Reviews
Good!!!!
I bought the High seat because the original Seat was too low, but I am glad I bought the Large seat because I could feel the change. View detail
Fits: HONDA CROSS CUB50, HONDA CROSSCUB110, HONDA CT110 HUNTER CUB125, HONDA SUPER CUB 50, HONDA SUPER CUB110, HONDA SUPER CUB 50PRO, HONDA SUPER CUB110PRO, HONDA SUPER CUB C125, HONDA Dio 110, HONDA LEAD 125, HONDA PCX 125, HONDA PCX 160, HONDA PCX ELECTRIC, HONDA ADV 150, HONDA HORNET250, HONDA HORNET600, HONDA CB 125R, HONDA CB 250R, HONDA CBR 250RR, HONDA CBR 600RR
Easy to hang and wind resistant. Very good.
I use this Repeater on my CT110 HUNTER CUB and GB250 CLUBMAN. It is my favorite.
I bought it last year when I bought a CT110 HUNTER CUB, because I was planning to add a front carrier and a RODCarrier to it. I am sure it will be a good reference for those who are considering purchasing it.
The front carrier is made of DRC, the largest class, and is fixed at the most forward position, so the front of the handlebar is considerably longer than in NORMAL, The height of the LeftFront section of the Rear Carrier is 10cm higher than the Seat. The lower part of the front wheel and Quantity:Pair (for Left and Right) As you can see in the photo, I can close the RearFastener to the very bottom, even with the bottom rope tightened quite a bit. I live in an area that is occasionally exposed to strong winds, and the Seat has never rolled up.
Also, I have been using it for over a year now and it has not deteriorated much. (There is a short period of time when the parking Space is in direct sunlight.) Not much dirt on it. (It has a roof, so it is virtually dry even in the rain.) and I have never washed the surface with water. I am very satisfied.
I bought it for GB250 CLUBMAN almost one year after CT110 HUNTER CUB. It is rather a little bit large, so the front wheel lower part and the quantity of the front wheel are a little bit smaller than the original size.:Pair (for Left and Right) The Adjuster rope at the bottom is fully squeezed. There is still room to spare, but not so much that it will flip up in the wind, so we are not worried at all.
Perhaps if it were exposed to rain and direct sunlight throughout the day, the evaluation of deterioration might change, but I cannot comment on that.
View detail
Matching with Caliper
Purchased a 1/2-inches diameter short lever to replace the front caliper with a Brembo crab caliper.
Piston diameter 32mm in combination with Caliper (hydraulic pressure ratio 6.35) is
No Control at all with stiff Touch.
Piston diameter 34mm in combination with Caliper (hydraulic pressure ratio 7.17) is
Good Controllability, although a little softer than the preferred Touch.
If it were a standard Lever, would the former combination have been acceptable?
View detail
Maintenance.
I have not used it yet but the Bolt on the R1 has rusted so I bought it to replace it.
I would recommend everyone to replace it before this happens because it will make the Brake less effective. LOL!
View detail
Very good.
Installation was easy.
The sound is Slip-on Silencer, so I thought there would be no LARGE difference, but no way. Very good.
No BackFire, etc. and stable ride.
I don't think the vibration has increased.
Fuel economy and RPMs are about the same since it is a city Main.
I think it has increased safety because cyclists and others will recognize that Motorcycle is coming.
I would like to Recommendation to the people who ride on the street.
View detail
for KAWASAKIOil Filter
The exchange was also Smooth.
The price is cheap and helpful.
View detail
Fits: KAWASAKI Ninja 250, KAWASAKI Ninja 400 (2014-)
Cospa strongest
OEMRear Fender was so creepy that I decided to convert it to a Fender Eliminator, because the Kit is cheap, the License Plate looks like it grows directly from the Motorcycle, and there is a Loading Hook. (In Z400, removing the OEMRear Fender means losing the Loading Hook.) The fact that you can use an OEMBlinker is also Gold-friendly.
KIJIMA's description claims that it is for NINJA400 and NINJA2 Helmet50R, and does not mention a single word about my beloved Z400, but this Quantity:I bought this one because I saw some guys on the Internet who installed Set on their Z400, and the back of Z400 is almost the same as the current NINJA400.
