I made this Filter the same as last time in the third Oil exchange. Filter wrench is not required, there is no new expense, even in terms of performance Since I could use it without problems, I would like to repeat it in the future.
First of all, the Size of the Fork attachment site is thinner than Fork, even if it can not be fixed, I thought whether it could be used if it were to be scraped off, but since it interferes partially with Brake hose, processing is necessary also on the Brake hose side. As it is not a part that makes the effort to that extent, I gave up the installation, I can not trust Made in China again. If Bikers' Fork Stabilizer sees product images, I think that interference with Brake hose seems to be avoidable.
I thought that it could be cheap at with Magnet, purchased, nothing was Paint on the exterior It was good at Simple Since the tightening Torque is stated in the OEM, I watched it and installed it, but the next time I need to look it up MT07 was 15 Nm
Plus side : Price is cheap, around (grip) Soft, I think that it is good not to get stiff even in cold weather, individuals with many vibrations.
Minus surface : Grip becomes thick (About Grip heater included) So, for those who are Small in hands, depending on the angle of Handlebar, the thickness increases, Lever and Handlebar (Core of) There is a possibility that the thing may feel distant and it may be difficult to walk around so I think that the evaluation will break up.
Because my FUSION can not adjust the angle for Normal handle, I felt it slightly upward more than to Upright (Feeling holding down from above) became. Because it is a Scooter which does not hold down even Positionally, the difference of several millimeters is sensuously pretty much Large. Recommended for those who can adjust Handle position based on the thickness of Grip.
On the other hand, Direct feeling of Handlebar becomes thin, so I feel dull when I turn around.