Reviews
Fits: HONDA CB1100, HONDA CB1100EX, HONDA CB1100RS, HONDA CB1300SB, HONDA CB1300SF, HONDA CB1300SP, HONDA CB1300ST, HONDA CB900F HORNET, HONDA CBF1000, HONDA CBR1100XX, HONDA CBR600F, HONDA VTR1000F, HONDA X11, HONDA X4 TypeLD, HONDA X4, YAMAHA YZF-R6
be confused about the color of something
[How is it used?
Sometimes Touring
Was the one you received as per Image?
Yes
How was your experience with it?
Good
[Points to note]
Careful installation
How did it compare to other products?
Good color, other companies are flashy Gold, but SUNSTAR is gentle Champagne gold.
Other items that would be helpful
Installation points and hang/Items to buy together/ Opinions and requests to the Manufacturer
View detail
Useful for cold season commuting
[How is it used?
installed
Was the one you received as per Image?
Grip is Slim and good.
Was the installation difficult?
Left Side Grip is difficult to install. How do we get there?" I struggled with it for about 15 minutes. I hit it with a board and tapped it in with a plastic hammer, but the Motorcycle shop advised me not to do it as much as possible because it could be damaged.
How was your experience with it?
The product Single Body is warm, but it is even more effective if you use Knuckle guard, Cover, or other devices to protect it from the driving wind.
[Included Parts:were they on?
Everything was in place.
[Was there anything that disappointed you?
Sufficient performance is not a problem.
View detail
It was the best Size for W800.
I replaced the previous Type, and the size seems to have changed. I thought it was Large and sturdy.
It was the best size, completely covering the front and rear tiers with the Center Stand hanging down.
Moreover, it was exquisite that the Limit did not stick to the ground.
The fabric seems to follow the fabric from the previous MODEL, so there seems to be no concern about waterproof and durability.
The sealing tape at the seams seems to be firm, but in the past I have handled it roughly and the tape almost peeled off, so I try to handle it carefully, especially when taking it on and off.
Also, the bike is used in a covered parking lot where there are gusty winds, and the side cover has been scratched when the cover flaps.
Nevertheless, Balance's performance and price, which provide long-term protection under the current conditions, are unparalleled in quality.
The lower part of the cover can be adjusted to a very narrow range, and the belt near the center can be securely fastened, so that flapping can be suppressed to some extent.
As described above, the basic functions as a Cover are perfect, and it is made to be less prone to defects.
The black fabric does not stand out, and the color-coded lock holes on the front and back are designed for ease of use and security.
The cover is well made and is useful as a cover with waterproof function, protection, strong fabric, durability, and security effect.
View detail
Required for Northeast Number.
The grip is so thin and natural that you don't even notice it has been replaced. View detail
I am very grateful for this season!
My other car is equipped with a Grip Seater at Standard Equipment, and in the middle of winter, I have been benefiting from it, so I installed it on SecondMotorcycle as well.
As a result, WW could be a little warmer.
I guess the performance is a consideration for Battery capacity, etc., but if I had my wish, I would prefer a little more warmth...
The product looks and feels completely comfortable to hold.
Having said that, I have been able to spend this winter more comfortably than if I had nothing on!
View detail
Fits: KAWASAKI W400, KAWASAKI W650, KAWASAKI W800, YAMAHA virago, YAMAHA XV400, YAMAHA YZF-R1, YAMAHA YZF750SP, YAMAHA XJR1300, YAMAHA XV250, YAMAHA V MAX 1200, YAMAHA XJ600S, YAMAHA XJR1200R, YAMAHA FZR600, YAMAHA FZR750, YAMAHA FZX750, YAMAHA FZR250R, YAMAHA FZR400RR, YAMAHA FJR1300, YAMAHA FZ750, YAMAHA FZR1000
Motorcycle Cover After 3 months of use.
[How is it used?
Used in a parking lot with a carport. Where rain does not hit directly.
Was the one you received as per Image?
Camouflage pattern, as per Image. I prefer this area.
Was the installation difficult?
The size is a little large.
I'm satisfied with it because it just covers me completely.
How was your experience with it?
Use it for 3 months.
(1) Camouflage patterns can be quite recommendation in terms of security since they blend in at night.
A color that can recommendation in terms of security. This was a pleasant miscalculation.
I don't know about the durability of the PelePera fabric, but if it is not exposed to direct rain and can be stored indoors, it seems to be reasonably durable.
At any rate, I've been using it for 3 months with no problems at all. I just think it would not be suitable for places with Blue empty parking. Especially the fabric is so thin that I think the Cover will tear in windy areas.
[Included Parts:were they on?
[Was there anything that disappointed you?
My concern is the Buckle, if it breaks I won't be able to tie the Motorcycle down and it will probably crack over time after a few years. I'll see how it goes.
Other items that would be helpful
Installation points and hang/Availability and clarity of the Instruction Manual/Points to consider/Items to purchase/Opinions and requests to the Manufacturer
View detail
Fits: Others Universal, HONDA CB1300 SUPER FOUR, HONDA CB1300 SUPER BOLDOR, HONDA HAWK11, HONDA CB1100EX, HONDA CB1100RS, HONDA REBEL1100, HONDA CBR1000RR-R FIREBLADE, HONDA CB650R, HONDA CB1000R, HONDA VFR800F, HONDA CBR650R, HONDA CB1000 SUPER FOUR, HONDA CBR900RR, HONDA X11, HONDA VFR, HONDA X4, HONDA CBR1000RR, HONDA CBR600F, HONDA VRX
gargantuan
[How is it used?
