Lowdown

After much deliberation, I decided to go with EFFEX and it was the right choice.
Thanks to the fact that it is a little more than two centimeters lower, it will stick with sticky feet. View detail

for KAWASAKIOil Filter

The exchange was also Smooth.
The price is cheap and helpful. View detail

Z900RS used purchased, 4.800 kg, plug replaced

Purchased to replace a plug.
Kawasaki Z900RS cafe
second-hand acquisition
4.800 kg
○ Self-exchange
3 days later, he went to Touring Motorcycle shop.
I'm in good shape.
○Drive yourself home when you deliver the car.
It was Short/Two, but
FeeRing has improved since then.
To all of you...
Highly recommended! (^-^) / View detail

Vibration improvement at high speed

I purchased the Black color and it blends in well with the Grip. Installation was easy. I have not applied Screw lock yet, but I will do so after purchasing it at a later date. I was worried about the other company's HeBeaverWeight, but I am glad I chose this one. I have been driving at high speeds for about 30 minutes and my palms are no longer numb from the vibration at 6000 RPM. I wish I had bought it earlier. View detail

DAYTONA Oil Clean Bolt

Item received.took 4 days to arrived.excellent.very well packed.item is solid.very light than the original bolt.magnet is strong.thank you team WEBIKE..never disappoint.highly recommended to shop. View detail

Front Brake Pads for zzr1400

If it was before, I would use it all the time and it is a Repeat. View detail

For THRUXTONRS

OEM replacement for Triumph is not available, but if the OD and internal Screws match.
Can be installed. Always change Oil and Drain plug Magnet
This product gives me peace of mind when I look at it and worry about all the iron dust.
Overall length is slightly longer than tiger OEM, but no problem for installation.
Expect filtration capacity View detail

Crafting accuracy is not so good

There is a cut-out Sugar Crystal step near the shaft center.
This made me wonder if Large is sturdy enough.
Unlike Front, Rear is honestly not as effective.
I don't know. For this Gold amount, I should have gone with the KMT product for $57,000. View detail

Brembo radial master

SEA BASSRGV250Γ (VJ22A) It is used for
We found a Fluid leak from the OEM Master Cylinder due to deterioration, and were torn between Overhaul, a new NISSIN, or a YamahaOEMbrembo, Get me the best one you can." This is why we chose this product.
The OEMCaliper piston diameter is an opposed 4-pod 30/34mm double disk, but Radial master recommended 17mm or 19mm, but I prefer a firmer touch, so I finally chose 19mm.

The original hose was a Swage line mesh hose, and the handling was different from the OEM hose, so the hose was simply attached with the supplied banjo bolt.
The tank bracket, tank, and hose were purchased separately, and the brake switch was installed using the Emon Flat Terminal instead of the Bullet Type Terminal, which came with the brembo wiring, because we did not want to change the OEM wiring. The brake switch was installed using Emon's Flat Terminal instead of the Bullet Type Terminal.

I was worried about interference with the cowl when installing the tank, but there was no problem, although the clearance was about 5mm when the handlebar was fully cut.
Air venting is very easy because of the Bleeder Bolt on the MASTER side.

As for the key performance, even my insensitive self could feel that BrakeTouch was improved over OEM.
I am not sure if this level of specifications is necessary for touring on public roads. (Lol)
However, my impression is that it is a little harder than I expected.
It's not a Level that has problems of course, and even at 19mm, it's definitely significantly better than the OEM Master Cylinder. (OEMTokico) And I think there is also the issue of compatibility with
I have not tried it, so I can only imagine, but I think 17mm would be fine.
The lever is also infinitely adjustable, so you can grip it from your best position.

Finally, as for the appearance, it is very beautiful, but it is too beautiful for old cars and floats a bit. (Lol)
It was a bit expensive, but I felt the price was well worth it. View detail

Well-designed Rear suspension will be protected from dirt.

It seems to protect Rear suspension from dirt with good design.
Because of the tie band fixation, some adjustment may be possible when wearing. View detail

The design and shape are good, but the gap for the tank pad is unavoidable.

The design and shape are good, but the gap for the tank pad is unavoidable. Although I purchased the product with an understanding of this gap, it bothers me a little. View detail

Easy to install and good to see.

It is a simple device and looks good. The bonding strength was increased by using double-sided tape to add strength. View detail

320ization

Most of brembo's semi floats are rigid, so the fee rings are
It's bad, so I'm using Full floating.
Wear on the float area can be corrected with a very small amount of Bell HammerMETALGrease.
It can be eliminated, but if you put too much on, centrifugal force will cause the grease to break off in 20 places.
It is not a maintenance Tune suitable for amateurs in spreading, etc.
If you fail, you will die, so as a rule, don't do it. View detail

DAYTONA Oil Clean Bolt

Item arrived..as can see,superbe packing since day 1 of my order with webike.product is as advertised.very light and strong magnet.quality good..thank you team webike.. View detail

Satisfied with Simple Design

One month has passed since the product was installed, and the height is definitely 4 cm higher than that of the OEMScreen, and I am satisfied with the simple design that does not give the impression that it is just for show. However, the OEMScreen has a step between the cowl and the screen, so there is no difference between the screen and the cowl, but this product has no step between the cowl and the screen, so there is a difference between the cowl and the screen. In addition, the product has a quantity of Screen mounting screws.:Since it is not set, the Screen mounting Screw must be ported from OEMScreen or prepared separately. View detail

Material:The twill weave pattern peculiar to Carbon products is very beautiful! NEXRAY is indeed the best.

The twill weave pattern is very beautiful Coating. Moreover, it is a NEXRAY product. The product is highly accurate, and there was no distortion or modification of the screw installation position like other companies. View detail

Purchased for a 12 year MODEL ninja 1000

This is the first time I have used this Drain Washer.
I used to use Drain Washer purchased from Motorcycle shop, but I bought it because I ran out of stock.
I don't think it's a problem since it's OEM, but just to be sure, check the area around the Drain Washer after test run after replacing the Oil.
It didn't leak, so it's Large sturdy.
OEMs are secure. View detail

PetitCustom

PetitCustom by Exactly for One Point's color insert!
I installed it as a trial before putting brembo in.
4miniCustom standard color! View detail

Standard PetitCustom

For Caliper's color insert!
Trial installation before putting brembo in.

4mini standard color:?? View detail

Small

I bought it for my BMW R1150GS because it fits VST 1050, but it is smaller than I expected. I bought it knowing that it would not fit over the SIDEPannier, but I did not expect that it would not fit over the Top case either. The storage is compact. View detail