SUPER CUBC100 80- Inner width of brake arm tip approx. 12.5-13mm4MINI series Inner width of brake arm end approx. 12.5-13mm
Product Detail
Specification:
CubyOriginal parts
Φ12Type (Width inside the tip of Brake Arm that fits:Approx. 12.5-13mm) ■Hole diameter:M6(Through) ·Exchangeable sealing gasket:Steel •Finishing:Electroless Nickel plating
[Compatible OEM Product No.] 95015-42000,43486-250-000 etc.
[Description]
The Knurl processing and seat grille treatment type of SUPER CUBC100, which was only used in the very early years around 1958-59, was made into Motif.. Φ12Type" fits a wide range of products up to C100etc.. There is a "Φ10Type" that fits older model vehicles of. This page is "Φ12Type", please select it after confirming the width of Brake Arm..
Caution
*Most of the 4-mini type vehicles have the same front and rear brake arms, but there are some scooters and other vehicles that have different front and rear brake arms. Please check the inner width of the brake arm tip of your vehicle to be sure, especially if your vehicle is older than 1980. This "Φ12 type" is suitable for brake arms with an inner width of about 12.5-13mm at the end of the brake arm. *Not for use with disc brakes. *It is compatible with the SP Mukawa machined aluminum brake adjusting nut. *Please note that the product specification may change due to manufacturer reasons.
Applicable Models
SUPER CUBC100 80- Inner width of brake arm tip approx. 12.5-13mm4MINI series Inner width of brake arm end approx. 12.5-13mm
