Reviews
Fits: HONDA CROSS CUB50, HONDA CROSSCUB110, HONDA CT110 HUNTER CUB125, HONDA SUPER CUB 50, HONDA SUPER CUB110, HONDA SUPER CUB 50PRO, HONDA SUPER CUB110PRO, HONDA SUPER CUB C125, HONDA Dio 110, HONDA LEAD 125, HONDA PCX 125, HONDA PCX 160, HONDA PCX ELECTRIC, HONDA ADV 150, HONDA HORNET250, HONDA HORNET600, HONDA CB 125R, HONDA CB 250R, HONDA CBR 250RR, HONDA CBR 600RR
Easy to hang and wind resistant. Very good.
I use this Repeater on my CT110 HUNTER CUB and GB250 CLUBMAN. It is my favorite.
I bought it last year when I bought a CT110 HUNTER CUB, because I was planning to add a front carrier and a RODCarrier to it. I am sure it will be a good reference for those who are considering purchasing it.
The front carrier is made of DRC, the largest class, and is fixed at the most forward position, so the front of the handlebar is considerably longer than in NORMAL, The height of the LeftFront section of the Rear Carrier is 10cm higher than the Seat. The lower part of the front wheel and Quantity:Pair (for Left and Right) As you can see in the photo, I can close the RearFastener to the very bottom, even with the bottom rope tightened quite a bit. I live in an area that is occasionally exposed to strong winds, and the Seat has never rolled up.
Also, I have been using it for over a year now and it has not deteriorated much. (There is a short period of time when the parking Space is in direct sunlight.) Not much dirt on it. (It has a roof, so it is virtually dry even in the rain.) and I have never washed the surface with water. I am very satisfied.
I bought it for GB250 CLUBMAN almost one year after CT110 HUNTER CUB. It is rather a little bit large, so the front wheel lower part and the quantity of the front wheel are a little bit smaller than the original size.:Pair (for Left and Right) The Adjuster rope at the bottom is fully squeezed. There is still room to spare, but not so much that it will flip up in the wind, so we are not worried at all.
Perhaps if it were exposed to rain and direct sunlight throughout the day, the evaluation of deterioration might change, but I cannot comment on that.
View detail
Maintenance.
I have not used it yet but the Bolt on the R1 has rusted so I bought it to replace it.
I would recommend everyone to replace it before this happens because it will make the Brake less effective. LOL!
View detail
For CB250F
I searched for this in my country DUST SEAL (22X42X7) (ARAI) 91252-MC7-003 but I can't find it. Finally I bought it from webike. It is genuine. Very good packaging. Thanks to the webike team. View detail
Size is Exactly
The Size is Exactly and does not flap. It withstood a typhoon by tying up. It is also easy to lock.
Consumables, so they need to be replaced regularly.
View detail
Fits: DUCATI SCRAMBLERIcon, DUCATI 1299 Panigale., BMW R1200RS, BMW S1000RR, SUZUKI GSX-S1000, SUZUKI GSX-S125, SUZUKI GSX-S750, SUZUKI GSX1000S KATANA, SUZUKI GSX1300R HAYABUSA, SUZUKI GSX1400, SUZUKI GSX250R, SUZUKI ST250E Type, TRIUMPH STREETSCRAMBLER, SUZUKI VANVAN200, SUZUKI BANDIT1250, SUZUKI DL1000 V-STROM1000, SUZUKI DL1000 V-STROM250, SUZUKI GRASS TRACKER BIGBOY, SUZUKI DL1000 V-STROM650, SUZUKI Intruder Classic
Cute.
Pad thickness is just right and cute.
It would be better if it were cheaper.
View detail
For CB250F
really genuine product. Finally I bought it from webike. It is genuine. Very good packaging. Thanks to the webike team. View detail
Fits: HONDA CB1100R, HONDA STEED600, HONDA Gold Wing, HONDA VALKYRIE, HONDA CB1300P, HONDA VT250Z, HONDA V-TWIN MAGNA, HONDA VT250 SPADA, HONDA VT250F, HONDA XELVIS, HONDA VTZ250, HONDA Steed400, HONDA RVF400R, HONDA VF400F, HONDA VF400F INTEGRA, HONDA VFR400R, HONDA VFR400Z, HONDA Shadow VLX, HONDA Interceptor, HONDA MAGNA
It is a good product for Choi Custom.
OEM is Material:Plastic and cheap-looking, so I replaced it. Simply Material:The aluminum finish is not aluminum, but a satin-like high quality finish like titanium, so it feels massive for its weight and is very satisfying to look at.
It is Material that is the cautionary tale.:Since the cap is not plastic, it is safe not to touch the cap when the Engine is hot after a stop due to high thermal conductivity. Turn the cap after the engine has cooled down to a certain degree. You may get a slight burn.
OEM is Material:I understand that it is Plastic.
