The "DYNA model" is hidden behind the primary case and is difficult to take out, and many people look for a stand. With the extension, you can hang your feet naturally.Combination of hand-bent machined aluminum bars and laser-cut plates. It is a bolt-on design with two points, so there is no "looseness" when the stand is put in and out, and it is fixed firmly.The simple design pursues the functional beauty and matches with the custom vehicle.
The Dyna stand is hidden behind the primary case, making it difficult to get out. The extensions make it easy to visually display. Aluminum parts are buffed and polished, then anodized. The smooth, glossy black finish is perfect for painting the side stand black.
■Compatible models and years All models from 2007 onwards have the same side stand, so it is usually compatible.
A=Approximately 19mm B=Approximately 75mm → It is a wide type (usually bolt-on) A=Approximately 19mm B=Approximately 58mm → Only B is a narrow type (usually bolt-on) A=approx. 12mm B=approx. 58mm → Both A and B are narrow type (separate parts are required) *Cannot be mounted on stands with A=12mm or less B=56mm or less
■Mounting and processing method 1. Install the O-ring on the aluminum collar. *Dimensions of the stand tabs may vary depending on individual differences in the vehicle, and the O-ring may not be used. 2. Set the mounting bracket. 3. Tighten the bolts and nuts using a hexagonal wrench and a spectacle wrench. 4. Fix the mounting bracket at the end of the stand. 5. Adjust the direction of the extension bar and the primary case so that they do not interfere with each other, and fix them temporarily. 6. Be sure to use thread locker on the mounting bolts to prevent loosening.
Caution
*For older bikes, there is almost no problem, but for some models and years, the dimensions of A and B may be different due to minor changes in the stand. *Please make sure to confirm dimensions A and B before ordering. *When ordering, please be sure to check the dimensions of the stand tabs. *The vehicle may fall over during operation, resulting in damage to the vehicle or injury to the operator. *Work should be done by two persons or with the bike in an upright and stable position using a racing stand or jack.
