Can be installed and used without problems.
Effect,? Emblem is weakened. ? Beat of the Engine - Vibration lowers. ? There is little power of low rotation.
Afterwards installed RapidMotorcycleEasy also has the same effect (?except for) , But the change is dramatic in RapidMotorcycleEasy. (Because the price is high)
The installation was no problem at all.
When I turned the cell with expectation "Gakki" The sound...
It broke with a single shot.
Moreover, it seems that the debris fell into the Cylinder, turning the Plug back and turning the cell produces an abnormal sound.
I just went for repair as it was.
KawasakiOEMBore Up Kit + Since the port has been modified, it may have been a problem if it was a real OEM.
Because this Brake Pads is made of a hard material, its characteristics will be exactly as it is.
- The life of Pad is long (Hard to reduce) Instead, discs are reduced.
- Almost no Brake dust. (Wheel is not soiled)
- BrakeTouch becomes stiff. (Feeling like when changing to Mesh hose)
- Brake Squeak easily.
- Brake The effectiveness of the beginning of the hand grip is weak, but if it grips strongly it works strongly.
It is ineffective when it is cold again. Especially the start of running in winter
On the other hand, it seems to be strong against heat, and if Brake warms up to some extent it will improve its effectiveness.
I think this Brake characteristic is suitable for Circuit driving and Long touring
, Usual city riding, shopping etc.. It is a bit hard to handle when riding in.
Package says "Aggressiveness to Rotor Small Small", but that is an honest question.
I ran about 10,000 kilometers, but the disc was wearing as it was.
Instead, Pad is less likely to reduce, and the remaining amount of Pad is still there.
Indeed, Pad is superior to COSPA because it is hard to reduce, but if discs are reduced
I think how it is after all.
When I bought this Pad, it was relatively cheap Manufacturer,
Currently there are overseas cheap Pads, so I'm loving that now.
CloseType 's Hand guard is around, we used the OEMThrottle tube' s end at first and used it.
However, when Bar End of Guard fixing Bolt of Bar End is tightened to the limit, it seems to slightly interfere and it is caught when Axel is fully opened and does not return. I was forced to use it for a while without tightening, but with this, the Guard can not be fixed properly, and the position will be displaced each time it falls. Therefore, it will take time to restart again because you have to return every time. In addition to being solicitous irritated, in addition, the soil gradually entered between Throttle tube and Handlebar, Axel's movement gradually became awkward, Introducing this Parts that I had been concerned for a while Saw.
Result, all resolved.
The Guard can be fixed as Firmly, even in that state, no friction is felt, you can operate Axel grin and grillfully. Unnecessary Stress has decreased. I wish I had changed it as soon as possible.
In addition, of course, it is completely self-satisfactory Parts because it can not be seen from the outside at all.
I exchanged Plug because it exceeded 11000 km. Although it is an impression of about 500 km,
The attachment of Axel at 1500-3000 rpm improved, and the high rotation also turned well
I think. 5 speed 40 km is easier to run. Just 2000-3000 Partial
I feel that the area became irritable, and it became difficult to maintain a little with. I want to increase the vibration...
Because the heat value is not matched, the original Plug may be more comfortable for regular rotation. I am worrying about returning..
Looking at you..