- Home
- Product reviews
- Motorcycle Parts
- Suspensions / Rearsets / Wheels / Swingarms
- Foot Controls
- Other Step / Back Step Options / Repair Parts
- Customization that no one notices... (GILLES TOOLING: Shift Holder Kit)
【GILLES TOOLING】Shift Holder Kit Review
Fits: HONDA CB 500 F, HONDA CB 500 X, HONDA CB 600 Hornet, HONDA CB 600 Hornet, HONDA CB 600 Hornet, HONDA CB 650 F, HONDA CB 650 F, HONDA CB 650 R Neo Sports Cafe, HONDA CB 900 Hornet, HONDA CBR 1000 RR SP, HONDA CBR 1000 RR-R, HONDA CBR 1000 RR, HONDA CBR 1000 RR, HONDA CBR 1000 RR, HONDA CBR 1000 RR, HONDA CBR 1000 RR, HONDA CBR 500 R, HONDA CBR 600 RR ABS, HONDA CBR 600 RR, HONDA CBR 650 F,
Customization that no one notices
It was installed to make operation a little easier in traffic jams on the commute to work.
The vehicle installed is HONDA400X.
I thought it was because it was imported because it was so expensive. I thought it was because it was imported, but I was convinced that the housing material was titanium alloy gold.
Needle bearings are press-fitted, but since there is no dust seal, there is concern about the entry of garbage and grease.
I think the needle bearing is the same as the NSK model number FWF-142012 in terms of size. (It is made overseas, so it may be slightly different from JIS standard.) If the movement gets worse, I will try to use a lubrication-free Bush instead of a B? Ring.
Installation is easy, but the original Bolt has a lock tie applied, so it is hard to loosen.
Be careful not to drop the removed Bolt on the FrontSprocket side. I dropped it and it was very strange to find it.
I didn't expect it to work, but it does, and the clutch feels very light.
Cons? is that absolutely no one notices (laughs).
Kustomisasi yang tidak diperhatikan oleh siapa pun
Itu dipasang untuk membuat pengoperasian sedikit lebih mudah di tengah kemacetan dalam perjalanan ke tempat kerja.
Kendaraan yang dipasang adalah HONDA400X.
Saya kira karena impor karena harganya mahal. Saya kira karena impor, tapi saya yakin bahan housingnya adalah emas paduan titanium.
Bantalan jarum dilengkapi dengan alat press, namun karena tidak ada penutup debu, ada kekhawatiran akan masuknya sampah dan minyak.
Menurut saya needle bearingnya sama dengan nomor model NSK FWF-142012 dari segi ukuran. (Ini dibuat di luar negeri, jadi mungkin sedikit berbeda dari standar JIS.) Jika mesin jamnya semakin parah, saya akan mencoba menggunakan Bush yang bebas pelumasan daripada yang B? Cincin.
Pemasangannya mudah, namun Baut aslinya sudah dipasang pengikat pengunci, sehingga sulit dilonggarkan.
Hati-hati jangan sampai menjatuhkan Baut yang dilepas pada sisi Sproket Depan. Saya menjatuhkannya dan sangat aneh menemukannya.
Saya tidak berharap ini berhasil, tapi ternyata berhasil, dan koplingnya terasa sangat ringan.
Kontra? adalah bahwa sama sekali tidak ada yang menyadarinya (tertawa).