Reviews
Good product
Fits kawasaki w800 Improved the sponginess feeling Arrived well without any problem with customs Good service Highly recommended View detail
1P2014
The head lamp on my Honda Little Cub burned out. I liked the price and parameters of this lamp (not much power does not overheat the cartridge). Everything turned out to be good in quality, the lamp works perfectly. View detail
Easy installation, no brightness problems.
Until now, we had been using Type with LEDs affixed at the top and bottom, but the straightness of the LEDs was poor when Up is lit, so we always used the LEDs facing down.
This type of LEDs are affixed in the LeftRight type, so the straightness when the LEDs are up is also OK. This time, I installed it on a square eye light, but I think it would be best for a round eye light. Finally, I am satisfied with the brightness.
View detail
It was EXACTLY!
I purchased this to replace an OEM Oil cap groove that was broken.
It was Exactly in JA10!
View detail
As expected of DAYTONA
Was the installation difficult?
pimping
How was your experience with it?
It's going to look different
View detail
Fits: HONDA CBX125F, HONDA NSR250R, HONDA CBR250R, HONDA VFR400R, HONDA Integra, HONDA CBR400R, HONDA SUPER BOLDOR, HONDA CBR300R, HONDA RVF400, HONDA CB400SB, YAMAHA TZM50R, YAMAHA YZF-R125, YAMAHA TZR250, YAMAHA YZF-R15, YAMAHA YZF-R25, YAMAHA FAZER, YAMAHA FZR400RR, YAMAHA YZF-R3, YAMAHA YZF-R6, YAMAHA XJ6
First MirrorBlinker installation
I put it on a yzf-25r early model.
Screw holes don't meet at all, so I have to rebuild them.
It must not be done. It is absolutely impossible for an amateur.
View detail
Dress-up in a casual way
It can be dressed up casually.
I am satisfied with the quality of the product.
It would be better if it were a little cheaper.
View detail
The oil filler cap is very convenient to use and decorate
Daytona brand is a famous brand in the production of spare parts for motorbikes from engines to decorations. In particular, the product set of oil cap, reservoir cap and bar ends comes from Daytona premium, I feel the quality is improved compared to normal Daytona. With this set of oil caps, compared to the original cap, I find that it is not only used for decoration with many colors to choose from, but also can be easily opened and closed to make changing the oil easier. With a normal OEM oil cap, I usually spend about 2 to 3 minutes opening and closing the oil cap. With the Daytona oil cap, it only takes 30 seconds to do that. View detail
Brake Pads for Street Riding
I purchased and installed these Brake Pads for my Ninja 250SL for urban driving (commuting). The cost performance is unquestionably good, but it is still a bit expensive. "Red Pad. Compared to the OEM Brake Pads, the Brake Pads are more controllable and cost-effective, so we recommend these Brake Pads to Mainers who drive in the city. View detail
WhiteLight and good looking!
It's super easy because all you have to do is change the Valve.
I was able to purchase Valve's length and fit without concern because of the information provided by its predecessors.
D-TRACKER-X's dark, orange-tinged light has been brightened to white.
I haven't driven at night yet, so I haven't been able to experience the true effect, but the impression of the motorcycle will change considerably just by having white light.
View detail
Bright and low power consumption
I was worried about whether I could install it on my KSR2 since the body is longer, but I saw the impressions of someone who had already installed it on his KSR and he said it could be installed, so I bought it and installed it.
The length was a limit, but I was able to install it, the Others had no problems with the installation, and the rubber cover went on without modification.
The beam coverage has been widened. The optical axis remains the same and is large and sturdy. The high beam illuminates high up and is even brighter, so you have to be careful of oncoming cars.
I also changed the tail lamp to LED, so the power consumption was reduced a lot. I installed the LeftSwitch of the previous model in my car, so I can switch from LightOff to Light when Halogen is on.
Idling dropped about 200 RPM when switched to On, but switching from LightOn to LightOff when LED has no effect on Idling.
View detail
Safe and Secure OEM Parts
[How is it used?
Used for EngineO/H of YAMAHA/TZr50R.
This item is an oil seal for Counter Shaft.
When this Seal is removed, oil leaks into the Alternator side.
Although there was no leakage during the O/H this time, it was replaced as a preventive measure.
How was your experience with it?
OEM Parts is the only choice for Engine parts.
There is no problem with the quality. It is press-fitted, so it requires a hang to pull it out. In my case, I lightly drilled a hole with a drill, screwed in the bolt, and pulled it out with pliers.
