Reviews
1P2014
The head lamp on my Honda Little Cub burned out. I liked the price and parameters of this lamp (not much power does not overheat the cartridge). Everything turned out to be good in quality, the lamp works perfectly. View detail
Easy installation, no brightness problems.
Until now, we had been using Type with LEDs affixed at the top and bottom, but the straightness of the LEDs was poor when Up is lit, so we always used the LEDs facing down.
This type of LEDs are affixed in the LeftRight type, so the straightness when the LEDs are up is also OK. This time, I installed it on a square eye light, but I think it would be best for a round eye light. Finally, I am satisfied with the brightness.
View detail
Fits: HONDA DIOSR, HONDA DIO, HONDA TACT BASIC, HONDA ZOOMER, HONDA SMART・DIO Z4, HONDA SMART・DIO, HONDA STAND-UP TACT, HONDA SUPER DIOZX, HONDA SUPER CUB 90, HONDA SUPER CUB70, HONDA SUPER CUB 50, HONDA SUPER CUB110, HONDA GORILLA, HONDA CREA SCOOPY, HONDA QR50, HONDA BAJA, HONDA TODAY, HONDA TODAY DELUXE, HONDA CUB PRESS, HONDA MONKEY
No Impossible part
There is no part that is not possible as a Body Cover. View detail
WhiteLight and good looking!
It's super easy because all you have to do is change the Valve.
I was able to purchase Valve's length and fit without concern because of the information provided by its predecessors.
D-TRACKER-X's dark, orange-tinged light has been brightened to white.
I haven't driven at night yet, so I haven't been able to experience the true effect, but the impression of the motorcycle will change considerably just by having white light.
View detail
Bright and low power consumption
I was worried about whether I could install it on my KSR2 since the body is longer, but I saw the impressions of someone who had already installed it on his KSR and he said it could be installed, so I bought it and installed it.
The length was a limit, but I was able to install it, the Others had no problems with the installation, and the rubber cover went on without modification.
The beam coverage has been widened. The optical axis remains the same and is large and sturdy. The high beam illuminates high up and is even brighter, so you have to be careful of oncoming cars.
I also changed the tail lamp to LED, so the power consumption was reduced a lot. I installed the LeftSwitch of the previous model in my car, so I can switch from LightOff to Light when Halogen is on.
Idling dropped about 200 RPM when switched to On, but switching from LightOn to LightOff when LED has no effect on Idling.
View detail
I put it on my RG 50Gamma.
It's just like changing a light bulb.
There is no problem
View detail
Cool grips
I bought these beautiful grips again - this time to replace them with a Honda Super Cub.
The handles are of excellent quality and are not expensive and fit perfectly. The replacement took a little time.
I bought these beautiful handles again - now to replace them with a Honda Super Cub.
The handles are of excellent quality and are not expensive and fit perfectly. The replacement took a little time. -------------------------------------------------- -------- I bought these beautiful handles again - now to replace with Honda Super Cub. Handles of excellent quality and are not expensive and are perfect. The replacement took a little time. I BUGHT Th, Beautiful Handles AGain - Now To Replace them with a Honda Super Cub. The Handles are of Excellent Quality and ARE NOT Expensive and Fit Perfectly. The Replacement took a Little Time. Powered by Google Translator
View detail
It looks better now.
I put it on because it stands out from the OEM. View detail
Good variety of color variations
Standard NGKPower cable, used for CUB.
Speaking of NGK, I had always thought of Red and BlueCable images, but I was surprised to find that NGK has a wide variety of color variations.
I was curious about the Yellow color code + BlackCap, so I bought it, and the actual color was a nice bi-Bit color as well.
View detail
Very happy
Was skeptical at first, but gave it a shot. Ordered 1 to ship to Oklahoma. Received item in a timely matter and it's what I wanted. Will be ordering from them again. Thank you View detail
subtle
Perhaps it is because the Scooter has a low power generation rate, but I feel that the Halogen bulb has a wider beam range and better visibility.
This might be better with a slightly better Halogen bulb.
View detail
Fits: SUZUKI K50, SUZUKI K80, SUZUKI Birdie90, HONDA SUPER CUB 90, HONDA SUPER CUB 50, SUZUKI Birdie80, HONDA BENLY PRO, YAMAHA Axis Treat, YAMAHA YSR80, YAMAHA AXIS 90, YAMAHA YSR50, YAMAHA VOX, YAMAHA YB50, YAMAHA V80MATE80, YAMAHA V80MATE50, YAMAHA TZ80, YAMAHA TDR80, YAMAHA TZ50, YAMAHA TDR50, YAMAHA FZ50
I wanted a camouflage Motorcycle Cover.
[How is it used?
Used for KSR-II.
It is kept in Garage, but the reality is that it is not a fashionable thing called Garage. Garage and workshop. It is reasonable to say that dust and dirt are falling on motorcycles that have not been ridden for a while....
I purchased the Motorcycle Cover to improve the current situation where the first thing I do when I start to ride my motorcycle, which is supposed to be kept indoors, is to wash it.
Did you receive the item as per the Image?
