Reviews
Fits: YAMAHA NMAX, YAMAHA NMAX 155, YAMAHA NMAX155
At 10,000 km maintenance
We were using endurance's High Power air filter which was replaced at the same time when the Exhaust System was replaced.
I wanted to do the same this time, but it was discontinued and I had no choice but to replace it with this one.
Low-density and high-density Filters are enclosed, but this time I installed both.
I then did a TEST run around the neighborhood … I didn't notice any change.
View detail
CYGNUS CUSTOM
Used as a Filter inside Air cleaner. The color between the filter and the air cleaner became red and cool.
I don't know about performance as I haven't run it much yet, but does it need fuel adjustment?
View detail
Cosmetic! For protection of Axle Shaft.
[How is it used?
Used at Circuit. The screw thread of Axle Shaft was almost crushed when it fell down without being attached.
Was the one you received as per Image?
Yes.
Was the installation difficult?
Just pull out the SHAFT and insert the Cup between both SIDE.
However, if you assemble the Rear Shaft without thinking about it, as has been your habit, you will have to redo the whole thing.
You might want to get into the habit of putting Cup in the beginning.
How was your experience with it?
I haven't tipped it over yet, so I can't give an imprementation, but it is solid and secure for the low price.
The resin Cover is removed, but still high enough for Shaft protection.
[Included Parts:were they on?
It had parts to accommodate M10.
[Was there anything that disappointed you?
None
Other items that would be helpful
Installation points and hang/Availability and clarity of the Instruction Manual/Points to consider/Items to purchase/Opinions and requests to the Manufacturer
If I had to say so, I would say that the length of the resin slider could be a little shorter, as it seemed to hit the ground in the Circuit.
View detail
appearance
It looks better Parenthesis and is easy to install. I am not sure how well it works yet. View detail
Visibility Up
The flowing blinker and position lights are always on. The sunset time is early in the season, so we put it on for visibility even on a small motorbike.
Bracket is a POSH Faith item number : 098101-26 and had no problems.
View detail
Best value reusable high efficiency air filter
About quality and texture, I can confirm that the quality is great and that the material used is a coarse sponge for the filter and a hard plastic for the filter frame. About the feeling of use, This air filter is highly efficient when used with the original air cleaner box and compared to using the original air filter with the same setup. The ability to reuse the sponge filter also makes it the best value air filter available. Products to buy together, If you are looking for good performance from the original air cleaner box then you will be needing to add the larger diameter air duct to your cart. Difficulty of installation, I can say the fitment of the air filter for my installation was very easy due to the ease of access to the cover of the air cleaner box that needs removing before simply placing the air filter in and installing the cover to secure the air filter in place. Cost performance and comparison with other products, The pricing of the product is the best. You receive an air filter made from quality materials that can be disassembled, cleaned and reused for thousands of miles. This air filter is much cheaper then other reusable air filters and more efficient then other similar priced disposable air filters. About shipping and packaging, My order was shipped within 48 hours of me placing the order and I received a few emails advising me of the status up until the order was dispatched. I find the link supplied to track my order very useful and the order arrived within the estimated date range. Any concerns, cautions, or advice when purchasing, I have no concerns or cautions when purchasing from Webike. I cannot recommend Webike enough for the majority of your biking needs. They not only sell aftermarket parts and bike gear but also OEM parts for your repairs and servicing needs. View detail
Koso power kit
Installed this kit on my 2022 honda adv 150 US version and man, it was what my bike needed. It comes alive at takeoff and doesn't stop till i hit the rev limiter. This is better than the S23 brand they sell here in the USA. 16 gram rollers is spot. View detail
Fits: YAMAHA SMAX, YAMAHA SMAX, YAMAHA MAJESTYS, YAMAHA FORCE155, YAMAHA MAJESTYS
It looks cool and I am satisfied with it.
This is a Cover that simply fits over the Radiator.
Mounting is Material attached to the surface:It is easy to remove the PlasticCover and fit it into the Radiator.
In addition, I put the KN Planning Radiator guardPanel inside, but I have no idea.
