Kembali ke atas

【KITACO】Kabel Power Supply

Harga: Rp157,000

*Termasuk PPN 10%
Webike Points: 1,570 pts

Shipping point: 3 pts ( 3 pts x 1qty)
Ubah
DKI Jakarta, Jakarta Selatan, Cilandak
Biaya pengiriman
Rp9,000

    • Nomor Produk:
    • 756-9000400

Mohon tunggu...


Model yang Sesuai:

NINJA2 Helmet50RSL BR250A/B

NINJA400 14- EX400G

ESTRELLA (FNO:BJ250A-099001-)

Lihat lebih lanjut

Rincian Produk

Konten ini diterjemahkan oleh Google, jika Anda ingin melihat aslinya, silakan klik Lihat versi asli

[Spesifikasi]

Kabel untuk power supply 12V
Lokasi output: Konektor sistem diagnosis malfungsi
dengan tube logo original KITACO

[Peringatan]

*Jangan gunakan untuk menghubungkan produk dengan konsumsi tenaga dan arus tinggi (amplifier, kompresor, dan lain-lain).
*Menggunakan skun bullet tipe female CA/CB 103 (HONDA) sebagai skun bullet kabelnya.
*Produk di foto adalah untuk model: Z125 PRO.
*Foto memuat tipe lainnya.

[Deskripsi]

ACC (+) dan ground (-) dapat diambil dengan hanya menginterupsi coupler spesifik untuk tiap model motor dengan mengamankan power supply yang diperlukan untuk charging, seperti charging smartphone, yang merupakan perangkat penting sehari-hari.
Ini adalah kabel yang dapat mengambil power supply untuk aksesoris dengan hanya mentransmisikannya ke coupler body motor.
Dapat mengambil power supply seperti power supply USB dan ETC dengan cermat.
Pengkabelan dapat dilakukan dengan mudah karena kabel dari semua kabel supply memiliki tube tanda original.

[Cara memasang (untuk Z125 Pro)]
Lepas tutup coupler tahan air 4P di bawah jok.
Hubungkan kabel power supply ke coupler yang telah dilepas. Hubungkan power supply USB untuk dipakai ke ACC (+) GND (-) dan selesai.

Model yang Sesuai

  • 3.9

    8 Ulasan

  • 5

    Memuaskan

    5

    4

    Bagus

    1

    3

    Lumayan

    0

    2

    Kurang

    0

    1

    Mengecewakan

    2
  • Tulis Ulasan

    Buy with YZF-R25 to power the Doreco.
    It's easy to connect to the Coupler, so where you can not hurt Wiring
    Was it good, but the installed plug receptacle is Small?
    The plug does not easily get in and it spreads out with Driver and managed somehow.
    Well it's just a matter of replacing the Bullet Terminal.
    The essential dorareko is working normally.

    When it interrupted the Harness of Rear brake, the indication of Plus and Minus is opposite, and there is no need for Meter to give an error indication.
    I can not believe it.

    I bought it to install USB power supply to NINJA 2 Helmet 50R.
    Installation was easy and could be installed easily.
    However, if it can take as long as it takes time to find a terminal to be interrupted, if you can specify the position of the terminal on the Manufacturer's Site and check the length of Cable,

    The Kitaco Power Output Harness DOSE NOT FIT HONDA MSX125G 2016. This is the seccond Kitaco part BROUGHT for my GROM and the plugs on the Kitaco Power Output Harness are completely different from any electrical plugs on my 2016 GROM. The instructions even show a piture of 2016 GROM and were to fit the Harness. Complete waste of money. I have brought 3 Kitaco parts to fit my GROM and NONE of them have fitted my 2016 GROM. Shame Kitaco shame.

    When attaching to z125, I had difficulty in removing Harness cover on Body side. It is very convenient to easily take out the ACC power supply with just the Coupler connection. I use the Grip heater connected to the power taken out from here, but it is used without particular problems.

    Until now USB etc. Although it had taken out from Fuse to secure the power supply of Fuse, it did not close the lid of the Fuse box and closed the lid casually so as not to cut or cut the lid a little, but there is a possibility of Short, This product is simply easy to plug into the Coupler of NORMALWiring It is saved by Large that you can secure power with easy operation!
    Cospa is also friendly to Large innocence!

8 Ulasan Lihat semua