- Home
- Model
- HONDA 0 - 50cc
- MONKEY
- Motorcycle Parts
- Suspensions / Rearsets / Wheels / Swingarms
- Suspensions
- Rear Suspensions
- U-CP
- U-CP: Rear Suspension for Long Swingarm
Rear Suspension for Long Swingarm
- Product number: UCSUT32RDBKHO78
-
- IN STOCK
- Out Stock
- U-CP
- |
- 0.0
- (0 review)
Check my coupons
Product Detail
Specification:
Color: Red/Black
[Size]
Mounting Hole Center-Center Length: Approximately 325mm
Spring Outer Diameter: 65mm
Spring Wire Diameter: 8.1mm
Rod Diameter: 12.3mm
Upper Side Mounting Hole Inner Diameter: 10mm
Lower Side Mounting Hole Inner Diameter: 10mm
Upper Side Mounting Part Thickness: 18.3mm
Lower Side Mounting Part Thickness: 20.0mm
Tank Diameter: 49mm
[Size]
Mounting Hole Center-Center Length: Approximately 325mm
Spring Outer Diameter: 65mm
Spring Wire Diameter: 8.1mm
Rod Diameter: 12.3mm
Upper Side Mounting Hole Inner Diameter: 10mm
Lower Side Mounting Hole Inner Diameter: 10mm
Upper Side Mounting Part Thickness: 18.3mm
Lower Side Mounting Part Thickness: 20.0mm
Tank Diameter: 49mm
[Description]
●Based on the concept of providing a suspension that can be used with assurance, this is an original suspension that has been completed through many trials and errors from planning and development to commercialization.
●In order to achieve low cost, the parts that make up the suspension are manufactured at partner factories overseas, while the final assembly, nitrogen gas injection, product inspection before shipment, and other important tasks are handled by specialized staff at U-CP's factories in Japan.
●U-CP has increased the tank capacity, increased the spring wire diameter by 1mm, and increased the spring outer diameter by 5mm, so the ride will not be too soft and fluffy.
●The upper and lower rubber bushings are manufactured in Japan, so they are resistant to deterioration and can be used just like the stock.
●The length of the suspension can be set to almost the same as the stock suspension.
●The length from the center of the mounting hole to the center is about 325mm, which can be extended by 10mm by extending the end eye.
●The spring preload can be full adjustable.
●Damping pressure cannot be adjusted.
●The preload adjustment wrench and hex wrench are included.
●In order to achieve low cost, the parts that make up the suspension are manufactured at partner factories overseas, while the final assembly, nitrogen gas injection, product inspection before shipment, and other important tasks are handled by specialized staff at U-CP's factories in Japan.
●U-CP has increased the tank capacity, increased the spring wire diameter by 1mm, and increased the spring outer diameter by 5mm, so the ride will not be too soft and fluffy.
●The upper and lower rubber bushings are manufactured in Japan, so they are resistant to deterioration and can be used just like the stock.
●The length of the suspension can be set to almost the same as the stock suspension.
●The length from the center of the mounting hole to the center is about 325mm, which can be extended by 10mm by extending the end eye.
●The spring preload can be full adjustable.
●Damping pressure cannot be adjusted.
●The preload adjustment wrench and hex wrench are included.
Note
Click here for Other Color
Caution
*The image is for reference only.The size of the collar may vary depending on the model.
*There may be some small scratches on the product during production or transportation.
*There may be some small scratches on the product during production or transportation.
Applicable Models
ALSO VIEWED PRODUCTS
Apply Coupon
Image Review
Review detail
/