It is so good that I want it to be attached as OEM!

I ride a PANIGARE V2 and had a problem with my hand going numb from the vibration of the handlebar when touring.
I had looked for bar ends and inner weights at mass retailers, but there were none that fit the structure of Japanese-made products, so I had given up! To be honest, it was so effective that I wish OEMs would adopt it.
It will of course look Race ish and is very Recommendation! View detail

Installed on a '23 monster 937.

[How is it used? Installed on delivery of a 23-year old monster 937

Was the one you received as per Image? As per Image since I had seen it beforehand.

Was the installation difficult? Installed by Dealer.

How was your experience with it? The look and feel is very good.

[Included Parts:were they on? Instruction manual and everything else.

[Was there anything that disappointed you? None

The price is higher than other manufacturers, but it is understandable when you see the actual product. It is made with attention to detail. View detail

Fender Eliminator Kit installed

Need 55mm Wrench and 600mm+ Spinner Handlebar to remove Tire.
All that remains is to follow the Instruction Manual. View detail

2cmDown

When I installed the racing seat on my DUCATI Panigale 1199 R, it was not easy for my 167cm height to get a good footing, so I bought the product that can lower the ride height the most (3cm down according to the manufacturer).

The Panigale has a Full Cowl and the Exhaust System is installed very tightly under the body, so I thought I would work on it while removing the Exhaust System, but I completely forgot and installed the Exhaust System first, so I asked a shop with a ceiling crane to assemble it. I asked a shop with a Crane to assemble the exhaust system.

The ECU is mounted on the Panigale's sub-frame, and the work was done after removing the rubber and shifting it backward (it is shifted forward in the photo), and suspending the body through a thin NylonSling through the hole in the frame. The instruction manual didn't mention anything about this, so I had it done at a shop that could do this work, because I found out through YouTube that it was necessary to keep the LINK unloaded.

I went to the shop with a NORMAL Seat, which had a good footing, when I installed the seat, and after the exchange I went home and replaced it with a Racing seat to check the footing.
When unloaded from the Crane at the Shop, it was already That's a pretty big drop." But when I came home and measured it over STAND, I could see that it was 2 cm lower at the Reflector under Number.
Before Lowdown, I could barely reach the toes of one foot, but after Lowdown, I can reach the toes of both feet and feel more secure.

I am a little worried about stopping at Side Stand because of the lower vehicle height, but the vehicle is properly tilted to the Left. Since I am a little anxious, I confirm that the vehicle is leaning to the Left after getting off the vehicle.
I am very happy with the installation. View detail

For Damage Reduction

[How is it used?
Mounted on Engine
Was the one you received as per Image?
It was just like the image.
Was the installation difficult?
The instruction manual with pictures was easy to understand.
How was your experience with it?
No discomfort
[Included Parts:were they on?
Well thought out with Included Parts
[Was there anything that disappointed you?
Nothing in particular
Other items that would be helpful
Installation points and hang/Availability and clarity of the Instruction Manual/Points to consider/Items to purchase/Opinions and requests to the Manufacturer
It would be helpful to have a 10mmAllen Wrench in Included Parts:.
Home center, $250 required to purchase. View detail