Kembali ke atas

RADICAL

RADICAL menyediakan berbagai produk sparepart sepeda motor mulai dari knalpot, as roda bahan chromoly, rearset, dan masih banyak lainnya. RADICAL juga memproduksi frame dan swingarm yang kualitasnya sudah tidak usah dipertanyakan lagi.

4.3
(100 Ulasan)

5

Sangat Baik

51

4

Baik

35

3

Sedang

8

2

Buruk

4

1

Sangat Buruk

2

Ulasan Produk RADICAL

After buying and installing in front and back, I realized the difference clearly just by pushing. It became very light. Since Cornering may cut too much until it gets used to it, only that attention.

【What made you decide the purchase?】
I have not changed only Front

【How was it actually used?】
The product of this hand feels an effect in plain

【Was it difficult to install? (Hard parts case)】
From the experience of changing another Motorcycle before installation
Maintenance Standetc. The person who does not have to purchase at the same time! Although exchange of things is not so difficult, it is safe if you asked Shop to those who do not have confidence about suspension relationship

【Please tell me the point of installation and hang (in the case of Hard parts)】
STANDetc. Same as the above answer

[Is there anything I was disappointed about?]
I wanted you to enter the product until Nut instead of using pure STD Nut

【Hope for Manufacturer ? Please let me know if there are any improvement points]
I would like to have genus with with Nut

【Have you compared items?】
I am using Vito at gs1000 I can not find it with Vito I purchased it here but I think it is the correct answer

[Others]
After all three points change is Recommendation In that case the price will be quite expensive! If the price is cheaper a little more!

This is used at the time of fine work.
uses, such as trimming and a port, -- it is various and finds it useful.

it uses for parts washing -- it is cheap and convenient.

Please never buy it.
Because something does not suit the air zipper 22.

I first installed it in the 2006 GSXR 1000 Front. I realized immediately that the handling became lighter and the rigidity increased.
For about a year I got on as it was and when I replaced Pivot, Rear axle shaft for Chromoly, I think I gained a sense of unity.
First of all, I think it would be good to exchange Rear after replacing Front.

It attached to GSX-R1100 of 87 year.
SpannerQuantity : Install with 2pc - I think that it is low in difficulty because it can be adjusted.
Working space is narrow because of carburetor, but it can be replaced without removing carburetor.
Instruction Manual was enclosed in it and it was OK as it was installed and adjusted accordingly.
Turn the adjustment Bolt and advance the Notifier of Tensioner in Manual.
In my Motorcycle, I advanced 1Notch and looked at the situation but the Engine sound changed quite a bit before and after the exchange.
If the tension is too tight, the rotation of the engine will become heavy, so be careful with too tight.

I bought it to remove Flywheel of HondaGL 700 Interstate.
As expected there were only OEM tools, Flywheel could easily be removed.
Easily, because the handlebar part of the CROSS CROSS is short, it is difficult for power to enter, and as I turn around slowly, Crankshaft also goes around, so I knocked out the Handlebar part with a Rubber hammer and it turned off.