- Home
- Motorcycle Parts
- Bodyworks
- Fenders
- Rear Fenders
- CHIC DESIGN
- CHIC DESIGN: Estrella Vintage Fender
Check my coupons
Product Detail
Specification:
Fender Body: Made of FRP
Black gel coat finish
Black gel coat finish
[Description]
Long type rear fender with large flared ends, which covers tire deeply.
The elegant silhouette reminiscent of vintage bikes of the past is impressive.
The fender body is made of FRP with black gelcoat finish, and aluminum collar is used for the mounting part to increase durability.
This product is pre-wired with Classic taillight (Lucas S type).
To install the rear blinkers, please make a hole in the side of the fender or use the "Tail Blinkers Bracket" separately.
The fender body is strong enough for pillion riding.
・The taillight is small and stylish LUCAS S type.
The "classic taillight" is equipped with a round reflector.
・Pre-wired and couplered to the harness on the vehicle side.
・The main unit of the fender is installed via an aluminum collar to prevent damage from overtorque and vibration.
・It holds suffcient strength for pillion riding.
The elegant silhouette reminiscent of vintage bikes of the past is impressive.
The fender body is made of FRP with black gelcoat finish, and aluminum collar is used for the mounting part to increase durability.
This product is pre-wired with Classic taillight (Lucas S type).
To install the rear blinkers, please make a hole in the side of the fender or use the "Tail Blinkers Bracket" separately.
The fender body is strong enough for pillion riding.
・The taillight is small and stylish LUCAS S type.
The "classic taillight" is equipped with a round reflector.
・Pre-wired and couplered to the harness on the vehicle side.
・The main unit of the fender is installed via an aluminum collar to prevent damage from overtorque and vibration.
・It holds suffcient strength for pillion riding.
Note
* The image is only for reference. The image shown may differ from the actual product.
Caution
*Some of the products have parting lines (joints between molds) due to the molding process using split molds.It occurs at the joint of the mold and the mold, and there is no problem in the strength of the product.Please use it after painting or buffing if you are concerned about it.
*The included light bulb is a universal product.Please use it after replacing the wattage of the bulb with the wattage of the vehicle body by transplanting the tail lamp of the vehicle body.
*The lens part may melt due to heating of the bulb caused by vibration during driving or long time riding.It is recommended to use a smaller shaped bulb.
*The included light bulb is a universal product.Please use it after replacing the wattage of the bulb with the wattage of the vehicle body by transplanting the tail lamp of the vehicle body.
*The lens part may melt due to heating of the bulb caused by vibration during driving or long time riding.It is recommended to use a smaller shaped bulb.
ALSO VIEWED PRODUCTS
Apply Coupon
Image Review
Review detail
/