Reviews
1P2014
The head lamp on my Honda Little Cub burned out. I liked the price and parameters of this lamp (not much power does not overheat the cartridge). Everything turned out to be good in quality, the lamp works perfectly. View detail
Just receive item
Second time order from webike..the quality of packaging still tip top for me with the bubble plastic and so on..well order again in future..thank you View detail
Advantages of Maintenance
I have been using DX since its release. I don't mind maintenance, but sometimes I get tired of doing it when I'm busy with the weather, so it's nice to have less frequent replacements. Fuel consumption and running performance do not change drastically. View detail
Easy installation, no brightness problems.
Until now, we had been using Type with LEDs affixed at the top and bottom, but the straightness of the LEDs was poor when Up is lit, so we always used the LEDs facing down.
This type of LEDs are affixed in the LeftRight type, so the straightness when the LEDs are up is also OK. This time, I installed it on a square eye light, but I think it would be best for a round eye light. Finally, I am satisfied with the brightness.
View detail
The weight of the description does not Ate.
OEM 3-type for horizontal JOG (480g) I bought it for the weight Up rather than the
The description gives a weight of 515g, but the actual measurement is only 496g.
OEMs usually increase or decrease by about 5g because of balance shaving, etc,
I could not think of writing an imprementation that I would recommend to others if the Cut-out Outer had an error of almost 20g!
[Regarding installation].
50cc horizontal JOG (3KJ/5AUCase before regulation, 5BM/5SUCase after regulation)
Case cover Gasket is required.
However, the shaft part is thicker than OEM, so when you stop the Nut, insert the O-ring, and try to close the Cover.
The gap with Bearing on the Cover will be insufficient.
So we need to take measures such as thinning the O-ring
・3WF
There's plenty of room to spare. o-ring should be as thin as the 50 story?
You can replace the Nut that stops the Outer with a thin Nut for 50cc
View detail
The size is just right and the texture is good.
Used in 2008 YZF-R1.
LengthSize is also really Exactly.
I did not originally intend to use parts cleaner, but I was able to get in without any difficulty without using Bond paint parts cleaner.
View detail
Fits: HONDA DIOSR, HONDA DIO, HONDA TACT BASIC, HONDA ZOOMER, HONDA SMART・DIO Z4, HONDA SMART・DIO, HONDA STAND-UP TACT, HONDA SUPER DIOZX, HONDA SUPER CUB 90, HONDA SUPER CUB70, HONDA SUPER CUB 50, HONDA SUPER CUB110, HONDA GORILLA, HONDA CREA SCOOPY, HONDA QR50, HONDA BAJA, HONDA TODAY, HONDA TODAY DELUXE, HONDA CUB PRESS, HONDA MONKEY
No Impossible part
There is no part that is not possible as a Body Cover. View detail
WhiteLight and good looking!
It's super easy because all you have to do is change the Valve.
I was able to purchase Valve's length and fit without concern because of the information provided by its predecessors.
D-TRACKER-X's dark, orange-tinged light has been brightened to white.
I haven't driven at night yet, so I haven't been able to experience the true effect, but the impression of the motorcycle will change considerably just by having white light.
View detail
Punching in as is
As per Title, it can be popped on as is.
Visibility from other vehicles, such as oncoming traffic, has increased, so I think safety performance has improved.
I don't know about durability so far.
View detail
Kitaco Belt variator
The delivery was successful, but the packaging was damaged, there was an incision on the package, but in general everything is fine. The CVT belt is hard of good quality and goes to the very top. I recommend View detail
Bright and low power consumption
I was worried about whether I could install it on my KSR2 since the body is longer, but I saw the impressions of someone who had already installed it on his KSR and he said it could be installed, so I bought it and installed it.
The length was a limit, but I was able to install it, the Others had no problems with the installation, and the rubber cover went on without modification.
The beam coverage has been widened. The optical axis remains the same and is large and sturdy. The high beam illuminates high up and is even brighter, so you have to be careful of oncoming cars.
I also changed the tail lamp to LED, so the power consumption was reduced a lot. I installed the LeftSwitch of the previous model in my car, so I can switch from LightOff to Light when Halogen is on.
Idling dropped about 200 RPM when switched to On, but switching from LightOn to LightOff when LED has no effect on Idling.
View detail
Kitaco 63cc
The packaging and delivery completely satisfies me, after the kit contains all the information for installing the manual and gaskets. After installation, the dynamics on the rise appeared noticeably. I recommend this kit View detail
Fits: YAMAHA JOG (CY50D), YAMAHA JOG (CY50E), YAMAHA JOG (CY50F), YAMAHA JOG (CY50G), YAMAHA JOG (CY50H), YAMAHA JOG (CY50J), YAMAHA JOG (CY50K), YAMAHA JOG (CY50L), YAMAHA JOG (CY50M), YAMAHA RAZZ (SH50A), YAMAHA RAZZ (SH50B), YAMAHA RAZZ (SH50D), YAMAHA RAZZ (SH50E), YAMAHA RAZZ (SH50F), YAMAHA RAZZ (SH50G), YAMAHA RAZZ (SH50H), YAMAHA RAZZ (SH50J), YAMAHA RAZZ (SH50K), YAMAHA RAZZ (SH50L), YAMAHA RAZZ (SH50M)
TZr50R 4EUEngine Oil pump Breather BoltGasket
[How is it used?
