Check my coupons
Product Detail
Specification:
Additional chain cover brackets are standard
Body Finish: Buffing
materials
・Main pipe: Super duralumin 7N01 material/deformed figure of merit cross section (triple square)
・Chain puller: A5083 material / OW type
Specification
[Main Pipe] Triple square cross section
・95mm in length, 40mm in width, 2.5mm in thickness
[Pivot section] machined, Pivot section has ball bearings + needle bearings
[Chain adjuster] OW type
[Adjustment range] 20mm to +40mm compared to stock
[Axle shaft] included, Shaft diameter 20mm
[Brake] Stock compatible
[Wheel] Stock compatible
Body Finish: Buffing
materials
・Main pipe: Super duralumin 7N01 material/deformed figure of merit cross section (triple square)
・Chain puller: A5083 material / OW type
Specification
[Main Pipe] Triple square cross section
・95mm in length, 40mm in width, 2.5mm in thickness
[Pivot section] machined, Pivot section has ball bearings + needle bearings
[Chain adjuster] OW type
[Adjustment range] 20mm to +40mm compared to stock
[Axle shaft] included, Shaft diameter 20mm
[Brake] Stock compatible
[Wheel] Stock compatible
Note
* This product will be made after an order, We will notice currect shipping time after we recieve an order.
Caution
*Some options (change of overall length, axle width, suspension support position, torque slot support position, oil catch tank specification) are excluded from the options on Webike.
*Since the spring rate is set to remain the same, the bike height is increased by 20mm.Change the settings as necessary.
*When replacing the sprocket or changing the ride height, be careful to keep the clearance between the chain and the swingarm.
*Stock step cannot be used.
*The combination with the stock exhaust has not been tested, but there is a possibility of interference because the swingarm member is wider than the stock.
*The image may contain other types.
*There may be changes in product specifications due to the manufacturer's reasons.
*Since the spring rate is set to remain the same, the bike height is increased by 20mm.Change the settings as necessary.
*When replacing the sprocket or changing the ride height, be careful to keep the clearance between the chain and the swingarm.
*Stock step cannot be used.
*The combination with the stock exhaust has not been tested, but there is a possibility of interference because the swingarm member is wider than the stock.
*The image may contain other types.
*There may be changes in product specifications due to the manufacturer's reasons.
Applicable Models
ZEPHYR1100
