- Home
- Motorcycle Parts
- Handles & Control Parts
- Controls
- Quick Action Throttles
- DAYTONA
- DAYTONA: Super High Slow Kit for Mixture
Check my coupons
Product Detail
Specification:
[Compatible] Various big carbs from Φ20-Φ28 (PE, PWK, VM, PC, CR-mini, VM, YOSHIMURA YD24/28)
[Size]
Outer length: 760mm
Rolling radius: 29mm
[Specifications]
Made in DAYTONA. Up to Ride Bar(MID), 760mm(29240)
Grip end through type
.
[Size]
Outer length: 760mm
Rolling radius: 29mm
[Specifications]
Made in DAYTONA. Up to Ride Bar(MID), 760mm(29240)
Grip end through type
.
[Description]
Φ20-Φ28 Designed for optimum take-up of various big cabs!
Φ20-Φ28 Super high throttle kit designed for the optimum take-up volume for various big cabs (PE, PWK, VM, PC, CR-mini, VM, Yoshimura YD24/28).
In the case of the Φ28 carburetor, it takes about 55 degrees of rotation to fully open.
For use with the NSR50 and NS-1, it can be used with either the stock carburetor or the Daytona big carburetor kit.
Φ20-Φ28 Super high throttle kit designed for the optimum take-up volume for various big cabs (PE, PWK, VM, PC, CR-mini, VM, Yoshimura YD24/28).
In the case of the Φ28 carburetor, it takes about 55 degrees of rotation to fully open.
For use with the NSR50 and NS-1, it can be used with either the stock carburetor or the Daytona big carburetor kit.
Note
Here is the instruction manual
Repair Parts are here
Repair Parts are here
Caution
*APE needs to be converted to disc brakes.
*APE requires a separate brake lever holder.
*After installing the product, it is necessary to drain the oil in the oil pump and to block the oil inlet on the carburetor manifold side.
*When using this product on the TZR50/R and TZM50R, the cable length is not long enough for the stock carburetor, so it is necessary to replace it with a big carburetor.
*There may be changes in product specifications due to the manufacturer's reasons.
*APE requires a separate brake lever holder.
*After installing the product, it is necessary to drain the oil in the oil pump and to block the oil inlet on the carburetor manifold side.
*When using this product on the TZR50/R and TZM50R, the cable length is not long enough for the stock carburetor, so it is necessary to replace it with a big carburetor.
*There may be changes in product specifications due to the manufacturer's reasons.
ALSO VIEWED PRODUCTS
Apply Coupon
Image Review
Review detail
/