View detail
3rd generation
I'm not looking for any particular accuracy as long as I can see the signs of Regulator's Puncture. I'm not looking for accuracy or anything like that, except for the fact that it's 1V lower than the Large body Tester. If it breaks, I'll probably buy the same product again. I have one attached to my car and it has never broken down yet, so I think it might be a vibration or humidity problem. View detail
Fits: YAMAHA NMAX155, YAMAHA NMAX125, YAMAHA NMAX155, YAMAHA AUGER, YAMAHA FORCE2.0, YAMAHA X FORCE, YAMAHA BW'S125, YAMAHA CYGNUS Gryphus, YAMAHA CYGNUS Gryphus
It is easy to install. Fee Ring is also …?
Installation is easy with Phillips Screwdriver, 1 pc for easy replacement.
Driving Fee Rings Say Ha Drill Full throttle, full throttle Rider. I was thinking of going to... (Lol)
Response from medium speed is quite good, and I have a problem that I want to open Axel;
Another thing I noticed is that the low-speed Torque has become a little thinner.
This area may still need to be set up with a fuel conditioner!
By the way, my NMAX is "SP Tadao" The rest of the engine and drivetrain are all NORMAL. (Lol)
Perhaps a Normal muffler would be a better match?
The intake sound is quite nice, so even if you are a normal muffler rider, you can still enjoy the sound of the intake air. A little more powerful Sound…" I'm sure Rider will be able to find a way to make it an Exactly Item!
Really nice in that it's easy to install and you can feel the difference from the NORMAL!
For myself, I am a low speed Torque and Start dash oriented person, so I will give it 4 stars.
View detail
It's a relief to have it
I'm not comfortable with some kind of measuring device.
Water temperature gauge installed.
One thing I misunderstood is that I thought I could just interrupt the OEM Water Temperature Sensor and be done with it, but it seems I need to connect the ± line.
It's safe to boa with this.
View detail
It's cool
I was worried about other Blinkers.
Some combinations of Tail and Relay
There were some Cases that were sequential but not sequential.
I bought it with KOSOTail in Rear.
View detail
Flashing is bright!
I purchased this along with the KOSOBlinker from Front.
When you release the Brake, it doesn't disappear in a flash, it disappears slowly!
View detail
Fits: HONDA PCX125, HONDA PCX125, HONDA PCX125, HONDA PCX150, HONDA PCX150, HONDA MONKEY
I put it on anyway.
I see posts here and there that it's not very Ate.
I have Enigma on and bought it to use as a guide.
I bought a jc92 grom for Honda, but the coupler shape was different, so I modified the wiring and installed it.
I don't know how it works because it's still cold and I'm not used to it yet.
The installation was done using the existing Mirror holes and affixed to a self-made Plate.
View detail
KOSO Temperature Sensor
I purchased a M10×1.25. The Meter came with a 1/8, so it didn't fit.
The color is different from Included Parts:and it is Anodized Red, so it looks good.
View detail
KOSO Koso i-Gear Meter (Blue)
I have used Red in the past and purchased Blue this time.
I liked Blue better because it was more relaxed.
View detail
KOSO Super Slim Style Meter [Extension Harness 2m]
I purchased this extension because I am installing it on a vehicle, not a motorcycle.
The Coupler system made it easy to install.
View detail
Fits: YAMAHA Majesty S, YAMAHA SMAX, YAMAHA FORCE155 [BH9]., YAMAHA FORCE155 [BH9].
KOSOAir cleaner cover
Refreshing around the Engine, looks good, Large satisfied.
However, when removing the Air duct from the OEM and putting it into the Air cleaner I purchased, the process was Large strange, so for the price, I thought it would be better to have it installed from the beginning.
View detail
self-satisfaction
Parts that are self-satisfying only in appearance.
Personally, I prefer a little more Large Vertically long." would you like to ...?
Largeness is roughly the same as OEM.
View detail
Exhaust System Slider
I purchased this product in conjunction with the purchase of Full Exhaust System.
It is unclear if this will protect Silencer.
I was able to install the Refreshing without it looking too bulky.
I'm satisfied
View detail