Check my coupons
Product Detail
Specification:
Color: hard anodizing
Panigale V4 / left side
Panigale V4 / left side
[Description]
Securely guards the magnesium crankcase.
The crankcase of the Panigale V4 is made of magnesium to reduce the weight, and if it is damaged during a fall, such as a fall from a standing start, it will require expensive replacement.
AELLA guard is made of machined aluminum (A2017 material) and hard anodized to increase surface strength, and its unique color matches the magnesium cover.
The color is like champagne gold, but it is uncolored anodized aluminum, so it does not fade due to heat or ultraviolet rays.
The shape is the most important part of the design, so that the thickness (protrusion) does not appear as much as possible.
The maximum thickness of the wall is 6mm, and 2.5mm at the point where there is no burden.
The inside of the cover is covered with heat-resistant fluorine resin rubber to soften the impact on the case in the event of a fall.
○Other benefits
・This product can be used with AELLA engine sliders.
・Installation can be done by simply removing the lower cowl, and it takes only a few minutes for the product to be installed.
The crankcase of the Panigale V4 is made of magnesium to reduce the weight, and if it is damaged during a fall, such as a fall from a standing start, it will require expensive replacement.
AELLA guard is made of machined aluminum (A2017 material) and hard anodized to increase surface strength, and its unique color matches the magnesium cover.
The color is like champagne gold, but it is uncolored anodized aluminum, so it does not fade due to heat or ultraviolet rays.
The shape is the most important part of the design, so that the thickness (protrusion) does not appear as much as possible.
The maximum thickness of the wall is 6mm, and 2.5mm at the point where there is no burden.
The inside of the cover is covered with heat-resistant fluorine resin rubber to soften the impact on the case in the event of a fall.
○Other benefits
・This product can be used with AELLA engine sliders.
・Installation can be done by simply removing the lower cowl, and it takes only a few minutes for the product to be installed.
Caution
*Depending on the lot of anodized aluminum, there will be a slight difference in color.The color may not be exactly the same on both sides.
