Reviews
1P2014
The head lamp on my Honda Little Cub burned out. I liked the price and parameters of this lamp (not much power does not overheat the cartridge). Everything turned out to be good in quality, the lamp works perfectly. View detail
The size is just right and the texture is good.
Used in 2008 YZF-R1.
LengthSize is also really Exactly.
I did not originally intend to use parts cleaner, but I was able to get in without any difficulty without using Bond paint parts cleaner.
View detail
ESTRELLA's crying place.
ESTRELLA's Restore, which has become immobile, maybe the end of the line here.
Just before it became immobile, it was leaking oil frequently, and I was looking for various causes this time while restoring it.
(1) Deterioration of Piston ring → done.
(2) CamTensioner problems→done.
(3) Gasket degradation → done.
I have been repairing the grains in various ways, but there was a blind spot.
There was oil leakage from the root of the oil pipe on the crank side.
Is it Gasket?
I took it off for a test, and as I expected, it was Gasket. I replaced it.
Oil pipe, as the name implies, is a pipe through which oil passes, but why is it attached?
It has to do with oil pumps.
Oil pump
Equipped on the lower front side of the cylinder block and driven in conjunction with the crankshaft.
The OilCleaner sucks up oil accumulated in the oil pan and supplies oil to the sliding parts of the cylinder head and cylinder block. 。
Think of it as gravity, so Oil goes down too, it accumulates in the Oil pan.
The oil pipe is where the oil passes through.
Oil pipe
Oil pipe is a piping that serves as a route to feed engine oil. 。 Engine oil plays a role in lubrication and cooling, and oil leaks can cause seizure and other problems. 。 Also called oil transmission pipe.
Engine oil not only lubricates the engine, but also cools it.
If the engine is air-cooled, the engine oil cooling effect is even more important.
And if the oil as an auxiliary role for cooling does not circulate correctly due to leakage, .......
→If the amount of engine oil is less than the proper amount, a strange noise may occur while driving, or the engine sound may become louder than usual. 。 In addition, low engine oil reduces the natural lubricating effect of the engine, causing a risk of engine seizure in some cases.
In my case, I don't know why it didn't burn out... I was able to manage to ride it while adding oil... now that I think about it, it's scary (laughs).
Gasket replacement.
Procedure
Remove the oil pipe from the cylinder head side, the carburetor side, and the crankcase side.
↓
(2) Gasket of rubber is confirmed at the tip of the pipe on the crankcase side. 。
↓
Replace (3).
↓
Assemble in the order of ? ?→?.
[After exchange]
◎Oil leaks are completely gone 。
◎A little test drive made it run Smooth.
This completely fixed the Oil leak. 。
Regardless of the year, it is a part that comes in contact with oil, so deterioration is to be expected. If you feel oil leakage even a little, it may be a good idea to suspect this part. 。
It seems that ESTRELLA has many examples of repairs here (laughs).
The only thing left to do is to adjust Tappet.
View detail
XG250 TRICKER
I use it on my XG250 TRICKER.
The Motorcycle Cover is a consumable item, so this thickness is sufficient for this price.
View detail
Genuine DID 420NZ3 Gold Spare Chain Link
I do not really use these too often as they are basically one step up from a push bike chain anyway. But, it is always good to have them in stock just in case a customer needs one. I found this chain link by just searching through the DID inventory on Webike website. It was really easy to find so you should be just fine. I ordered a few other different chain links along with this as I do like options with spare links. All were shipped together and this saved some shipping cost. My order arrived in 5 days from being shipped. The chain link came in a nice sealed packet with all that is needed to refit. You do get a not seem to get the white grease packet in this size chain but that's ok, I have a lot of these anyway. The chain link is very well made, it also is in the gold colour so nice looking too and it is also embossed with the DID logo so you know it's genuine. Very happy with these small purchases and these will keep me going for future. Thank you Webike. View detail
I think it is necessary and sufficient.
