durable (usu. goods)

After consulting with us, they wanted to replace the old Chain roller on their XR400R as a precautionary measure, so we replaced the Chain roller.

He did not know how long it had been used, but he said he had been using it for years.
A new one was replaced by removing the roller by the front sprocket.
Time is a few minutes.
Inspect the removed Roller. Still good looking! (Bearing is covered with Grease and not damaged by moisture, and there is little scraping of Roller.) Therefore, it was diverted to the Full stroke side.

It took a lot of time and effort on your part.
First, there is little clearance to remove the Roller because it interferes with the Air cleaner case. Therefore, the Sub-frame was shifted to secure the gap with the Air cleaner case.
The roller shaft was rusted due to the paint being scraped off by the resin of the OEM roller, so the bearing roller did not fit easily.
I struggled with rust on the shaft. I was a little concerned about the play in the thrust direction, so I bought a thin washer and a pin for the clamp at Home center.

This should allow for years of mindless good looking.
The photo shows a used Roller, as the new one can be seen in person.
It is covered in Grease and I cleaned it, Red is quite discolored with dirt, but the performance has not deteriorated.

Recommended

tahan lama (usu. barang)

Setelah berkonsultasi dengan kami, mereka ingin mengganti Chain roller lama pada XR400R mereka sebagai tindakan pencegahan, jadi kami mengganti Chain roller.

Dia tidak tahu berapa lama itu telah digunakan, tetapi dia mengatakan dia telah menggunakannya selama bertahun-tahun.
Yang baru diganti dengan melepas roller di sproket depan.
Waktu adalah beberapa menit.
Periksa Roller yang dilepas. Masih tampan! (Bantalan dilapisi dengan Gemuk dan tidak rusak oleh kelembapan, dan ada sedikit goresan pada Roller.) Oleh karena itu, dialihkan ke sisi Langkah Penuh.

Butuh banyak waktu dan usaha dari pihak Anda.
Pertama, ada sedikit celah untuk melepas Roller karena mengganggu casing Air cleaner. Oleh karena itu, Sub-frame digeser untuk mengamankan celah dengan wadah Air cleaner.
Poros rol berkarat karena cat terkikis oleh resin rol OEM, sehingga rol bantalan tidak mudah dipasang.
Saya berjuang dengan karat di poros. Saya sedikit khawatir tentang permainan ke arah dorong, jadi saya membeli mesin cuci tipis dan pin untuk penjepit di Home center.

Ini harus memungkinkan selama bertahun-tahun berpenampilan menarik.
Foto menunjukkan Roller bekas, karena yang baru bisa dilihat langsung.
Dilapisi Grease dan saya bersihkan, Merah agak kotor karena kotoran, tapi performanya tidak menurun.

Direkomendasikan