Reviews
Fits: HONDA CB400 Super Boldor, HONDA CB400 Superfor, HONDA CB400 Superfor, HONDA CB400 Super Boldor
Main stand installation
Purchased to install on a 2012 CB400SB. However, since it is 2014 or later OEM parts, the Hook is not attached to the body as it is, and it needs to be shaved. I was able to install the Hook after shaving 3mm with File. The last difficulty was that the spring was so strong that it could not be attached according to the instruction manual. It is working well when I check the amount of oil and clean the chain. View detail
Peace of mind in times of need
It's heavier than it looks, which made it a bit of a challenge to install, but the build quality is solid for that, and most importantly, the Side Stand works well in places where I'm uncomfortable or when I'm doing a little maintenance. With the added weight of the car, the Demerit doesn't feel like much at the moment, but I wouldn't be bothered without it! If you ask me, you're right... View detail
Fits: HONDA CB400 Super Boldor, HONDA CB400 Superfor, HONDA CB400 Superfor, HONDA CB400 Super Boldor
OEMs are safe, but …
I installed it on a 2011 CB, but there was no Instruction Manual, so I had to go ahead and I referred to the imprints I purchased
LargeThey were helpful
It took about 30 minutes to install it, but it was difficult to set up the STAND I did
I still can't get a hang of it
Because it's OEM parts, I'm not worried about it, but the U shape that attaches to the body of the car is the first thing that comes with the Hook I'm worried that I didn't fit in and straighten out
View detail
Exhaust System (Exhaust manifold) It is easy to wear it off.
We started work from the state where Spring was attached in advance. I think that it would be better for two people to use this method. If you TRY alone, Exhaust System (Including exhaust manifold) Remove the Extension for Ratchet (1 / 4inch)etc. Insert and center it and you can easily install it. It is because the hole through Shaft becomes shadow of it unless you remove the exhaust manifold.
Although there is no problem in terms of functioning, welding is pretty rough. It is about a good level to say that it is awful.
It is NCSeries, which is cheap, but I feel that Main stand may be equipped with Standard.
View detail
if it is at the time of a Maintenance of the time of an oil change, or a Chain, and the little break of the Touring point -- too -- It is convenient. Pains was taken over , however attachment just for a moment.
if it is at the time of a Maintenance of the time of an oil change, or a Chain, and the little break of the Touring point -- too -- It is convenient.
Pains was taken over
, however attachment just for a moment.
View detail
Now, the thing currently naturally attached to the old Motorcycle is also treated as an Option ... space-saving-izing at the time of parking, Chain tension, and Wheel cleaning -- it is convenient in it being various. If compared with an external article
Now, the thing currently naturally attached to the old Motorcycle is also treated as an Option ... space-saving-izing at the time of parking, Chain tension, and Wheel cleaning -- it is convenient in it being various. If compared with an external article, it is comparatively cheap, and it attaches and there is no loss. View detail