View detail
For CB250F
good quality and great deal from Webike, super fast international shipping, very well packaged and a reasonable price, thanks Webike team great! View detail
It was replaced under warranty.
The other day, I was told that Quantity:Pair (for Left and Right) The footpegRubber on my LARGE footpeg came off and was under warranty. I received a new footpeg and replaced it. Thank you very much. View detail
For CB250F
Same as the genuine Front Fork Oil Seal Set . About shipping and packaging Very good packaging.Fast shipping no way to dammage. About quality and texture Products to buy together realy genuine product. good qulity.Thanks to the webike team View detail
For CB250F
Same as the genuine Rubber Footpeg . About shipping and packaging Very good packaging.Fast shipping no way to dammage. About quality and texture Products to buy together realy genuine product. good qulity View detail
For CB250F
good quality Oil Filter and great deal from Webike, super fast international shipping, very well packaged and a reasonable price, thanks Webike team great! View detail
Recommended for Gymkhana and police training sessions
It is stuck in the speed range of the Gymkhana and police training sessions. It is also easy to ride in town.
I continue to use the same product, replaced at 15,538 km.
View detail
Directly attached to Ignition coil
As others have said, 250tr has a shorter original IgnitionCable, so I made it the same length and attached it directly.
The cable diameter is thick, so it was installed while shaving it with a cutter as appropriate. This was quite a difficult task.
After installation, I feel a little more power up.
Dress-up can be effective by showing a glimpse of the Yellow-colored Cable.
View detail
![[Short Lever] Brake Master Cylinder Kit [Horizontal Type 11mm/Tank Separate Body Type]](https://img.webike-cdn.net/catalogue/images/105373/26854_TS.jpg)
Replace instead of overhaul 20 year old OEM
The MAJESTY 250 OEM Master Cylinder is 20 years old, the paint is peeling, the fluid level window is white and cloudy, and the touch screen is dead. I thought that if I replaced it with OEM, it would be in the same condition again someday, so I replaced it with this one, which has better accuracy and quality.
The original vehicle had some customization done to the exterior, and the replaced handlebars gave it a more custom look.
I am satisfied that the color of the handlebar matches the color of the MASTER and Lever, creating a sense of unity.
Unlike the OEM, the 6-step lever play adjustment is also highly satisfactory.
Also, we are happy to be able to strengthen the brake with the SKULL Helmet principle by lowering the diameter by 1 Size to 11mm, compared to the OEM MASTERPiston diameter of 1/2-inches.
The brake hoses were stainless steel mesh when they were installed, so we did not have to worry about a large increase in stroke volume, and both control and braking power were improved, resulting in a highly satisfactory brake customization.
View detail
Fits: Others , YAMAHA SEROW250, YAMAHA TMAX500, YAMAHA RZ250R, TRIUMPH TRIDENT 660, YAMAHA MT-09, SUZUKI RF900, SUZUKI GSXS1000F, SUZUKI GSX-S750, SUZUKI GSX1100S KATANA, SUZUKI GSX-S1000, SUZUKI B-KING, SUZUKI GSX-R750, KAWASAKI zephyrχ, KAWASAKI NINJA 1000 (Z1000SX), KAWASAKI ninja250, KAWASAKI ZX-9R, KAWASAKI ZX-6R, KAWASAKI ZEPHYR400χ, KAWASAKI ZRX1200
Great product for the price
Sometimes a backpack is not enough.I use it for daily trips ..After reviewing several different tail bags, the Tanax seemed to be the perfect size.the Trails End bag attached securely and the excess length of the strap ends, tuck away cleanly. It looks well made, and I especially like the fact that the bag keeps it shape when empty.It is waterproof and the fabric is durable.Additional pockets are very functional.really great price, good and quality from many known brands.highly recommend. View detail
A little short, a little thick
I installed it on a ZrX1200ZrX1200 DAEG and it was a little short in overall length.
I think 125mm is just right. i bought some Sponge from Home center and filled the gap.
The thickness is about 33mm compared to about 30mm for OEM. It is just right for me. It may be too thick for some people.
View detail
PetitCustom
PetitCustom by Exactly for One Point's color insert!
I installed it as a trial before putting brembo in.
4miniCustom standard color!
View detail
Standard PetitCustom
For Caliper's color insert!
Trial installation before putting brembo in.
4mini standard color:??
View detail
Manufacturer Warranty
Less than a year after purchase, Rubber is Quantitative:Pair (for Left and Right) Both peeled off.
This is what happens, isn't it?
Contacted Webbig Customer because it was a Manufacturer warranty or 1 year.
We are pleased to announce that we have received the Manufacturer Guarantee.
I have purchased many different Parts, but this is the first time I have had a Manufacturer's Warranty.
If you purchase Parts with a Manufacturer's Warranty, you should keep the Manufacturer's Warranty and the delivery note.
View detail