This is a compact, yet very strong disc lock with a strong stainless steel body and a strong key barrel that is directly attached to the brake disc rotor. When it detects the vibration such as moving the vehicle body, it sounds the piercing alarm sound of 120dB, and it is the product which shows the power to prevent the theft of your vehicle. In addition to waterproof specifications, the body of the disc lock is finished with a special surface treatment to give it a high-class look. The built-in lithium rechargeable battery system can be used approximately 500 times. The battery can be recharged by USB, so it is very economical. It will run for about 4 to 5 months on a single charge.(*Varies depending on the number of times the alarm is activated) In addition, the alarm has an [ON / OFF] function.
--- Operation --- [How to switch ON / OFF] *The alarm is equipped with a sensor that detects the brake disc. ●When the main unit of the disc lock is inserted into the brake disc, a short "beep" will sound once, followed a few seconds later by a notification sound indicating that the security alarm is in the ON mode. Note: The security alarm will not be switched on if it is removed from the brake disc before the audible notification that the security alarm is in the ON mode.When locking, always check the operation. ●When the disc lock unit is inserted into the brake disc, the security alarm will be turned off if there are two short "beep" sounds.(There will be no notification sound to indicate that the device is off.) *To release the security system after it has been activated, release the lock and remove the disc lock from the brake disc.The alarm stops when the alarm body no longer detects the brake disc.
[charging method] 1. Remove the disc lock unit and disc insert bolt with the attached hexagonal wrench. *If you use a hexagonal wrench, the sensor that detects the brake disc may react and make a sound. 2. Remove the bolt and the cover will come off. 3. Remove the alarm unit, remove the waterproof cover and attach the cable to the USB connector to charge the battery. *Please do not lose the waterproof cover. *If a short "beep" sound is heard once when the alarm unit is removed, push the alarm unit in again and remove it.If you hear a short "beep" sound twice when you remove the device, the security system will not be activated. 4. When you start charging with USB cable, blue LED lamp will light up. 5. Charging is complete when LED turns off.Install the alarm unit. *When installing the alarm unit, be careful not to forget to attach the waterproof cover.
Caution
*Please check the size of the brake disc on your motorcycle. *There is a slight dimensional error in the size description.
