Kembali ke atas

E-Value


4.4
(18 Ulasan)

5

Sangat Baik

11

4

Baik

5

3

Sedang

1

2

Buruk

0

1

Sangat Buruk

1

Ulasan Produk E-Value

The price was cheap and I was uneasy but it was able to be used without problems.
I am worried about durability, but now we can use it without problems.
High accuracy, ideal for rebuilding rusted Screw Mountain, hole.

【What made you decide the purchase?】 Cheap price. I have a lot of frequently used Size.
【How was it actually used?】 As for Screw mountain correction, it is necessary enough
【Was it difficult to install? (Hard parts case)】 Any
【Please tell me the point of installation and hang (in the case of Hard parts)】 Any
【Fit feeling and height when wearing - Please tell me the weight etc (Apparel case) 】Any
[Is there anything I was disappointed about?] In order to cut the thread newly, it seems that the hardness is insufficient. I tried to create a 7 mm Nut, but Screw Mountain is Small, so I'm concerned to tighten it strongly.
【Hope for Manufacturer - Please let me know if there are any improvement points】 I think it would be useful if you have a shorter Handlebar for Tap.
【Have you compared items?】 Cherry and 40PS of E Value
[Others] When installing Universal Front Fender, it entered diagonally from the position of Screw hole. We have recovered by Screw Mountain correction.

I used Nipper that is 100 yen uniform before but the quality is still better.
Easy to use, I thought that the weight feeling when I had it could not be done with 100 yen.
It is not so high and is generally good.

I think that it entered Pocket. Especially those who use Motorcycle are more convenient.
Especially when I go to a far place I think that it is extremely necessary.

I bought it to pack Handlebar.
I imagined it was sharpness or sharpness, but I could work more smoothly than I thought.
I think Cospa is nice..

As I wrote in the Title, I used threads or Grinder to cut off Pipe but it was not able to go around well and it was skewed, cut and not good. I used it for cutting Aluminum Pipe of 6 mm diameter and iron Handlebar this time. Aluminum Pipe was able to cut cleanly at ok..
Handlebar was turned back and turned back and it was possible to cut beautifully again in about 10 minutes. I planned to measure exactly with Vernier calipers but because the length was about 2 mm as a marking mistake, I usually say that this is fine with the usual case, but this time it was able to cut accurately 2 mm properly.
I think that it would have been better to purchase it earlier if this work could be done at this price.

The Frame of the ZOOMER was decomposed, and it rusted and purchased to drop. Although he thought that he would remove paint application of
origin by a Paint remover, it did not permeate, but a crack is attached to
point with this Wire, and it was made for a Paint remover to permeate.
This Size is a large object for area.

although I think that it can use enough now and that it is dissatisfaction with the part assigned to one for a while for newly turning off the Screw since it is used at least for cleaning of the Locke agent etc. -- correction of a screw thread -- if -- it is a product which can be used without a problem.