The Kit itself is carefully processed and absorbent to the touch. I thought I got my money's worth at this stage. The installation instruction manual is also very detailed and easy to understand. The hardest part of the installation was the removal and installation of the blinker and the coupler of the license lamp, and the porting of the OEMB blinker. I cut off the rubber cover around the Coupler and solved the Blinker by my own efforts. All of them are Kawasaki's fault, not KIJIMA's. Kawasaki designed the blinker with poor maintainability. What is going on with Kawasaki?
The Loading Hook is also very useful and in a very good position. It is a great product that makes me feel like a fool to buy a kit around 20,000 yen for the same purpose when such a great kit is available.
View detail
Fits: DUCATI SCRAMBLERIcon, DUCATI 1299 Panigale., BMW R1200RS, BMW S1000RR, SUZUKI GSX-S1000, SUZUKI GSX-S125, SUZUKI GSX-S750, SUZUKI GSX1000S KATANA, SUZUKI GSX1300R HAYABUSA, SUZUKI GSX1400, SUZUKI GSX250R, SUZUKI ST250E Type, TRIUMPH STREETSCRAMBLER, SUZUKI VANVAN200, SUZUKI BANDIT1250, SUZUKI DL1000 V-STROM1000, SUZUKI DL1000 V-STROM250, SUZUKI GRASS TRACKER BIGBOY, SUZUKI DL1000 V-STROM650, SUZUKI Intruder Classic
Cute.
Pad thickness is just right and cute.
It would be better if it were cheaper.
View detail
Highly satisfied
The OEM exhaust system looked and sounded so bad that we replaced the silencer immediately after taking delivery of the car. I decided to buy the R-11 and R-77S because they are cheaper and I don't want to forget to buy Gasket. (I forgot to buy it) 。
The instruction manual for installation is as helpful as it can be, and although it may require some hang to install the silencer bracket rubber, it is totally doable by DIY. If you can read the translation (please type here) and can't install it after reading this Instruction Manual, I think it's better not to tinker with your own motorcycle.
The sound is also very low pitched, which is what I was looking for, but the idling volume is a bit loud, so you may have to be a little careful around people. The current vehicle inspection system may not help, but at speeds above 70km/h and below 6500rpm, the exhaust sound is overpowered by the wind cutting sound and nothing can be heard.
I changed to this Silencer immediately after delivery, so I don't know if the performance has changed.
View detail
Vibration improvement at high speed
I purchased the Black color and it blends in well with the Grip. Installation was easy. I have not applied Screw lock yet, but I will do so after purchasing it at a later date. I was worried about the other company's HeBeaverWeight, but I am glad I chose this one. I have been driving at high speeds for about 30 minutes and my palms are no longer numb from the vibration at 6000 RPM. I wish I had bought it earlier. View detail
Fits: KAWASAKI D tracker, KAWASAKI KLX250, KAWASAKI Z250 (2013-), KAWASAKI Z250SL, SUZUKI 250SB, KAWASAKI NINJA2 Helmet50RSL, KAWASAKI NINJA2 Helmet50RR, KAWASAKI NINJA250R, KAWASAKI D-TRACKER-X
DRCFront sprocket
It was just the right size. Now I will adjust it with Rear sprocket. View detail
DAYTONA Oil Clean Bolt
Item received.took 4 days to arrived.excellent.very well packed.item is solid.very light than the original bolt.magnet is strong.thank you team WEBIKE..never disappoint.highly recommended to shop. View detail
Lighter than OEM, texture is comparable to OEM, slightly less visible
NINJA400 (2023) I installed it in
The fit is perfectly fine.
It is shorter and lower than OEM and looks better.
Rearward visibility is slightly inferior for this reason, but it can be managed with some adjustments.
(The field of view will be wider, so the result will be toned or slightly harder to see.)
near (near directly behind) Do not do this if you are afraid that it will be difficult to see the
This is for people who have or can have a Habit to make sure they have a good visual check.
So far I don't notice much loosening at high speeds or blurring from vibration.
