Easy to hang and wind resistant. Very good.

I use this Repeater on my CT110 HUNTER CUB and GB250 CLUBMAN. It is my favorite.
I bought it last year when I bought a CT110 HUNTER CUB, because I was planning to add a front carrier and a RODCarrier to it. I am sure it will be a good reference for those who are considering purchasing it.
The front carrier is made of DRC, the largest class, and is fixed at the most forward position, so the front of the handlebar is considerably longer than in NORMAL, The height of the LeftFront section of the Rear Carrier is 10cm higher than the Seat. The lower part of the front wheel and Quantity:Pair (for Left and Right) As you can see in the photo, I can close the RearFastener to the very bottom, even with the bottom rope tightened quite a bit. I live in an area that is occasionally exposed to strong winds, and the Seat has never rolled up.
Also, I have been using it for over a year now and it has not deteriorated much. (There is a short period of time when the parking Space is in direct sunlight.) Not much dirt on it. (It has a roof, so it is virtually dry even in the rain.) and I have never washed the surface with water. I am very satisfied.
I bought it for GB250 CLUBMAN almost one year after CT110 HUNTER CUB. It is rather a little bit large, so the front wheel lower part and the quantity of the front wheel are a little bit smaller than the original size.:Pair (for Left and Right) The Adjuster rope at the bottom is fully squeezed. There is still room to spare, but not so much that it will flip up in the wind, so we are not worried at all.

Perhaps if it were exposed to rain and direct sunlight throughout the day, the evaluation of deterioration might change, but I cannot comment on that. View detail

If it is a single cylinder, it is very effective Large!

Fuel economy will also increase.
Power also goes up.
Life gets better, too.

Is there anything cheaper and more effective Large?
The effect is particularly large for single cylinders.
Installation on CUB110. View detail

I bought it as a Stock, but I replaced it as soon as possible and it works great!

I purchased it for Stock on April 6 and it was promptly replaced.
Even after replacing the battery, the cell was weak and rarely restarted from idle ring stop, so I checked the Fuse and found that the Fuse had not run out, so I checked the Plug and found that it was covered.
After the replacement, the cell runs well, and the car no longer has trouble restarting from idle ring stop.
It has about 13,000 km since I last replaced it with the same one, and I was hoping it would last a little longer, but the price is low, so it's a good thing. View detail

Size is Exactly

The Size is Exactly and does not flap. It withstood a typhoon by tying up. It is also easy to lock.
Consumables, so they need to be replaced regularly. View detail

PetitCustom

PetitCustom by Exactly for One Point's color insert!
I installed it as a trial before putting brembo in.
4miniCustom standard color! View detail

Standard PetitCustom

For Caliper's color insert!
Trial installation before putting brembo in.

4mini standard color:?? View detail

Exhaust system is changed so intake air is also changed.

Installation was easy and two types of filters were included to match the Engine's TuningStyle. View detail

Advantages of Maintenance

I have been using DX since its release. I don't mind maintenance, but sometimes I get tired of doing it when I'm busy with the weather, so it's nice to have less frequent replacements. Fuel consumption and running performance do not change drastically. View detail

Purchased for PCX150KF30 for Stock

Purchased as Stock because it has traveled 13,000 km since the last replacement.
Denso has no choice as only DXPlug is compatible.
I have replaced it with this plug last time and Idlingetc. is stable without any problem. View detail

Somehow.

It's just a replacement, because I can replace it with 3 Screws. View detail

Unfortunately, it didn't fit.

I purchased this product as a BirdCity155 compatible product, but it was necessary to modify the product in order to install the Left Side.
Unfortunately, we had to deal with a return, but the response was excellent. View detail

Effective in rainy weather and midsummer

[How is it used?
In use on NMAX 155.
When I ride in the rain, the seating surface gets very wet, so a friend of mine recommended that I purchase one.

Was the installation difficult?
It's very simple
Simply follow the instructions in the Instruction Manual to cover the Seat and fasten the back of the Seat with Magic tape.
The markings are also provided so that the front and back will not be installed backwards.

How was your experience with it?
I got lucky (?) the day after I installed it. It was a rainy day, but it worked!
The ride was comfortable with no uncomfortable wetting of the seating surfaces.
The improved ventilation will also reduce the heat of the Seat in mid-summer, which we will experience a little later in the year.
There is no movement of the mesh cover during driving, which is good.

[Was there anything that disappointed you?
It's not a disappointment, but I can't wipe the Seat without removing it each time, so it looks like it will get dirty inside if left unattended to some extent.
Perhaps due to the Belt fastening at the back of the Seat, closing the Seat now requires more force than before. View detail

Cheap but good product

I purchased it as a replacement for the genuine Benley 110. You can't feel any difference.
Although it is cheap, I think it is a really good product.
I replace it every 10,000 km, but I think the replacement cycle could be longer.
I plan to continue using it.
-------------------------------------------------- -------- I purchased it as a replacement for the genuine Benley 110. You can't feel any difference. Although it is cheap, I think it is a really good product. I replace it every 10,000 km, but I think the replacement cycle could be longer. I plan to continue using it. Powered by Google Translator View detail

XG250 TRICKER

I use it on my XG250 TRICKER.

The Motorcycle Cover is a consumable item, so this thickness is sufficient for this price. View detail

Good looking!

The OEM filler cap on my CB400SF had deteriorated and was not looking good, so I replaced it.
I purchased this product because the Ditona product was good in terms of Cost. Installation was a simple task of removing and replacing the OEM, but I was a little concerned about the ORing being a little loose, but there are no oil leaks, so I think it is a good idea. View detail

I think it is necessary and sufficient.

This is just my personal opinion, but I think it is not a PeLePera, and considering the price, I think it is satisfactory enough. View detail

Replaced with AJ59SUPER CUB110 Iridium plugs

To be honest, I don't know much about the effect of replacing it. 100% of the vehicles I have purchased so far have Windshield IRIDIUM in them.

I only feel that the Engine is working better, but that's OK, it's a world of self-satisfaction. View detail

not bad

It takes a lot of time and effort to replace them, but I think it's good to feel a reasonable change.
There was an increase in vibration during Idling, but I didn't mind it so much myself. View detail

Reliable Braking Power

[How is it used?
It is installed on a NMAX 155.
I bought a used car and replaced it with a Timing with a total mileage of over 10,000 km.
Since this is my first Pad replacement, I have not been able to compare it with other Other Brand Products.

How was your experience with it?
The Pad at the time of purchase of the vehicle is probably from Standard Equipment, but it is a more stable braking force than that.
It is very important to be able to stop safely as it is a commuter vehicle that we ride every day.
However, there is no sense that it is dangerous to stop too much, but only that it is safe to stop strongly, which is very good for Fee Rings.
The other part is how much Life is, but that will be discussed later, as it hasn't been that long since the replacement. View detail

Why?

I am disappointed that there are no products. I wonder if the year determines whether they are in stock or not. View detail