I made this Filter the same as last time in the third Oil exchange. Filter wrench is not required, there is no new expense, even in terms of performance Since I could use it without problems, I would like to repeat it in the future.
I thought that it could be cheap at with Magnet, purchased, nothing was Paint on the exterior It was good at Simple Since the tightening Torque is stated in the OEM, I watched it and installed it, but the next time I need to look it up MT07 was 15 Nm
She said that she was already floating from release paper at the time it reached home. - - - -
When we arrived, it was already floating from release paper. It seemed that the adhesive strength was not 0 and the season was still hot, so I tried adhering to Tank in the meantime and then it will float after a while. As another means, by holding down from above for a long time, I hope that the shape of Pad itself will become familiar with Tank, I will keep curing Tape from above and keep it familiar 2 months. I thought that it would have become familiar with it and seemed to be sticking somewhat when removing the curing tape. But. It floated on the next day. If you leave it like this, you will scratch the painting of Tank if you get in dust, so you only have to peel off. It is mere Large loss.
Installed in zx-6 r in 16 years. I thought that Heat sink of heat dissipation will interfere, but since it did not hit Limit it was attached with no processing. It is bright, it looks pure white with a white color too!
I bought it because the replacement of the Oil filter is approaching. Since I bought it at Sale time, I am superior in Cost performance. Recently I have been using this product all the time, especially the bad place There is none. I will use it next time as well.