When hammering, the amount of hammering was carefully measured with Caliper using Socket.
How did it compare to other products?
There is no Other Brand Product, so there is no comparison. Even if there were, OEM would be the only choice.
[Points to note]
Be careful not to hit too hard or too supple.
If it doesn't leak, it doesn't matter...
View detail
O-ring of TZr50R 4EUEngine Oil pump
[How is it used?
Used for EngineO/H of YAMAHA/TZr50R.
This product is an Oil pump O-ring.
If this O-ring becomes ruptured, 2ndOil may enter the GEAR side.
Although there was no leakage during the O/H this time, it was replaced as a preventive measure.
I am glad I replaced the old O-rings because the stones were getting hard.
How was your experience with it?
OEM parts are the only choice for engine parts. There is no problem with quality.
How did it compare to other products?
There is no Other Brand Product, so there is no comparison. Even if there were, OEM would be the only choice.
[Points to note]
The O-rings were greased up before installation, being careful not to twist them during installation.
View detail
Oil Filler Cap
Changed to Green Light or Gold. View detail
Fits: YAMAHA YSR50, YAMAHA TDR50, YAMAHA Axis, YAMAHA JOG Zr, YAMAHA TZR50, YAMAHA TZR250, YAMAHA TZM50, YAMAHA TW200, YAMAHA SR500, YAMAHA SR400, YAMAHA RZ125, YAMAHA RZ50, YAMAHA SDR, YAMAHA RD50, YAMAHA GT50, YAMAHA GT80, YAMAHA JOG, KAWASAKI KS-2, YAMAHA BW's, KAWASAKI KS-1
Slightly modified
Used for TW200 (2JL)
The coils were not in good shape during the restoration, so, well, it's an old bike, and I had to replace them.
The compatibility chart said it would work, but to be honest, it wasn't exactly a poncho.
I had to shave the edges of the plastic on the body, shave off the part where the frame meets the plastic, and sweat.
Maybe it's just my TW, but I managed to get it to work.
Performance Quality is fine.
View detail
Required for 4EUEngine Overhaul
[How is it used?
I purchased this product to use for Engine overhaul of TZr50R.
The 4EUEngine Flywheel of TZr50R uses a special screw diameter and requires a special tool for this type of vehicle.
Was the one you received as per Image?
The product was exactly as shown in the Image and comes with the Instruction Manual, so it is ready to use as soon as it arrives.
How was your experience with it?
The quintessential product is a dedicated product and is quite easy to use.
Conversely, this is the only use for this Engine, so in a sense it is too much to handle.
To use the Fly Wheel Puller, attach the Fly Wheel Puller to the screw thread on the Crankshaft on the Flywheel side as shown in the video.
While holding it in place with the MONKEY, turn it. If it becomes very hard in the middle, you can easily loosen it by tapping it lightly with a rubber hammeretc. to give it a vibration. In my case, I pushed it through by force.
[Points to note]
Nothing special, but try not to damage Mt. Screw.
How did it compare to other products?
The competing product is the YAMAHAOEM SST, but the price is not much different, and this one is more economical since it comes with a point.
View detail
Genuine DID 420NZ3 Gold Spare Chain Link
I do not really use these too often as they are basically one step up from a push bike chain anyway. But, it is always good to have them in stock just in case a customer needs one. I found this chain link by just searching through the DID inventory on Webike website. It was really easy to find so you should be just fine. I ordered a few other different chain links along with this as I do like options with spare links. All were shipped together and this saved some shipping cost. My order arrived in 5 days from being shipped. The chain link came in a nice sealed packet with all that is needed to refit. You do get a not seem to get the white grease packet in this size chain but that's ok, I have a lot of these anyway. The chain link is very well made, it also is in the gold colour so nice looking too and it is also embossed with the DID logo so you know it's genuine. Very happy with these small purchases and these will keep me going for future. Thank you Webike. View detail
Fits: YAMAHA RZ50 (New), YAMAHA TZM50, YAMAHA TZR50 R
I bought it because there was no OEM Product.
I purchased this product because OEM Product is not available.
It blows up more energetically than NORMAL! I am satisfied with the feeling of use, but the price is high. The price is high, but it is an old car so it can't be helped.
View detail
I put it on my RG 50Gamma.
It's just like changing a light bulb.
There is no problem
View detail
Plug
I put One set on the back tool box. I bought more than one set because they are one lung or cover. The quality is good! View detail