- Beranda
- Ulasan Produk
- Sparepart Motor
- Sparepart Mesin
- Mesin
- Transmisi
- Tenaga kerja khusus diperlukan untuk penggantian... (DMR-JAPAN: Shift Spindle Metal Bearing Kit)
【DMR-JAPAN】Shift Spindle Metal Bearing Kit Review
Special labor is required for replacement
In order to pull out the Needle bearing assembled in the Case by the OEM, the
A Bearing Puller is required.
The compatible shaft diameter is 14mm.
InnerPuller for ball bearing may not work.
We forced it out with a 15mm puller for ball bearings.
If you can afford it, Puller should be prepared.
On the other hand, the assembly of Tougashi-kun itself does not require a special tool.
Socket and Hammer are sufficient.
The product itself is very solid, so
After assembly, you will be thrilled by the lack of rattling.
It is a good product, although it is difficult to replace.
Tenaga kerja khusus diperlukan untuk penggantian
Untuk mengeluarkan bantalan Jarum yang dipasang di Case oleh OEM, the
Diperlukan Penarik Bantalan.
Diameter poros yang kompatibel adalah 14mm.
InnerPuller untuk bantalan bola mungkin tidak berfungsi.
Kami memaksanya keluar dengan penarik 15mm untuk bantalan bola.
Jika Anda mampu membelinya, Penarik harus siap.
Di sisi lain, perakitan Tougashi-kun sendiri tidak memerlukan alat khusus.
Socket dan Hammer sudah cukup.
Produknya sendiri sangat solid, jadi
Setelah perakitan, Anda akan senang dengan tidak adanya gemerincing.
Ini adalah produk yang bagus, meskipun sulit untuk diganti.