Reviews
Good Control property
I have used it with other Large type NKs and was satisfied with the Control property braking power durability.
The brake of the Street Triple 765R, which was added to the fleet, was strong but difficult to control, so we decided to try this one first while we were considering replacing it with a radial master.
It is expected that the back plate is thicker than the standard bremboPad, or that the corners are beveled to a Large width.
Control could be improved without feeling a loss of braking power.
It is good enough to put Radial master on hold.
View detail
Fits: BMW F900R, BMW R 1250 R, BMW R1200R, BMW R1250R, BMW S1000 XR, BMW S1000R
Personally, I'd say.
It is smaller than the OEM size, so we do not recommend it to those who do not like it. View detail
Made by Wonderlich, a trusted manufacturer
Made by Wonderlich, which is reliable but expensive.
It would be nice to be able to easily extract power from the back of the Heller Socket.
View detail
It's made by Wonderlich, a company you can trust.
I haven't compared it to Chinese products, but I thought it was a sure bet since it is made by Wonderlich, a trusted name in the industry. View detail
I am satisfied
Even though the overall quality of the S1000RR is high.
Oil Filler Cap is very normal (laughs)
It is also a Recommendation because it can be a One Point.
Gill's even handles OEM parts for BMW.
The accuracy is assured because it is a reliable manufacturer.
Since Coloring is self-fitting,
Taper Direction Notes.
View detail
Fits: BMW S 1000 XR, BMW S 1000 RR, BMW S 1000 R, BMW R nine T all models, BMW R 1200 ST, BMW R 1200 S, BMW R 1200 RT, BMW R 1200 RS, BMW R 1200 R, BMW R 1200 GS Adventure, BMW R 1200 GS, BMW HP4, BMW HP2 Megamoto, BMW HP2 Sport, BMW HP2 Enduro
Cost-effectiveness was excellent.
I was using it on a W800, and it was a little expensive, but I installed it because the W800 is air-cooled and there is a lot of room around the engine.
Used with normal muffler and air cleaner, the response to the opening and closing of the Axel has improved to the point of being laughable. Knocking at low rpm was also eliminated and fuel consumption was improved.
However, the engine became too white, and the balance between the chassis and suspension was not right, so I wondered whether I should proceed with Custom or not, and eventually gave up the W800.
View detail
Safe and reliable DAYTONA products
I used it to replace oil in my S1000RR.
The number of washers required for one oil change is one, so you do not need three washers, but you should save them for the next oil change.
There was no rough workmanship, and it was installed cleanly.
If you are in doubt, choose this one because it is made by DAYTONA, a Large hand.
However, the diameter of the drain bolt differs depending on the vehicle, so be careful to select the right fit when purchasing.
View detail
Hey!
Contact Person!
I thought I sent you an email telling you to Cancel!
View detail
Fits: KTM 1190ADVENTURE, KTM 1090ADVENTURE R, KTM 1090ADVENTURE, KAWASAKI Versys650, KAWASAKI Versys1000 SE, KAWASAKI Versys1000, HONDA VFR800X, KAWASAKI Versys-X250 TOURER, KAWASAKI Versys-X250, HONDA VFR1200X, HONDA NC750X, HONDA NC700X, HONDA CRF1100L Adventure Sports ES, HONDA CRF1100L, HONDA CRF1000L Adventure Sports, HONDA CRF1000L, HONDA 400X, DUCATI MULTISTRADA 1260, DUCATI MULTISTRADA 1200, BMW G310GS
It is Just size
I was able to use it normally with the OEMSIDEPannier installed. View detail
Race ish Grip force
This is AlphaRACING's Grip from BMW's Racing partsBrand, and I installed it on a YZF-R1 (2CR).
AlphaRACING is called AlphaRACING, but Renthal's Logo on the Grip is a hat-drill. (Lol)
The Grip itself is by Renthal, famous for its Off-roadParts, and the Grip seems to be a for-on-road version of that.
I personally think it is good to be able to grip with a small amount of strength.
View detail
Cylinder replacement for C400GT Top case 77439829379
I bought a Top case from another Motorcycle to use on my C400GT so that I could match the pin of the Cylinder to the new key.
I ended up doing it and it was surprisingly easy.
