- Home
- Accessories
- Trailer / Towing / Winches
- Genb
- Genb: [GENB] NV350 Caravan Rear Bump Stopper Adjust Plate
[GENB] NV350 Caravan Rear Bump Stopper Adjust Plate
- Product number: OSE-MF-SAP04C
-
- IN STOCK
- Out Stock
- Genb
- |
- 0.0
- (0 review)
Check my coupons
Product Detail
Specification:
[Description]
Must see for light down users! Rear Bump Adjusting Plate
The "Bump Stopper" is a common practice in lowering customization to improve the ride quality.
However, when installed on a vehicle with less than 2.0 inches of light down, the stopper does not activate until the vehicle reaches the default height setting, which tends to cause the rear to sink more than the front.
Therefore, OGUshow set up the "Adjust Plate" for rear bump only for 1.0-2.0 inch light down users.
By increasing the initial height of the rear bump, excessive sinkage is suppressed.
This is an item that was born from a change in thinking, allowing you to freely control the attitude change of the vehicle depending on the combination of plates.
By replacing the bump stopper with a thinner one, the amount of stroke was increased, but with the stopper size corresponding to 4.0 inches down, the rear of the vehicle sank excessively, resulting in a loss of front / rear balance.
By inserting a plate according to the amount of downward movement, it is effective to improve the stability of the vehicle body by maintaining the proper amount of stroke.
If the vehicle is lowered with the stock bump stopper, the stroke will be insufficient even if it was correct with the standard height.
If you drive in this condition, you will feel an unpleasant thrust when you bump.
The "Bump Stopper" is a common practice in lowering customization to improve the ride quality.
However, when installed on a vehicle with less than 2.0 inches of light down, the stopper does not activate until the vehicle reaches the default height setting, which tends to cause the rear to sink more than the front.
Therefore, OGUshow set up the "Adjust Plate" for rear bump only for 1.0-2.0 inch light down users.
By increasing the initial height of the rear bump, excessive sinkage is suppressed.
This is an item that was born from a change in thinking, allowing you to freely control the attitude change of the vehicle depending on the combination of plates.
By replacing the bump stopper with a thinner one, the amount of stroke was increased, but with the stopper size corresponding to 4.0 inches down, the rear of the vehicle sank excessively, resulting in a loss of front / rear balance.
By inserting a plate according to the amount of downward movement, it is effective to improve the stability of the vehicle body by maintaining the proper amount of stroke.
If the vehicle is lowered with the stock bump stopper, the stroke will be insufficient even if it was correct with the standard height.
If you drive in this condition, you will feel an unpleasant thrust when you bump.
Note
NV350 Caravan Genb Rear Bump Stopper is here.
Caution
*NV350 CARAVAN Genb Rear Bump Stopper is sold separately.
*This product is an exclusive part for light-down specification vehicles.It is designed to lower the vehicle by less than 2.0 inches (-50.0mm) based on the standard vehicle height.
*This product is an exclusive part for light-down specification vehicles.It is designed to lower the vehicle by less than 2.0 inches (-50.0mm) based on the standard vehicle height.
ALSO VIEWED PRODUCTS
Apply Coupon
Image Review
Review detail
/