Kembali ke atas

【KITACO】Repair Parts for PWK28/M Carburetor

    • Penilaian:

Since the grand axis was equipped with PWK28, it purchased for jetting.
In order to compensate an intermediate speed omissio...

  • Pengulas: Japan User(translated)
  • Ditulis pada: 2007-04-13 18:31:19
Since the grand axis was equipped with PWK28, it purchased for jetting.
In order to compensate an intermediate speed omission peculiar to a yamaha vehicle, I consider that it is better to arrange a needle in B to G.

Tanggapan

Jika ingin menanggapi komentar silakan "Masuk" dan menyelesaikan "Pendaftaran".

Ulasan lainnya

【What made you decide the purchase?】 Carburetor setting for escape from the mire
【How was it actually used?】 Modified E / Was it still thin for G?
【Was it difficult to install? (Hard parts case)】 Be careful not to lose E Ring
【Please tell me the point of installation and hang (in the case of Hard parts)】 I am trying to remove it while holding E Ring.
[Is there anything I was disappointed about?] Where there was no storage case
【Hope for Manufacturer - Please tell me if there are any improvement points】 No particular
【Have you compared items?】 KN Planning No. quotient ProductNo : KS-NJ-SET

【What made you decide the purchase?】 Carburetor setting for escape from the mire
【How was it actually used?】 Modified E / Was it still thin for G?
【Was it difficult to install? (Hard parts case)】 Be careful not to lose E Ring
【Please tell me the point of installation and hang (in the case of Hard parts)】 I am trying to remove it while holding E Ring.
[Is there anything I was disappointed about?] Where there was no storage case
【Hope for Manufacturer - Please tell me if there are any improvement points】 No particular
【Have you compared items?】 KN Planning No. quotient ProductNo : KS-NJ-SET

Since the grand axis was equipped with PWK28, it purchased for jetting.
In order to compensate an intermediate speed omission peculiar to a yamaha vehicle, I consider that it is better to arrange a needle in B to G.