1. Remove the two inner ScrewScrews.
2、It is difficult to work with, so I use a stick? Hinge (where the turn is made) Poke and pull out the iron Pin of the
3, Remove two ScrewScrews from the inside of the removed assembly.
Be careful not to remove the lid too roughly at this time, or you may be surprised when the Spring inside pops out.
4. Then, the entire Cylinder gasket comes off, so it is large and sturdy.
5, How to pull out the Cylinder and how to match it with the new key is the same as Pannier such as R1250GS, so you can find it by searching.
6、When you assemble it at the end, you need to be careful or the lock may not close. You need to make sure that the plastic clasps are properly aligned. (I can't explain it well, but you'll understand if you try.)
View detail
S1000xr
The colour of the seat match my bike colour, if the seat cover have more padding , it will go perfect. It need skill upholstery personnel to do the cover. View detail
Water repellency confirmed
Black is the only color.
HUSQVARNA Just fitSize in Norden 901.
Waterproofness is not known, but it is stated that it is not Completely Waterproof. It is water repellent.
I don't know about durability, but the fabric is thick, so it looks promising.
View detail
Fits: BMW S1000R, BMW S1000RR, KAWASAKI Ninja250, KAWASAKI Ninja400, SUZUKI GSX250R, BMW S1000XR, HONDA CBR1000RR, KAWASAKI ZX-10R, KAWASAKI ZX-25R, SUZUKI GSX-S1000F, SUZUKI GSX-S1000S KATANA, SUZUKI GSX1300GSX1300R HAYABUSA, KAWASAKI Z900RS CAFE, KAWASAKI Z900RS
Maintenance Stand and Dress-up as well.
I purchased this product to use to stand a Maintenance Stand.
We decided to purchase the product because of its affordable price compared to other companies and the fact that it is a trusted Posh.
The design has good parenthesis, and the anodization is beautiful.
The surface of the STAND is scraped off after standing on it several times, but this is not a particular complaint as it is an unavoidable part of the product's characteristics.
I think it is worth buying even for one point dress-up purposes.
View detail
Handlebar Cover is pampered
However, these are Handlebar Gloves, so they are safe.
I was able to install the GIVI Hand Guard ExtensionEH5108 with no problems.
View detail
Fits: BMW S1000XR, HONDA CBR1000RR, KAWASAKI ZX-10R, KAWASAKI ZX-25R, SUZUKI GSX-S1000F, SUZUKI GSX-S1000S KATANA, SUZUKI GSX250R, SUZUKI GSX1300GSX1300R HAYABUSA, BMW S1000R, BMW S1000RR, KAWASAKI Ninja250, KAWASAKI Ninja400, KAWASAKI Z900RS, KAWASAKI Z900RS CAFE
Good sense of unity!
I purchased this for my Roller stand.
The color is the same as the color of the original.
View detail
It is satisfactory enough.
I purchased this product to protect my TFTDisplay when I took delivery of my car. I feel it is a little small, but I am fully satisfied with the quality and performance among many products. I will buy it again when it deteriorates because of its good cost performance. View detail
Oil Filter made by DAYTONA can be used.
I thought the OEM Oil Filter could be removed with this product, but the size is too small to be replaced. Therefore, I think this product can be used only with the OEM Oil Filter.
I am not particular about the texture since it is a filter wrench, but it has a black surface finish, so I don't think it will stand out in a tool box. It also feels better to the touch than just bare steel.
If I can loosen and tighten the Filter properly, there is no problem. The product is perfectly fine as it fulfills its given role. The price is low, so I recommend it to those who do DIY filter replacement.
View detail
LeftBolt portion comes out a little.
[How is it used?
Mounted on rear axle shaft
Was the one you received as per Image?
Street Image
Was the installation difficult?
Easy to use 10mm Socket and tighten from both SIDE.
How was your experience with it?
In case of a fall
[Included Parts:were they on?
Washeretc., can be installed with Included Parts:only
[Was there anything that disappointed you?
None; Left SideBolt portion will show some.
Other items that would be helpful
Availability of Instruction Manual
Yes, but translation (please enter here) is not supported.
View detail
About Top caseBack
I am Large satisfied with the capacity without any problems. View detail