- Home
- Product reviews
- Motorcycle Parts
- Handles & Control Parts
- Bar Ends
- Good, but maybe a little expensive.... (POSH: Middle Weight Bar End)
【POSH】Middle Weight Bar End Review
Fits: HONDA 400X, HONDA CB1000R, HONDA CB1100, HONDA CB1300SB, HONDA CB1300SF, HONDA CB250R, HONDA CB400SB, HONDA CB400SF, HONDA CB650F, HONDA CBR1000RR, HONDA CBR250R, HONDA CBR400R, HONDA CBR600RR, HONDA CBR650F, HONDA DUNK, HONDA NC700S, HONDA NC700X, HONDA NC750S, HONDA NC750X, HONDA NM-4,
Good, but maybe a little expensive.
From the time of delivery. (OEM) The Bar End was floating a bit, and when I asked the dealership, they said it was normal for it to float a bit. So I rode it for a year and a half, but it got looser and looser, and I had to tighten it every time, but finally it came off.
I chose this one because there was no way I was going to go OEM with it, and I didn't have any other choice but to go with this one because I don't think anything too ornate from Motorcycle's styling would look good on me, but the bottom line is that it's pretty good.
Just tighten the bolts to the length of the bolts.
Styling doesn't seem to detract from the overall feel of the vehicle. It's just a product called Middle Weight Bar End, but its weight is OEM (cb1100) It seems to be almost the same as the Bar End of the Bar End, so it's not suitable for vibration control.
In addition, 2011 model cb1100 is not indicated as compatible, but I was able to install it with no problem.
But if I were to raise a bad point on the premise that I'm satisfied, I'd say the price is a little high.
As a side note, I also found out why the OEM Bar End didn't fit properly during installation, so it wasn't the OEM's fault, it was just that the dealership sucked. From what I've seen, I prefer the OEM, so I probably won't have to repeat this product.
Bagus, tapi mungkin sedikit mahal.
Dari waktu pengiriman. (OEM) Bar End sedikit mengambang, dan ketika saya bertanya kepada dealer, mereka mengatakan itu normal untuk mengapung sedikit. Jadi saya mengendarainya selama satu setengah tahun, tetapi semakin longgar, dan saya harus mengencangkannya setiap kali, tetapi akhirnya terlepas.
Saya memilih yang ini karena tidak mungkin saya akan menggunakan OEM dengan itu, dan saya tidak punya pilihan lain selain memilih yang ini karena saya tidak berpikir sesuatu yang terlalu berhias dari gaya Sepeda Motor akan terlihat bagus untuk saya. , tapi intinya cukup bagus.
Cukup kencangkan baut dengan panjang baut.
Styling tampaknya tidak mengurangi keseluruhan nuansa kendaraan. Ini hanya produk yang disebut Middle Weight Bar End, tapi beratnya OEM (cb1100) Tampaknya hampir sama dengan Bar End dari Bar End, jadi tidak cocok untuk kontrol getaran.
Selain itu, model cb1100 2011 tidak diindikasikan sebagai kompatibel, tetapi saya dapat menginstalnya tanpa masalah.
Tetapi jika saya mengajukan poin buruk dengan premis bahwa saya puas, saya akan mengatakan harganya sedikit tinggi.
Sebagai catatan tambahan, saya juga menemukan mengapa OEM Bar End tidak pas selama instalasi, jadi itu bukan kesalahan OEM, hanya saja dealernya payah. Dari apa yang saya lihat, saya lebih suka OEM, jadi saya mungkin tidak perlu mengulangi produk ini.