This is just my personal opinion, but I think it is not a PeLePera, and considering the price, I think it is satisfactory enough. View detail
Rear Sprocket purchased with tooth count change
Purchased to change the number of Chain pieces when changing the number of teeth on the Rear Sprocket. clip type is easy to adjust as it can be removed as many times as needed. View detail
It looks better now.
I put it on because it stands out from the OEM. View detail
Good variety of color variations
Standard NGKPower cable, used for CUB.
Speaking of NGK, I had always thought of Red and BlueCable images, but I was surprised to find that NGK has a wide variety of color variations.
I was curious about the Yellow color code + BlackCap, so I bought it, and the actual color was a nice bi-Bit color as well.
View detail
Chain assembly
The chain was stretched, so I cut it and used it for reassembly.
Installation does not seem to be that difficult since it is a Clip.
View detail
be too much
I would like more room.
Sure, you can get in, but it will be tight-fitting with no room at all.
Recommendation to others is not possible at all.
It's a shame because I had high hopes for it
View detail
Fits: YAMAHA Cygnus X, YAMAHA Cygnus X SR, YAMAHA YD250, YAMAHA YD250S, YAMAHA Cygnus 125, YAMAHA YD125, YAMAHA YD125S, YAMAHA SDR, YAMAHA TZR125, YAMAHA TZR50, SUZUKI Vexter 150., SUZUKI Hustler 50, SUZUKI SW-1, SUZUKI Wolf 50., SUZUKI Koreeda., SUZUKI RG125 gamma, SUZUKI RG50 gamma, SUZUKI GN125E, SUZUKI GS125E, SUZUKI K-125
It's not cheap or bad.
My own ideas on how to choose Motorcycle Covers.
○ First, consider the performance required to protect Motorcycle.
It is not enough to apply a cover to your product. Check the waterproof and water-repellent properties.
Check it out especially if you spend a lot of time parking your motorcycle! After a rain or during the rainy season, the inside of the motorcycle cover tends to get very humid, so a humid environment is not good for your motorcycle. 。 If you remove your Cover every day when commuting to work or school, you may not have to worry about it much, but if you do not ride your motorcycle frequently or frequently, you should choose one with ventilation.
Small scratches when attaching and detaching should be avoided! Can the inside fabric also be protected from Check tampering?
Check here for security. Also, check if there is a hole for a chain lock. It is important that the chain is visible from the outside of the cover!
I bought this based on the above four points.
Certainly the more expensive Covers are superior in durability, etc., but since they are basically outdoors, it is essential that the fabric weaken over time.
I think it is not the price.
good point
○ Water repellent performance of the fabric is sufficient for the need.
○ The bottom of the Cover is open, not sealed, so there is no need to worry about ventilation.
The fabric is smooth and soft TaffetaMaterial, so it will not damage the body of the vehicle.
There is a hole through the ○○ bar type lock.
○ Inexpensive, but with basic functionality.
A bad point
I thought it would only last about 2 years.
Even an expensive Seat will inevitably deteriorate over time, and if we have to replace it eventually, it would be good if it is inexpensive and has basic functionality.
View detail
Just right for NSR250R
I bought this for my NSR250R Cover.
It is not too thick, not too thin, just normal. When you hold the folded Cover, it is zzzzzzzzzzzzzzzzzzzzzzzzzzzzzzzzzzzzzzzzzzzzzzzzzzzzzzzzzzzzz.
View detail
ALCAN hands iGrip
I have used it for VTR250 and MT-03, and I bought it again this time. The color is Orange red to match the body color, and it is a good accent for the handlebar. When I installed it, I used a small amount of glue to prevent shifting and decided not to use wiring. View detail
Maybe LL would be better for Z900RS people?
L makes it seem a little small.
If you make it LL, it's just right.
View detail
Oil seal
Project bike, one of most difficult to work on as need to disassemble exhaust to access. Easy to replace once old one removed. Love OEM parts at good price View detail
Two years of use and still Large sturdy!
I used it on another vehicle with Blue empty parking for 2 years and it has worked fine with no problems except for some ragged loosening and fading of the fibrous material around the key for hole, so I bought a Repeat!