Used for EngineO/H of YAMAHA/TZr50R.
This item is Oil pump's Breather BoltGasket.
If this Gasket is damaged, 2ndOil may ooze out of the Oil pump.
Although there was no leakage during the O/H this time, it was replaced as a preventive measure.
How was your experience with it?
OEM parts are the only choice for engine parts. There is no problem with quality.
When bleeding air from 2ndOil, loosen this bolt to bleed air.
How did it compare to other products?
There is no Other Brand Product, so there is no comparison. Even if there were, OEM would be the only choice.
[Points to note]
Not particularly
View detail
Cheap but good product
I purchased it as a replacement for the genuine Benley 110. You can't feel any difference.
Although it is cheap, I think it is a really good product.
I replace it every 10,000 km, but I think the replacement cycle could be longer.
I plan to continue using it.
-------------------------------------------------- -------- I purchased it as a replacement for the genuine Benley 110. You can't feel any difference. Although it is cheap, I think it is a really good product. I replace it every 10,000 km, but I think the replacement cycle could be longer. I plan to continue using it. Powered by Google Translator
View detail
Fits: YAMAHA YSR50, YAMAHA TDR50, YAMAHA Axis, YAMAHA JOG Zr, YAMAHA TZR50, YAMAHA TZR250, YAMAHA TZM50, YAMAHA TW200, YAMAHA SR500, YAMAHA SR400, YAMAHA RZ125, YAMAHA RZ50, YAMAHA SDR, YAMAHA RD50, YAMAHA GT50, YAMAHA GT80, YAMAHA JOG, KAWASAKI KS-2, YAMAHA BW's, KAWASAKI KS-1
Slightly modified
Used for TW200 (2JL)
The coils were not in good shape during the restoration, so, well, it's an old bike, and I had to replace them.
The compatibility chart said it would work, but to be honest, it wasn't exactly a poncho.
I had to shave the edges of the plastic on the body, shave off the part where the frame meets the plastic, and sweat.
Maybe it's just my TW, but I managed to get it to work.
Performance Quality is fine.
View detail
It's perfectly normal
I used it on my MAJESTY125
The MotorcycleBROS specification table lists a different Plug, but this is the correct one, so please be careful if you are buying!
It is a Normal plug, so it is quite normal, but since it is NGK, it is still very safe.
I'm going to Repeat it again.
View detail
Fits: SUZUKI ADDRESS V50, YAMAHA Remote controller jog, YAMAHA TOWN MATE80, YAMAHA MATE NEWS 50, YAMAHA JOG TRUNKSpec., YAMAHA SUPER JOGZ, YAMAHA MATE, YAMAHA JOG SPORTS90, YAMAHA JOGSporty, YAMAHA JOG Z, YAMAHA YV50 Z II, YAMAHA JOG Zr, YAMAHA AxisTrunkSpec., YAMAHA JOG, YAMAHA Vino, YAMAHA YB50, YAMAHA Axis, YAMAHA PW50, YAMAHA V80MATE50, YAMAHA V80MATE80
Very good for occasional motorcycle rides!
Purchased for an old CUB that I might ride once a month or so.
S Size was the perfect size.
The fabric is thick and flap resistant, and the waterproof property is very solid.
The inside is also soft material and gently wraps the body of the car. Considering the quality, the price is very reasonable.
Because of its weight, it cannot be applied quickly and easily, so it may be a hassle to put it on and take it off every day when you commute on your motorcycle.
This product was very Exactly for my needs for a vehicle that is only ridden occasionally. I am planning to buy one for my other motorcycle that I ride only once in a while.
View detail
I put it on my RG 50Gamma.
It's just like changing a light bulb.
There is no problem
View detail
Replaced with AJ59SUPER CUB110 Iridium plugs
To be honest, I don't know much about the effect of replacing it. 100% of the vehicles I have purchased so far have Windshield IRIDIUM in them.
I only feel that the Engine is working better, but that's OK, it's a world of self-satisfaction.
View detail
Cool grips
I bought these beautiful grips again - this time to replace them with a Honda Super Cub.
The handles are of excellent quality and are not expensive and fit perfectly. The replacement took a little time.
I bought these beautiful handles again - now to replace them with a Honda Super Cub.
The handles are of excellent quality and are not expensive and fit perfectly. The replacement took a little time. -------------------------------------------------- -------- I bought these beautiful handles again - now to replace with Honda Super Cub. Handles of excellent quality and are not expensive and are perfect. The replacement took a little time. I BUGHT Th, Beautiful Handles AGain - Now To Replace them with a Honda Super Cub. The Handles are of Excellent Quality and ARE NOT Expensive and Fit Perfectly. The Replacement took a Little Time. Powered by Google Translator
View detail