(OEMs are better in comparison).
View detail
The change in appearance is 80%.
NINJA400 (2023) I installed it in
OEM [Color] From Clear [Color] The Smoke gives a tighter appearance from the front.
The windproof effect on highways and windy days is I think I might have changed, if you ask me." It is a degree.
The texture is slightly cheesier than OEM as it is thinner.
In general, I think it's more than enough if you divide it into fashionable Items.
View detail
For THRUXTONRS
OEM replacement for Triumph is not available, but if the OD and internal Screws match.
Can be installed. Always change Oil and Drain plug Magnet
This product gives me peace of mind when I look at it and worry about all the iron dust.
Overall length is slightly longer than tiger OEM, but no problem for installation.
Expect filtration capacity
View detail
For THRUXTONRS
THRUXTON's Swing Arm is an oval, so this is for Lift.
Since this is the Final edition, I decided to go with Gold.
However, it is used accentually because it gets scratched when it is put to practical use.
View detail
DAYTONA Oil Clean Bolt
Item arrived..as can see,superbe packing since day 1 of my order with webike.product is as advertised.very light and strong magnet.quality good..thank you team webike.. View detail
Good cost performance, OEM same etc. Crimp structure is also safe.
Used to refresh a NORMAL rubber hose that had been used for nearly 40 years since new and had cracks on the surface.
The Crimp is made by NICHIRIN, the same company that makes the OEM Brake hose, and the connection to the banjo section is the same quality as the OEM Crimp.
We purchased this product because it is durable and reliable for long-term use, and it kills two birds with one stone:it also provides a Snap and BrakeTouch as a mesh hose.
Performance is fine.
After installation, the Crimp was not handling well for about a year, and it was pulling tight due to interference with the Cowl Bracket at full lock, but the Crimp did not pull out and the Hose did not break.
In order to reduce in cost and increase reliability, the panjo adapter is fixed and there are only two types of orientation, 90-degree right angle or parallel, for the upper and lower panjos, and only two types of banjo adapter angles, straight or 20 degrees, so you have to choose the type of car to install. The banjo adapter has only two angles, Straight or 20 degrees, so you have to choose the type of car you want to install it on.
View detail
Used for MAJESTY 125 FBrakes custom
The MAJESTY125 and R1-Z have the same 83mm Pitch of the front brake caliper, so I used the R1-Z's caliper and changed the front brake to 4POD to strengthen the brake. So, I wanted to lower the Piston size of MASTER, and I wanted to be able to adjust the lever play by Dial as well as CB1300 Caliper, and I wanted to use a short lever. I also wanted to use short lever, so I replaced it with Nisshin's MASTER.
As expected, the brake has improved in both touch and braking power due to the MASTER's smaller-diameter piston size,
Now I have a performance problem on the Caliper side and want to replace the Caliper with the SumitomoCaliper from TZr250 after 3MA or the Nisshin caliper with 83mmPitch released from TZ125, TZ250 and AdvantageNisshin in the 90's. I'm looking for a new caliper.
View detail
Fits: Others , YAMAHA SEROW250, YAMAHA TMAX500, YAMAHA RZ250R, TRIUMPH TRIDENT 660, YAMAHA MT-09, SUZUKI RF900, SUZUKI GSXS1000F, SUZUKI GSX-S750, SUZUKI GSX1100S KATANA, SUZUKI GSX-S1000, SUZUKI B-KING, SUZUKI GSX-R750, KAWASAKI zephyrχ, KAWASAKI NINJA 1000 (Z1000SX), KAWASAKI ninja250, KAWASAKI ZX-9R, KAWASAKI ZX-6R, KAWASAKI ZEPHYR400χ, KAWASAKI ZRX1200
Great product for the price
Sometimes a backpack is not enough.I use it for daily trips ..After reviewing several different tail bags, the Tanax seemed to be the perfect size.the Trails End bag attached securely and the excess length of the strap ends, tuck away cleanly. It looks well made, and I especially like the fact that the bag keeps it shape when empty.It is waterproof and the fabric is durable.Additional pockets are very functional.really great price, good and quality from many known brands.highly recommend. View detail