Check my coupons
Quantity
100% Original
7 Days Warranty
Free Cashback
Net Price
Applicable Models
See All
gsx1100s katana (sword)
gsx1100s katana (sword)
Product Detail
Specification:
[Size]
Center of mounting hole - length of center: Approx. 355mm
Spring length: 205mm
Spring Outer Diameter: 65mm
Spring wire diameter: 8.1mm
Rod diameter: 12.3mm
Inner diameter of Upper Mounting Hole: 12mm
Inner diameter of lower mounting hole: 10mm
Thickness of the upper mounting: 18.3mm
Inner width of the lower U-shaped part: 22.2mm
Outer width of the lower U-shaped part: 29.8mm
Tank Diameter: 49mm
Center of mounting hole - length of center: Approx. 355mm
Spring length: 205mm
Spring Outer Diameter: 65mm
Spring wire diameter: 8.1mm
Rod diameter: 12.3mm
Inner diameter of Upper Mounting Hole: 12mm
Inner diameter of lower mounting hole: 10mm
Thickness of the upper mounting: 18.3mm
Inner width of the lower U-shaped part: 22.2mm
Outer width of the lower U-shaped part: 29.8mm
Tank Diameter: 49mm
[Description]
●Based on the concept of providing a suspension that can be used with assurance, this is an original suspension that has been completed through many trials and errors from planning and development to commercialization.
●In order to achieve low cost, the parts that make up the suspension are manufactured at partner factories overseas, while the final assembly, nitrogen gas injection, product inspection before shipment, and other important tasks are handled by specialized staff at U-CP's factories in Japan.
●U-CP has increased the tank capacity, increased the spring wire diameter by 1mm, and increased the spring outer diameter by 5mm, so the ride will not be too soft and fluffy.
●The upper and lower rubber bushings are manufactured in Japan, so they are resistant to deterioration and can be used just like the stock.
●The original "U-shaped" end eye is specially designed for GSX1100S KATANA, so it can be installed by bolt-on.
●The length of the mounting hole is about 355mm from the center to the center, which is about 2.5cm longer than the stock suspension.The end eye can be extended by 10mm.
●The spring preload can be full adjustable.
●Damping pressure cannot be adjusted.
●The preload adjustment wrench and hex wrench are included.
●In order to achieve low cost, the parts that make up the suspension are manufactured at partner factories overseas, while the final assembly, nitrogen gas injection, product inspection before shipment, and other important tasks are handled by specialized staff at U-CP's factories in Japan.
●U-CP has increased the tank capacity, increased the spring wire diameter by 1mm, and increased the spring outer diameter by 5mm, so the ride will not be too soft and fluffy.
●The upper and lower rubber bushings are manufactured in Japan, so they are resistant to deterioration and can be used just like the stock.
●The original "U-shaped" end eye is specially designed for GSX1100S KATANA, so it can be installed by bolt-on.
●The length of the mounting hole is about 355mm from the center to the center, which is about 2.5cm longer than the stock suspension.The end eye can be extended by 10mm.
●The spring preload can be full adjustable.
●Damping pressure cannot be adjusted.
●The preload adjustment wrench and hex wrench are included.
Caution
*The image is for reference only.The size of the collar may vary depending on the model.
*There may be some small scratches on the product during production or transportation.
*There may be some small scratches on the product during production or transportation.
Applicable Models
gsx1100s katana (sword)
gsx1100s katana (sword)
