Headlight LED

Installation was easy. It was brighter than I expected. View detail

To CT110 HUNTER CUB

Installed together with Exhaust System replacement. After the installation, there was no exhaust leakage. Don't forget to replace the Gasket when replacing the Exhaust System. View detail

OEM Equivalent Product, cheaper than OEM

Used for LITTLE CUB.
The low beam ran out, and a short time later the high beam also ran out. I bought this one because it was an emergency situation and it was immediately available in stock. The standard is 25-1. The Pine Stripe part number is 1P2015.
The grade of the bulbs is also the same as the OEM, White Hot bulbs, not Halogen.
I also found HalogenType, but the price difference was about three times as much, so I decided to go with the cheaper version.

Replacement is Light rim bottom, Quantity:Pair (for Left and Right) Remove the screw on the Plus of the light rim and lift the light rim upward to remove it.
The Glass part is replaced while touching as little as possible. Time required:2 minutes.
It lit up with no problem. I am relieved. I don't know about the durability yet, but it is a long-established domestic product and I am sure there will be no problem. View detail

Cospa is good

Scooter has to remove the exhaust pipe every time we change the rear tire, and we try to replace the gasket each time, but the price of OEM products is high. I have been searching for a more cost-effective product.
This is not a product where you will notice a difference in performance, but because it is a consumable product, it meets the objective of keeping the price low. View detail

Low cost Low Bright

To be honest, the brightness is not enough at all. However, if you want a LED light that shines white, this product is a good choice because of its low price and easy installation. If you need brightness for touring, this product is not reliable. It will be difficult to drive at night in places with poor street lighting, especially in bad weather. Especially in bad weather. But it is cheap! Easy installation is excellent. View detail

Ruthenium~ is what, what, what♪

When SEROW250 is used, the corresponding MotoDX." I had been using Premium RX (DCPR7ERX-P) by replacing the plug cap, but this time, it will be MotoDX Plug (CPR8EDX-9S).
It is the same Engine as the two JigSar models, so the same application should be used.
By the way, Car has been using Ruthenium type Plug, so I have a sense of security about its durability (I think it will last longer than Windshield IRIDIUM type), and I have no negative impression about its usability, so if it is worth the cost (I don't think it will be a loss), don't hesitate to buy it! If you don't think it's worth the cost, don't hesitate to buy it!
It is impossible for us amateurs to perceive only a slight difference, but we can still feel the smoothness of the product, which we think is very good. 。 I can recommend it to many people! View detail

The LED light bulb brightness and projection angle

I bought two M&H Matsushima led headlight bulbs for my 2014 HONDA MSX125 and got them installed. The brightness is less than that of OEM bulb. Horizontal projection angle is not wide enough, so I got back to the OEM bulb. Sorry. I do not recommend this bulb and gives two stars for the overall rating. View detail

Mirror arrived cracked.

The Mirror arrived with a crack.
I didn't return it because I noticed it after I installed one of them.
The box is in the worst possible sticky condition.
I think Design is the best. For a properly managed operation.
I would like it mailed to me. View detail

great greap

I liked these grips, they look like factory ones, they were delivered in 2 weeks, I’m very happy with the purchase, I will recommend them to friends ------------------------------ ---------------------------- I liked the vulture data, they looked like factory ones, delivered in 2 weeks, I am very pleased with the purchase, I will advise my friends Powered by Google Translator View detail

Very good Touch!

This is a 2008 ZOOMER.
The mileage was only about 5,000 km and it was still usable, but it started to squeal and work poorly, so I replaced it with a reliable Daytona.
It took some effort to remove the rear tire nut, but I am satisfied with the soft touch and effectiveness.
Durability will be confirmed in the future. View detail

It is easy to install.

The white light of LEDs feels bright.
It will probably have a long lifespan, so it will be cost effective.
Replacement was the same as a normal Valve replacement. View detail

Mini greap hunter

very good grips, similar to the factory ones, very soft, comfortable to hold, I really liked it, I will recommend it to my friends View detail

Looks cool.

Anyway, since it is a race ish, it is similar to KITACO's discontinued product, but if you put it on CHALY and start off on a slope, high-octane gasoline will leak just a little bit, but I forgive it because it looks cool! View detail

Used on a 50cc 2Cycle moped. Quite bright!

I originally used M&H Mats Stripe Halogen bulb 12V35/30W Clear, which was brighter than OEM, but still old mopeds are still dark.
Since I use them for commuting, I decided to use LEDs for safety reasons.
Installation can be done simply by removing the headlight cowl.
The color is a beautiful White and the brightness feels 1.3 to 1.5 times brighter.
The white color is more like a recent vehicle than the yellow color, which makes it a better parenthesis.
I think it is a good cosmetic product because it is inexpensive and made by Mats Stripe, which is a reliable company!
I use it on my AF35LIVE DIOZX, but the Valve is PH7 because I replaced the Headlight with an external one. View detail

Ngk is my frist choice

The quality and texture is very good .NGK spark is popular in the world so i don't worry about that. This spark feeling is same with Ngk Iridium spark . The installation is very easy. The cost is cheap The shipping is fast and packaging is very good . View detail

Used with CUB110

Used on JA10. It is a normal Exhaust Gasket.
Some people don't change it, but I think it is better to change it properly. View detail

Quantity:Seeking 1 pc!

I used this Gasket when replacing the exhaust system on my CRF-125F. However, I think it would have been better if I could have purchased it as a single item and at a lower price since I use only 1pc. of the Gasket for CRF-125F. View detail

Performance is top notch!

The Engine is good and spurts out perfectly.
But 3 times more than the price of Normal plug!
Cost performance is the lowest!
The average score between the two would be about 3 points! View detail

Always used Takegawa Drainbolt

Quality and texture information Perfect for installing temperature sensors with magnetic magnets It's good that the color can be used as a point Goods to buy together dn meter, thermometer It's easy to install Better cost performance and comparison to other products WeBike packaging is always great, arriving in a week for delivery and packaging Purchasing concerns, precautions, or advice Care must be taken when installing a product temperature sensor that must be fitted if installing a dn meter or thermometer View detail

periodic replacement

Used for AF62 DIO.
There is no perceptible change after replacement, but it is a regular replacement. View detail