Extend Fender

I put it on and used it in the rain and there doesn't seem to be much difference between with and without it….

Installation is easy, as long as you follow the instruction manual.

The color of the Fender is matte black, so I was able to install it without much discomfort. I worked with the Fender installed on the side, but it is easier to work with the Fender removed. If you want to use the fixed pin, you need to drill a 4mm hole so that you don't accidentally stick the tire in. I haven't done any real wet weather driving, but the Fender is extended and seems to work well. It was installed on a 2017 RC90, although it is not correct in terms of fitment. I bought mine because this one had a faster delivery time, but only at my own risk. 4 Pins were included, but I'm using 2 for now and seeing how it goes.

The NC750X's Front Fender is short and often gets dirt up to the Radiator when driving over puddles.
To mitigate the damage as much as possible, we installed this product.
We did not use the supplied double-sided tape, but attached it with adhesive for plastic.
That would be a better way to fill in the gaps.

After installation, I drove over puddles, and I think the amount of dirt was reduced compared to before installation.

I think it is effective Large for those who ride to work etc..on rainy days like Title.
I never ran in the rain. (Impact of increased telecommuting) It will be a decision of about 5? on the way back.
I think the effect was to reduce the amount of dirt on the exhaust pipe and cylinder fins.
In my case, it may be a mistake when adjusting to Fender, but it is a little Quantity.:Pair (for Left and Right) Clearance of the "A" was different, but I think it is a resin molding product, so it is totally acceptable.
I used the supplied double-sided tape for 12 hours of crimping and 2 pieces of the supplied Nylon rivet just to be safe.
Double-sided tape is divided into parts, and the instruction manual makes it easy to understand.
I have a Nylon rivet, Φ4Drill to drill the hole, but I think you need to be careful about the position of the hole, the length of the neck and the push of the Rivet is the limit and it was hard to insert. It is recommended to find a good position as thin as possible. I was just eyeballing it, so it was at the limit. Also, Rivet is convenient because it can be inserted with bare hands.