- Beranda
- Motor
- HONDA 0 - 50cc
- GYRO CANOPY
- Sparepart Motor
- Rantai / Gear
- Sparepart Skutik
- Sparepart Skutik Lainnya
- Hunter
- Hunter: Spacer untuk Resistor Motor Mini
Cek kupon saya
Jumlah
100% Ori
Garansi 7 hr
Gratis Cashback
Nett Tanpa Biaya Tambahan
Model yang Sesuai
Lihat SemuaRincian Produk
Konten ini diterjemahkan oleh Google, jika Anda ingin melihat aslinya, silakan klik
Lihat versi asli
Spesifikasi:
Components
・Two 3mm thick spacers
・2 cotter pins
・Minicar Conversion Application Form
Components
・Two 3mm thick spacers
・2 cotter pins
・Minicar Conversion Application Form
・Two 3mm thick spacers
・2 cotter pins
・Minicar Conversion Application Form
Components
・Two 3mm thick spacers
・2 cotter pins
・Minicar Conversion Application Form
[Deskripsi]
Ini adalah spacer yang disisipkan di antara roda dan poros OEM untuk memberikan tapak baru 4-tak Gyro X dan Gyro Canopy 500mm + yang diperlukan untuk registrasi mobil mini.
This spacer is inserted between the stock wheel and shaft to give the new 4-stroke engine GYRO CANOPY the 500mm or more tread.
The thickness of this product is 3mm per piece, so by inserting it between the left and right side of the set, the stock tread of 496mm will become 502mm.
The products are processed at ALFA AUTO's contracted Japanese factory, so there are no distortions in thickness and highly precise and hard.
Since the stock wheel of a 4-cycle canopy has a very small contact area with the shaft, using a simple circular washer with low hardness would crush the wheel nut and cause it to loosen. This product was manufactured at Japanese factory in considering the accuracy of the shaft and the spline (zig zag part) and the accuracy of the surface where the wheel and the shaft contact.
Since the stock cotter pins cannot be used when inserting the spacers, two split pins of the appropriate size are also included.
The thickness of this product is 3mm per piece, so by inserting it between the left and right side of the set, the stock tread of 496mm will become 502mm.
The products are processed at ALFA AUTO's contracted Japanese factory, so there are no distortions in thickness and highly precise and hard.
Since the stock wheel of a 4-cycle canopy has a very small contact area with the shaft, using a simple circular washer with low hardness would crush the wheel nut and cause it to loosen. This product was manufactured at Japanese factory in considering the accuracy of the shaft and the spline (zig zag part) and the accuracy of the surface where the wheel and the shaft contact.
Since the stock cotter pins cannot be used when inserting the spacers, two split pins of the appropriate size are also included.
Peringatan
*There may be changes in product specifications due to the manufacturer's reasons.
*There may be changes in product specifications due to the manufacturer's reasons.
*There may be changes in product specifications due to the manufacturer's reasons.
Model yang Sesuai
PRODUK YANG JUGA DILIHAT
Produk Siap Dikirim dari Gudang Jepang
Rekomendasi buat Kamu
Best Seller
New Custom Article
Gunakan kupon
Review Gambar
Review detail
/