Check my coupons
Product Detail
[Description]
This set includes a bracket that can be installed with or without the stock front carrier and a headlight that can be switched between high and low.
Normally, it is difficult to light both lights with the amount of electricity generated by a moped, so one side is usually set to low and the other to high, but in order to light both, I set the bulb to PH7 18/18W.Therefore, both lights can be switched between high and low.
Also, unlike ordinary H4 bulbs, PH7 bulbs have a long part protruding from the socket, so the Bates light was designed from scratch to ensure sufficient clearance between the bulb and the lens.
Special wiring is included to make wiring the headlights easier during installation.
When the headlight of the GYRO X is removed and the handlebar area is cleared, it is necessary to relocate the blinker as well, so the bracket has a hole for the blinker.
The 10mm holes allow for the installation of 10Φ blinkers, but 8Φ blinkers can also be installed with the addition of washers.
When installing the headlight kit with the GYRO X stock front carrier, use the special bracket to mount the headlight kit. This will prevent the nuts from loosening due to vibration during driving.
The headlight is equipped with an angle adjustment screw so that the optical axis can be adjusted.
Normally, it is difficult to light both lights with the amount of electricity generated by a moped, so one side is usually set to low and the other to high, but in order to light both, I set the bulb to PH7 18/18W.Therefore, both lights can be switched between high and low.
Also, unlike ordinary H4 bulbs, PH7 bulbs have a long part protruding from the socket, so the Bates light was designed from scratch to ensure sufficient clearance between the bulb and the lens.
Special wiring is included to make wiring the headlights easier during installation.
When the headlight of the GYRO X is removed and the handlebar area is cleared, it is necessary to relocate the blinker as well, so the bracket has a hole for the blinker.
The 10mm holes allow for the installation of 10Φ blinkers, but 8Φ blinkers can also be installed with the addition of washers.
When installing the headlight kit with the GYRO X stock front carrier, use the special bracket to mount the headlight kit. This will prevent the nuts from loosening due to vibration during driving.
The headlight is equipped with an angle adjustment screw so that the optical axis can be adjusted.
Applicable Models
GYRO X
