- Home
- Model
- YAMAHA 401 - 750cc
- SR500
- Motorcycle Parts
- Engine Parts
- Intake Parts
- Carburetors
- YOSHIMURA
- YOSHIMURA: MIKUNI TMR40 Carburetor Set
MIKUNI TMR40 Carburetor Set
- Product number: 785-351-2102
-
- IN STOCK
- Out Stock
- YOSHIMURA
- |
- 0.0
- (0 review)
Check my coupons
Product Detail
Specification:
[Type] Power filter
[Specification]
・Inner diameter: Φ40
Base body:TMR40-36.
Carburetor pitch:Single Body
Spigot outer diameter (mm):45mm
・Spigot total length(mm):30mm
[Included parts] Manifold
[Parts required separately] Universal Oil Catch Tank Set
Secondary air blind cap (for 01-)
[Specification]
・Inner diameter: Φ40
Base body:TMR40-36.
Carburetor pitch:Single Body
Spigot outer diameter (mm):45mm
・Spigot total length(mm):30mm
[Included parts] Manifold
[Parts required separately] Universal Oil Catch Tank Set
Secondary air blind cap (for 01-)
Note
* The image is only for reference. The image shown may differ from the actual product.
Caution
*Either of the following throttle holder sets is required as a separate part for installation.
*Yoshimura Racing Throttle Holder Set for TMR Large Body (L=850mm)
・Yoshimura Racing Throttle Holder Set for TMR Small Body with Switch (L=850mm) (Switch side coupler wiring required to be changed)
*Parts required separately:YOSHIMIURA Oil Breather Tank Kit.
*Required parts are the parts that YOSHIMIURA Japan confirmed the installation during the development.
*Please prepare the appropriate parts if stock parts have been discontinued.
*The length of the throttle wire is the standard setting.Please note that it may vary depending on the installation method.
*The filter adapter included with this product is a machined aluminum product.
*There may be changes in product specifications due to the manufacturer's reasons.
*Yoshimura Racing Throttle Holder Set for TMR Large Body (L=850mm)
・Yoshimura Racing Throttle Holder Set for TMR Small Body with Switch (L=850mm) (Switch side coupler wiring required to be changed)
*Parts required separately:YOSHIMIURA Oil Breather Tank Kit.
*Required parts are the parts that YOSHIMIURA Japan confirmed the installation during the development.
*Please prepare the appropriate parts if stock parts have been discontinued.
*The length of the throttle wire is the standard setting.Please note that it may vary depending on the installation method.
*The filter adapter included with this product is a machined aluminum product.
*There may be changes in product specifications due to the manufacturer's reasons.
ALSO VIEWED PRODUCTS
Apply Coupon
Image Review
Review detail
/