Kembali ke atas

14 year type PCX 125 (JF56) We used it when exchanging outside the company. I compared it with an OEM and it matched without any difference. 500? After running I checked whether there was exhaust leakage, but exhaust was not exhausted at all. OEM Product is slightly higher, so there was nothing wrong with this product that is excellent in COSPA.

I am using it for Rear, but since I do not start working unless I stepped on stronger, I feel pretty hard to use if I am accustomed to NORMAL.
Even if you step on it without fail, it does not work more reliably than OEM.

If you are afraid of rock, I think something is right, but when you are wearing High grip tire it is hard to be effective when it's time to recommend it.

Very good quality product. Much better than original brake shoes. Brakes works now perfectly. Highly recommended product.

The product came in a sealed box and excellent quality! Packaging is not damaged and the product too! I took it in reserve, so I did not install it on a motorcycle! I recommend this product and store to everyone! Successful shopping!

I used ordinary Iridium plugs before, but when I exchanged for this product this time I think that the startability of the Engine has improved.
Because of that, it took less time to turn Cell and the burden on Battery seems to be diminishing.

The shape of the tip is slightly different from OEM. I feel a sense of incompatibility when I put on Rubber cap.

Seal tape winds in the reverse direction, not in the tightening direction.

Noticing that Brake fluid seeped out of Caliper's Air breeder
Rust was amazing as I removed it. Indeed when I thought this was dangerous, I found this product
Replaced. As I wrote that the installation was to tighten Seal tape one half turn and tighten
I rolled Emon's Seal tape. It looks more modest to the ground.
If you think that you could buy safety cheaply in the long run as it will not rust.

By the way, by wrapping a Seal tape, it seems that it is possible to prevent the Brake fluid from bleeding out of the thread during the air removal work.
I wrote it as a reference, since I did not write to absolutely roll it, I thought whether it is not necessary to wind Tape.

Noticing that Brake fluid seeped out of Caliper's Air breeder
Rust was amazing as I removed it. Indeed when I thought this was dangerous, I found this product
Replaced. As I wrote that the installation was to tighten Seal tape one half turn and tighten
I rolled Emon's Seal tape. It looks more modest to the ground.
If you think that you could buy safety cheaply in the long run as it will not rust.

Selection of Plug was also a difficult place as we are familiar with various things such as 65ccBore up, NRMagicExhaust Chamber, High Speed ??Pulley etc.. I ran the second fastest from the OEM, but I could not correct the soothed feeling even if I adjust the air / fuel ratio to any extent. When I replaced it with this plug this time, it burned my best by chance.

Haven't got a chance to use it yet, cuz I am still deciding on what exhaust to get for my Grom, but given the price point and reliability of the Kitaco brand, I'm Sure it will meet my needs

2016 year formula (LED Headlight) Purchased to replace Grom 's Exhaust System to YOSHIMURAR - 77 SCYCLONEFull exhaust. As you understood by removing it, you can not reuse Exhaust Gasket first. Exhaust System It is an indispensable item for exchange.

kitaco brake shoes are the greatest choice for my honda c50!!Springs included in the kit..Low cost!High quality!Great braking!

I purchased it for exchange with Exhaust System and Set.
KITACO products are fairly comprehensive of the LineUP of fractional Parts.
Gold It is also cheap so I was glad I bought it.

We exchanged from OEM Parts Number during Maintenance of Commuter Scooter.

I checked the number of Air breeder, OEM Parts Number for Nisshin caliper and purchased it.

As described in the manual, I rolled around the Seal tape for about a half turn and installed it.

Combined with Stainless Steel Pad Pin, it is quite nice condition.

This time, I bought it around the exchange of Exhaust System.
Outside diameter was smaller than OEM Gasket, but it can be used without problems.

Quantity : 1 Set of 2pcs. It is saved because it can be used for damage, loss, and returning to OEMExhaust System.

I have Honda Dio ZX AF36 and had a problem with starting. Replacing spark plug solved the problem. Daytona products are high quality. I had to take out the seat box first in order to get to the carburetor and replace the spark plug. Delivery was fast.

'