Kembali ke atas

Comfortable grips...simple and nice. Good

It chose by appearance.
A portion black when grasping is collapse.

It exchanged together at the time of brake lever exchange.
I was easy to grasp lever form and thought that texture was also good considering a price.
A point regrettable [ one ] has GATA in a pivot part compared with a pure lever.
Operation does not seem to be affected.

It is always putting in under the sheet for the emergencies at the time of touring.
Although he does not want to encounter the opportunity for this to play an active part ...

It attaches above all and safe.
This No. 1

I made this Filter the same as last time in the third Oil exchange.
Filter wrench is not required, there is no new expense, even in terms of performance
Since I could use it without problems, I would like to repeat it in the future.

Order these grips for a Honda CBR1000f as per the listing but they are to short,I should have measured the old grips instead of trusting the listing so please check before you order.Nice grip otherwise.

HELLO I'M SATISFIED OF THIS PRODUCT. SO I NOTICED AROUND 5000 RPM ,THE ENGINE SEEMS LIKE TO HAVE BLOWS. AS IS AN RACING PLUG YOU HAVE TO MAINTAIN A CERTAIN POWER FOR AVOIDING BLOWS.UP 5000 RPM YOU HAVE GOOD SENSATIONS.

We use it for Initial Model VTR. In the winter, I could not afford to catch Chalk, but I feel that the stability has been improved remarkably! Since only two months have passed since I exchanged it, I am not sure about Cospa and exhaustion However, I receive the impression that it is comparable to that just after I replaced it for the moment. I like the extent that it will probably be Windshield IRIDIUM for the next exchange as well

We are attached to VTR 250. I also added a hand guard at the same time, so I do not know yet, but the fastest speed fell a bit. I expect that it will become warmer, remove the hand guard and extend the maximum speed.

cbr1000 only because its conformity is different but it is nice because I bought it for almost half price!.NORMAL same etc. Because the coefficient of friction was good, we chose a paddle sweat exchange.The effect is the same, but the feel is harder than NORMAL, and when it is strongly applied, the sound is also "Snap" ...

I thought that it could be cheap at with Magnet, purchased, nothing was Paint on the exterior It was good at Simple
Since the tightening Torque is stated in the OEM, I watched it and installed it, but the next time I need to look it up
MT07 was 15 Nm

I used this for CB 750 RC 42, Lever liked Black. It used to be a Korea made BlackLever, but I like it because it is glossy here. It is Exactly to RC 42 and there is no astringentness The operation feeling is very good

1. It is very easy to set up, and fit for Honda CB400SF (NC42). 2. Nice colours with red and black. 3. The price is lower than other brands. 4. Quality is not bad.

I bought it with Mirror exchange of the 2017 year Grom, but ...
I installed Style fun and cool.
The installation of the car body was installed snugly.
It is only the ground that you can adjust the angle of Mirror.
The angular width is small to turn it upwards, and I do not add it at all.
For two days I worried about various good ideas but abandoned it.
It will not be a shame.

'