I have purchased 3L/4L Size and L Size of this product in the past, and they have been used on SV650, SEROW, LITTLE CUB, etc., respectively, and have been very useful. I usually buy 1~2Size Large size body cover, but this time, I bought a 3L/4L Size and L Size body cover, which are listed on the back side of the box. Size appropriate for KSR-II." I purchased the M Size which is
I personally like camouflage patterns, so I searched all over Webike for this product and chose it.
How did you like it?
The reason why I had purchased the Large size is that I had been using it for a vehicle with a Rear box and a front basket. Bare bones. I purchased the M Size as specified for the proper size because it is used for a vehicle with a
when covered with Just fit." I will probably buy the M size again next time because I don't plan to do any more customization or rear box installation, etc. on this vehicle.
As I mentioned above, I use it for vehicles stored in Garage, but the fabric is thin, so I feel that the durability and weather resistance are a bit stiff if the vehicle is stored in the sun, such as on a bicycle parking lot.
[Points to note]
It is a thin fabric, labeled 100% Polyester, so you may want to consider replacing it after around one year if used outdoors.
Also, when the Engine or Exhaust System is hot, it is stated that it should be used only after the system has cooled down sufficiently.
How did it compare to other products?
Camouflage-colored body covers used to be sold by several companies, but recently they have become scarce, perhaps due to lack of demand.
Among them, Mr. Uniker has Green Light camouflage and Color:I can only be thankful that they have S Size to 8L for each of the two color variations of Gray camouflage.
Other items that would be helpful
Point and hang of installation
Not for use on vehicles at high temperatures.
Since the Motorcycle Cover is not strongly appealing to durability and weather resistance for its price, it may last a little longer if it is stored indoors or in the shade when not in use to avoid unnecessary ultraviolet rays.
similar to the above Heat resistant, durable, weather resistant If you are looking for a more expensive Body cover, consider a more expensive Body cover.
[ITEMS TO BUY TOGETHER
If theft prevention is also a consideration, purchase a strong Motorcycle locketc. to enhance theft protection.
[Opinions and requests to Manufacturer
We would be very grateful for two different color variations, but we would also appreciate it if you could add sand camouflage pattern, marine camouflage pattern, etc. to the lineup to make the garage even more colorful.
View detail
Product # 25602
This time we needed grips for the "Suzuki Birdie". Once again, the grips from "Hunter" did not disappoint. Everything fits perfectly, the workmanship and material are top notch as always. I am very glad! View detail
I wanted Cap.
I purchased this product to connect to the Ignition coil in Mukawa and wanted to unify the colors.
Cutter off the adhesive bonding the Cap to the cord, peel off the Cable outer skin of the Mukawa Ignition coil, insert it, and fix it with adhesive, and you are done.
The excess Cable of the product in question is used in place of the Cable attached to the OEMCoil.
This would have been unnecessary if caps in a variety of colors were available, but they are not.
Even if only the cable is replaced, the idling is stabilized and the long-used OEM product is refreshed.
View detail
Power cable & elect. module Dev'moto
Bonjour from France Thanks you for quick shipment of my order , i fixed it on ma yam sr 125 in addition of a new electronic module Dev'moto(made in France) with an iriduin plug already than replace the TCI -dead-:( the result is more better ( already too with the new module) cold cranking + little better torque at low rpm, and more i could reduce my idle setting ... so very happy with my purchase ... voilà ! View detail
Headlight LED
Installation was easy. It was brighter than I expected. View detail
OEM Equivalent Product, cheaper than OEM
Used for LITTLE CUB.
The low beam ran out, and a short time later the high beam also ran out. I bought this one because it was an emergency situation and it was immediately available in stock. The standard is 25-1. The Pine Stripe part number is 1P2015.
The grade of the bulbs is also the same as the OEM, White Hot bulbs, not Halogen.
I also found HalogenType, but the price difference was about three times as much, so I decided to go with the cheaper version.
Replacement is Light rim bottom, Quantity:Pair (for Left and Right) Remove the screw on the Plus of the light rim and lift the light rim upward to remove it.
The Glass part is replaced while touching as little as possible. Time required:2 minutes.
It lit up with no problem. I am relieved. I don't know about the durability yet, but it is a long-established domestic product and I am sure there will be no problem.
View detail
good choice
I bought it after seeing a review that you often replace it with a set with Takegawa reinforced coil. I bought any color because it was hidden in a cowl, and I connected the ngk power cable with the Takegawa reinforced coil and installed it. I had to cut the length and install it, but I thought there would be some loss, so I just connected it. It starts up well and I think it's effective in output. Thank you. View detail
great greap
I liked these grips, they look like factory ones, they were delivered in 2 weeks, I’m very happy with the purchase, I will recommend them to friends ------------------------------ ---------------------------- I liked the vulture data, they looked like factory ones, delivered in 2 weeks, I am very pleased with the purchase, I will advise my friends Powered by Google Translator View detail
Mini greap hunter
very good grips, similar to the factory ones, very soft, comfortable to hold, I really liked it, I will recommend it to my friends View detail