|Kapasitas Tangki||- Liter|
First of all, the Size of the Fork attachment site is thinner than Fork, even if it can not be fixed, I thought whether it could be used if it were to be scraped off, but since it interferes partially with Brake hose, processing is necessary also on the Brake hose side.
As it is not a part that makes the effort to that extent, I gave up the installation, I can not trust Made in China again.
If Bikers' Fork Stabilizer sees product images, I think that interference with Brake hose seems to be avoidable.
When we arrived, it was already floating from release paper.
It seemed that the adhesive strength was not 0 and the season was still hot, so I tried adhering to Tank in the meantime and then it will float after a while.
As another means, by holding down from above for a long time, I hope that the shape of Pad itself will become familiar with Tank, I will keep curing Tape from above and keep it familiar 2 months.
I thought that it would have become familiar with it and seemed to be sticking somewhat when removing the curing tape.
But. It floated on the next day.
If you leave it like this, you will scratch the painting of Tank if you get in dust, so you only have to peel off.
It is mere Large loss.
Neck is expensive.
Wiring does not know Plus, Minus LED does not flow if connected reverse. Do not light. Blinker relay is OK for normal LED
Since connection terminals are small, confirmation is necessary when connecting
With installation Screw 8 mm, it can be installed anything, it seems that it is made by EC standard and it enters EMark. With mark
Connection CouplerWire Set (Other Company Product) Can be populated with, or disconnected from the Line. (MT−09) in the case of
I installed it in the new CBR 250 RR. There is no problem with Length and Pitch, but the root of Drain bolt (Washer contact surface) Is thinner than the inner diameter of Washer, so attention is required for installation. It is a product that leaks Oil if you do not loosen the Drain bolt while holding down the Washer and doing the center picking out. There is no problem if you observe the shape before mounting and understand the shape.