Genuine DID 520ERVT Replacement Chain Link

I always like to have some of these in stock in case of any issue during fitting different chains. The DID 520ERVT is one I do have in stock but have no spares. I found this chain link by just searching through the DID inventory on Webike website. It was really easy to find so you should be just fine. I ordered a few other different chain links along with this as I do like options with spare links. All were shipped together and this saved some shipping cost. My order arrived in 5 days from being shipped. The chain link came in a nice sealed packet with all that is needed to refit. You do get the white grease packet in this size chain so that's always a good thing, I have a lot of these anyway but you cannot have too many. The chain link is very well made one, it also is in the gold colour so nice looking too and it is also embossed with the DID logo so you know it's genuine. I keep the rivet link type and this clip joint type but had ran out of this version, hence the purchase. Very happy with these small purchases and these will keep me going for future. Thank you Webike. View detail

For CB250F

.Actually this item i could not found in my country (VX Series Joint Link 520VX3). Finally I bought it from webike. It is original. Very good packaging.fast shipping.I am happy to deal with the webike team View detail

Changed from Clip to Crimp

When replacing the chain on the KLX230R, the ERVT came with a clip-type joint, but the clip didn't fit well and I had to press-fit it too much and it failed, so I decided to use a Crimp joint, which I am used to.

I think the Crimp is fine for me, and the Crimp is easier to work with because I'm used to it. View detail

Convenient and lightweight! But low strength

Large change is useful for washing the underside of the Motocrosser!
However, it is so strong that it will bend if you try to start KICK with STAND applied.
If it only supports the weight of the car, there is no problem.
The handlebar can be used as an insert, making it easy to insert into an Axle Shaft. View detail

just right

The OEMSTAND has large, stable feet, but it cannot be hooked onto a vehicle body, making it difficult to carry.
So I bought this DRC STAND.
As shown in the photo, there are front and rear joints, and one of the joints can be changed longitudinally, so a total of three joints can be used.
Husk TC125 was Just size. View detail