[Components] ・Assembly part ・Tail pipe ・8 springs ・Silencer ・End baffle ・Silencer band ・Silencer Bracket ・Exhaust pipe per vehicle
[Maintenance Data] ・Drain bolt: Manifold section needs to be detached ・Change oil filter: Manifold section needs to be detached ・Center stand: Not available
[Description]
Weld EX series designed exclusively for R.C.M The NITRO RACING Weldcraft 3D Titanium EX Series is made by painstakingly joining over 100 pieces of pipe to minimize the slightest distortion in the bending process. It is a commitment to roundness that prioritizes exhaust efficiency without regard to cost. The road clearance and bank angle are proof of the pursuit of the elements required for a exhaust. Specially machined spring locking flange. All for the best machine.
Note
* This item can not be cancelled, returned nor exchange after placing an order.
* The image is only for reference. The image shown may differ from the actual product.
Caution
*The end baffle is pre-installed on the silencer at the time of shipment. *Conical titanium silencers V-1 / V-2 / V-3 do not come with a silencer band as a bracket is pre-installed. *NEVER remove the silencing baffle from the NITRO RACING silencer.It is also recommended to check and overhaul the silencer's internal sound deadening wool on a regular basis. *You need to change to single type rearset.In this case, it is necessary to cut off the frame of the pillion step when you replace the stock one with this product. *You may need to replace the blinkers depending on the type of blinker. *The filter cover and drain bolt must be changed to a flat type.The Flat Cover & Drain KIT is included in the Exhaust Kit and should be replaced when the exhaust is installed. *NITRO RACING Pillion Step KIT Type2 can be used.(As to the vehicles already equipped with NITRO RACING Pillion Step KIT Type 1, there is a rare case of interference between the upper part of the silencer and the Pillion Step KIT due to the welding position of the mounting plate.) *The exhaust bracket is not compatible with the stock rear suspension mount.Compatible with laydown mount adaptation with M6 screw hole construction. It is forbidden to drive on public roads with the end baffles removed. *Installation image and product configuration are for reference only.
* Please note in advance that cancellation and/or return of this product cannot be accepted once the order has been placed.
