HONDA CB-1 (CB400F)
This model was based on the CB-1. It had a semi-raised type handlebar and a newly designed seat. The tank capacity had been increased from 11L to 13L, and it had a high gearing ratio.
|Kapasitas Tangki||- Liter|
Mounting on NS-1.
The same thing as this was attached when purchasing Motorcycle, but since Cable was disconnected, it was replaced.
Anyway Cable is thin! This is the most dissatisfied point.
I want to pay attention to breaking and pulling.
Since it can not turn off the power, the battery will run out quickly with keeping on.
As a matter of fact, replacing the battery is somewhat troublesome.
As a water temperature gauge, it is a cheap class, so it is recommended for people who place importance on COSPA, those who hand out the water temperature gauge for the first time.
Let's buy a high-grade water temperature gauge a little if there is gold and knowledge.
Plus side : Price is cheap, around (grip) Soft, I think that it is good not to get stiff even in cold weather, individuals with many vibrations.
Minus surface : Grip becomes thick (About Grip heater included) So, for those who are Small in hands, depending on the angle of Handlebar, the thickness increases, Lever and Handlebar (Core of) There is a possibility that the thing may feel distant and it may be difficult to walk around so I think that the evaluation will break up.
Because my FUSION can not adjust the angle for Normal handle, I felt it slightly upward more than to Upright (Feeling holding down from above) became.
Because it is a Scooter which does not hold down even Positionally, the difference of several millimeters is sensuously pretty much Large.
Recommended for those who can adjust Handle position based on the thickness of Grip.
On the other hand, Direct feeling of Handlebar becomes thin, so I feel dull when I turn around.
This is terrible.
Because everyone bought the performance, it would be Large sturdy, but I never used it even when I replaced the battery.
Since the spare battery was attached, it was unpleasant to change the battery immediately on the way in the middle of using it, so when I first exchanged it, the lid was broken in a moment, and even though I was careful when inserting the battery, the terminal breakage Finished with.
If it is a prototype, I think that it is a bad Level if I sell this durability by mass production.
I got angry with industrial products after a long absence.