for Off-road Handlebar with Handlebar Brace HIGH Type
- Product number: T05Z9990079BK
- RISE CORPORATION
- |
- 4.5
- (2 reviews)
Check my coupons
Product Detail
Specification:
[Material] Aluminum Alloy 6061
[Size]
Width: Approximately 790mm
Height: Approximately 110mm
Pull: Approximately 60mm
Grip Width: Approximately 150mm
Grip Part Diameter: Approximately 22.2mm
[Size]
Width: Approximately 790mm
Height: Approximately 110mm
Pull: Approximately 60mm
Grip Width: Approximately 150mm
Grip Part Diameter: Approximately 22.2mm
[Description]
■This is HIGH type of handlebar for off-road vehicles made of aluminum.
■This product can be installed on vehicles with a handlebar clamp diameter of 22.2mm.
■The position is a little higher than the orthodox CR type handlebar.
■The brace is attached, so it is a product with sufficient rigidity as well as design.
■The pipe on the clutch side is knurled to prevent the grip from idling or falling off.
■In addition, the clamp is equipped with a convenient scale for positioning the handlebar, making positioning adjustment easy.
■The material is 6061-T6 aluminum, which is also used for aircraft, and is anodized after shot beading.
■In addition to being highly durable and resistant to corrosion, these products have a very good appearance and texture.
■This product can be installed on vehicles with a handlebar clamp diameter of 22.2mm.
■The position is a little higher than the orthodox CR type handlebar.
■The brace is attached, so it is a product with sufficient rigidity as well as design.
■The pipe on the clutch side is knurled to prevent the grip from idling or falling off.
■In addition, the clamp is equipped with a convenient scale for positioning the handlebar, making positioning adjustment easy.
■The material is 6061-T6 aluminum, which is also used for aircraft, and is anodized after shot beading.
■In addition to being highly durable and resistant to corrosion, these products have a very good appearance and texture.
Caution
*There is no manual or warranty.
*Depending on the model, it may be necessary to drill holes to install the switch box.
*The brake hose and accelerator wire may need to be replaced.
*Depending on the model, it may be necessary to drill holes to install the switch box.
*The brake hose and accelerator wire may need to be replaced.