Might increase fuel economy?

The FSprocket has not been replaced yet and has not been run much, but it feels good.
The Meter reading was previously 4000 rpm at 60 km travel, but after the replacement, it became 3500 rpm and I was able to travel up to 6th gear without any discomfort.
Next time I will replace and adjust RSprocket and see. View detail

It was a darker Bronze color than the picture.

I fell 200 times rolling over on 2 Ding Down.
I thought it was Gold in the picture, but it was actually a Bronze color. View detail

Accurate and lightweight

I bought this for Circuit.
For MINICourse is swinging to the side with the show.
Lighter weight compared to OEM helps reduce load under Spring. View detail

It looks fancy, but it surprisingly MATCHES!

When it arrived. "That's a flashy color…." But when I put it on, it was surprisingly good.
I don't know about the quality part since it has only been run once, but I am sure it will be Large sturdy. View detail

Gsx-r1000 17 to 21 years old is not hooked up to the Gsx-r1000!

Gsx-r1000 17 to 21 years old is not hooked up to the Gsx-r1000!
Correct the fit. View detail

Conversion to 520

I Converted from 530 to 520. It is easier to push and move. 17T,18T should be re-released. View detail

beautiful color

It was a beautiful color ?

It felt light to hold! View detail

520Conversion

OK as Items to 520! View detail

Which is the front?

Purchased for XJR-1300Chainfor Conversion.
I don't know the front and back. installed based on the Line on the body side of the OEMSprocket. I think the thinner side is the body side. View detail

Parenthesis OK

Circuit to change Final
Purchased

OEM's number of Chain links.
It cannot be installed.

The number of LINKs needs to be increased.

Changing the Chain is a Large oddity.
I changed Front's Sprocket to 13 guns.

Steel, but light. View detail

Note the chain size

I bought this for my KLX125.
but please note the supported Chain size.
OEMSize is 428, this item is 420.

It is my fault that I bought it without checking it properly, but the Chain was still 428, so the mesh does not fit slightly and damages the Chain.
Specifically, at the end of the winding side, the Chain hits the pile of Sprocket and makes an unpleasant clattering sound when running.
Finally, we had to repurchase a 428-compatible Sprocket.
If it can run, it can run, but we recommend that you check the Chain size you are using before buying it. View detail