Product Detail
Specification:
[Ver. I]
Capacity 150cc
For side routing muffler
Body thickness:44mm(62mm including drain bolt)
[Ver. II]
Capacity 115cc
For center installation muffler
Body thickness:34mm(Drain bolt is taken out from side stand side)
Capacity 150cc
For side routing muffler
Body thickness:44mm(62mm including drain bolt)
[Ver. II]
Capacity 115cc
For center installation muffler
Body thickness:34mm(Drain bolt is taken out from side stand side)
[Description]
By placing the drain position on the left side, you can drain the filtered sludge (iron powder, gasket, etc.) at the same time as the dirty oil.
The drain in the stock position can be used for the balance meter sensor.
I for side mounted exhausts, and Ver.II for center mounted exhausts with a 40cc increase in oil capacity and drain position on the side stand side to allow clearance with the exhaust pipe.The fin shape increases the surface area and improves the cooling effect, and a drain bolt with a built-in magnet is standard equipment for sludge removal.
The drain in the stock position can be used for the balance meter sensor.
I for side mounted exhausts, and Ver.II for center mounted exhausts with a 40cc increase in oil capacity and drain position on the side stand side to allow clearance with the exhaust pipe.The fin shape increases the surface area and improves the cooling effect, and a drain bolt with a built-in magnet is standard equipment for sludge removal.
Note
* The image is only for reference. The image shown may differ from the actual product.
Caution
*Injection models cannot be installed.
*Ver.1 is compatible with stock and side exhaust.
*Ver.1 will contact with the main unit and drain bolt if the exhaust is installed outside the company.
Ver.II has secured the clearance for the outside center exhaust, but please measure the difference with the stock oil pan for the one-off exhaust.
*Ver.1 is compatible with stock and side exhaust.
*Ver.1 will contact with the main unit and drain bolt if the exhaust is installed outside the company.
Ver.II has secured the clearance for the outside center exhaust, but please measure the difference with the stock oil pan for the one-off exhaust.