It is also useful for the Motorcycle body as it does not scratch easily!
I don't know because I have not used it in a dusty or sandy environment, but it works fine in an environment with Concrete and Asphalt floors.
View detail
Fits: HONDA CB125T, HONDA CBX125F, HONDA CBX125 CUSTOM, HONDA CD250U, HONDA Dio110, HONDA JAZZ, HONDA NS-1, HONDA NS-50F, HONDA PCX, HONDA GYROX, HONDA SPACY100, HONDA SPACY125, HONDA MAGNA50, KAWASAKI AR125S, KAWASAKI AR50, KAWASAKI AR80-II, KAWASAKI EPSILON150, KYMCO V-Link125, KYMCO SUPER9, KYMCO TOP BOY100
Large will also serve as Small.
[How is it used?
It is used for LITTLE CUB.
I bought the Motorcycle Cover because I didn't want dust and dirt on my motorcycle, which is stored in my garage and workshop.
A middle-aged man who dreamed of the fashionable garage featured in magazines and other publications muttered to himself as he looked at his prefabricated garage with no place to step on garbage garbage garbage. It's not what I was going for. 。
I work on everything in the garage, so there is too much dust, so a body cover is necessary to store the car in the garage.
Did you receive the item as per the Image?
I have purchased 3L/4L Size of this product and used it on my SV650 before, and this time I have purchased 1~2 Size Large body cover as well.
I personally like camouflage patterns, so I searched all over Webike for this product and chose it.
How did you like it?
I am satisfied with the camouflage pattern and the color, so I bought a different Size.
In my case, I use it in Garage, but the fabric is thin, so I feel that it is not very durable and weather resistant when stored in the sun, such as on a bicycle parking lot.
Recommended size of Manufacturer by car model in LITTLE CUB "S" Size, but when you use it on a vehicle with a rear box or front basket, I think you will not regret purchasing a 1~2 Size Larger product.
[Points to note]
It is labeled as 100% Polyester, which, as noted above, is sufficient for indoor use, such as in a garage, but if used outdoors, you may not expect it to be durable.
Also, when the Engine or Exhaust System is hot, it is indicated that it should be used only after the engine has cooled down sufficiently.
How did it compare to other products?
This time I want a camouflage body cover." This was the only product that matched the conditions that we had in mind, so we did not compare it with other products.
Other items that would be helpful
Point and hang of installation
Not for use on vehicles at high temperatures.
Since the Motorcycle Cover does not offer strong durability and weather resistance for its price, it may last a little longer if it is stored indoors or in the shade when not in use to avoid ultraviolet rays. As mentioned above Heat resistant, durable, weather resistant If you are looking for a more expensive Body cover, consider a more expensive Body cover.
[ITEMS TO BUY TOGETHER
If theft prevention is also a consideration, purchase a Motorcycle locketc. to enhance theft protection.
[Opinions and requests to Manufacturer
If you could add a blue camouflage pattern to the lineup, it would make the Garage even more colorful.
View detail
I wanted Cap.
I purchased this product to connect to the Ignition coil in Mukawa and wanted to unify the colors.
Cutter off the adhesive bonding the Cap to the cord, peel off the Cable outer skin of the Mukawa Ignition coil, insert it, and fix it with adhesive, and you are done.
The excess Cable of the product in question is used in place of the Cable attached to the OEMCoil.
This would have been unnecessary if caps in a variety of colors were available, but they are not.
Even if only the cable is replaced, the idling is stabilized and the long-used OEM product is refreshed.
View detail
Power cable & elect. module Dev'moto
Bonjour from France Thanks you for quick shipment of my order , i fixed it on ma yam sr 125 in addition of a new electronic module Dev'moto(made in France) with an iriduin plug already than replace the TCI -dead-:( the result is more better ( already too with the new module) cold cranking + little better torque at low rpm, and more i could reduce my idle setting ... so very happy with my purchase ... voilà ! View detail