Kembali ke atas

Comfortable grips...simple and nice. Good

It chose by appearance.
A portion black when grasping is collapse.

Since oil change time came, it purchases in order to also exchange filters simultaneously.
I wanted red ....

It just said that it was reasonably priced.

It purchased to XJ6Diversion.

It will become Massey, if it does not fit into a filter easily firmly but uses for a while in the beginning.

Since it is the first exchange, a wrench is also simultaneous purchase.

Blue color of Anodized is gathered up as Accent in the whole of BlackBase.
I use it together with MASTERSinterCap of the same series

I made this Filter the same as last time in the third Oil exchange.
Filter wrench is not required, there is no new expense, even in terms of performance
Since I could use it without problems, I would like to repeat it in the future.

Order these grips for a Honda CBR1000f as per the listing but they are to short,I should have measured the old grips instead of trusting the listing so please check before you order.Nice grip otherwise.

It is used for Off-road motorcycle with Top case. There is another for Off, but because there is Screen at Touring SEROW, I made it for Large type Motorcycle here. This was the correct answer.

I purchased Green Light because the installed Motorcycle is Z1000, but the texture is much better than I expected.
Installation can only be done by removing the original Filler cap, so it can be done in 10 seconds. Rather it may take more time to get the item out of the box ... lol

Prodotto creato accuratamente oltre che piacevole alla vista ha una effettiva funzione di protezione dei para olii della forcella . Product created carefully as well as pleasing to the eye, it has an effective function of protecting the fork oils. (Translated by google translation)

In the case of the SR 400 OEM's Reserve tank integrated Master cylinder, Parts itself will inevitably become Large, so Handlebar replacement etc etc. , Custom around the Handlebar may interfere with fine adjustment of the positional relationship of each part. As this product is separate from the Reserve tank, compared with OEM, the degree of freedom of the installation position is high, it is a nice point for the Custom faction.

By the way, Brake's Fing Ring itself changes obviously compared to OEM.

OEM 's Master cylinder is early Touch, the rise of braking is relatively strong and it is clearly clear, there is no change in braking force which is too large even if gradually grasping from there, a certain pressure is applied Wherever, it was Fei Ring that seemed to work strongly, but I did not like it much.

On the other hand, this product often says "Linear" It is effective. The braking force rises to Smooth by the grasping amount. I think that the diameter of Master cylinder may be different from OEM, but obviously the controllability has improved.

Of course, I think that adjustment can be done by characteristics of Brake line and Pad, so it is only comparison with Master cylinder.

Also, the Lever position adjustment mechanism of the Dial formula, which is not found in the OEM, was delightful. It can be adjusted in a moment without tools.

Wiring processing of Brake switch is necessary, but it is not so difficult task, so if you are familiar with terminal processing work, Wiring processing will end within 5 minutes.

I have replace SKF fork seal for my CB400sf and it much better than the OEM. With it low friction design the fork move smoothly and even though it still remain good sealed from dust from outside and oil leak from inside. Highly recommended. Best

'