I bought this because my 3 year old DAYTONA Motorcycle CoverSIMPLE LLSize (https://www.webike.net/sd/23823142/) had reached its limit. I was going to buy another DAYTONA, but it was late in coming in, I chose this one which was in stock.
Was the one you received as per Image?
It is just as shown in the Image. I think you will receive the same contents no matter which Cover you buy under 5000yen.
How was your experience with it?
I bought a 3L after checking the fit model, but it was too large for my ZX-7R.
[Included Parts:were they on?
Not particularly
[Was there anything that disappointed you?
If it lasts 2 years, I won't say anything. The price is the price. I expect it to be durable against UV rays.
Other items that would be helpful
Installation points and hang/Availability and clarity of the Instruction Manual/Points to consider/Items to purchase/Opinions and requests to the Manufacturer
Motorcycle covers should be inexpensive, but it is a good idea to buy a new one from a well-known manufacturer in 2-3 year cycles. It doesn't matter what you use when you leave it outside.
View detail
Fits: HONDA CB1100R, HONDA STEED600, HONDA MAGNA, HONDA RC30, HONDA VF750C, HONDA VFR750F, HONDA Crossrunner, HONDA VFR800F, HONDA VT250F, HONDA XELVIS, HONDA VT250Z, HONDA V-TWIN MAGNA, HONDA VT250 SPADA, HONDA VFR800X, HONDA CB1100F, HONDA CB1100SF, HONDA CBR1100XX, HONDA X-11, HONDA CTX1300, HONDA ST1300
MORIWAKIOil Filler Cap
One of these costs just under 4,000 yen.
The texture is good, so I'm satisfied.
Recommended for casual One point
View detail
I'm satisfied with the texture.
Full floating in Circuit
SemiFloating is best except for Circuit.
Wave washer- I think it would be better if the waves were just a little bit smaller.
View detail
Simultaneous purchase at the time of Chain replacement
Purchased in conjunction with Chain replacement.
*Buy and replace both front and rear.
It is recommended to replace it with Chain at the same time.
Shift has also changed so much that it is easy to get into and back to the way it was in the new car.
View detail
More than I expected…
I bought it for winter touring because I had some points left over and there was a discount campaign going on.
I can do electrical work and have replaced grips before, so I installed it myself.
Installation was easier than I expected, but it is safer to ask a store to do it if you are worried about the force required to press-fit the grips.
The key heat is effective at Plus temperatures, but not so effective at Minus temperatures. Well, it is better than nothing.
I have a Honda 400X with Honda OEM hand guard, so it is not directly exposed to wind, but even so, the effect starts to diminish from about 3 degrees Celsius.
It is better than nothing, but when I experienced HondaOEM's Grip heater on the 400X I rented from LenBarrel at HondaDREAM before, it was so hot that I could not grip it even at high speed in the morning in the middle of winter, and 2 out of 3 levels was enough.
This product does not get that hot even at max. 5 levels.
It seems that the temperature differs depending on the Manufacturer, and KIJIMA-made products seem to be lower than those of other Manufacturers.
Power is supplied from Honda OEM power supply coupler ACC.
However, the grip is very good, so I will give it an overall rating of 3.
Good points:comfortable grip and easy to install.
Five levels allow for detailed settings depending on the situation.
The bad:Not as hot as expected.
View detail
Good cosmetics, old standby.
[How is it used?
It has been a standard consumable for a long time. I use this Filter every time.
How was your experience with it?
The quality is stable and reliable. I am satisfied with the quality of the product and have had no problems with it.
[Points to note]
Even if you use Filter wrench, you may choose to use Wrench because it is a Type without corners. I have never had a problem because I stick the Driver in and remove it.
How did it compare to other products?
It is comparable to the OEM Product, and I don't think there are any problems. There is no visible difference in performance, but it is a good consumable item for periodic replacement due to its good cost performance.
View detail
FOR CB250F
I am happy to work with the webike team.Actually this item i could not found in my country (Mark, Drive Caution 87560MY1701). Finally I bought it from webike. It is genuine. Very good packaging.fast shipping. Thanks to the webike team. It has not been installed yet.good for the genuine buyers.highly recomended. View detail
Accuracy of holes is not very good.
I bought this for Repair because the Knee Slider part of my CBR900ROEMfootpeg was cracked.
The texture at a quick glance is the same as the OEM Product, but the accuracy of the holes in the footpeg may be poor, and there is a feeling of pinching when inserting the pin.
I couldn't push it in by hand, so I finally tapped it in with a plastic hammer. (OEM Product's Pin and Footpeg are Smooth in this area)
I drove for about an hour after assembly, and there is no particular discomfort.
View detail
Purchased wrong size
I bought the wrong size. I'm thinking of buying it again. View detail
On a 2011 CBR600RR.
I bought it because I didn't want to do thick Gloves in the winter.
The installation was done by Webike's Support store with direct shipping.
In the case of the CBR600RR, I gave up on it myself because it is Large strange to remove the FI side of the Accelerator Wire.
I have used it and it heats up so much that it is hot at the strongest Level.
My wish to use thin Gloves in winter was fulfilled as long as I warmed the back side of my hand from time to time.
There is no possibility of mishandling during Blinker operation.
View detail
I knew this was easy to use.
The fabric is thicker and has some stiffness compared to the Simple made by DAYTONA, which I bought last time, but I prefer this one because it feels more protective.
It is easier to have a belt sewn to the cover to prevent it from being rolled up.
The size is a little bit oversized around the rear, but I think the 3L size is good because it can wrap around the entire motorcycle.
View detail
It's worth the price
I think it is a good product. The only thing that bothers me is that the hole for the lock in the back is hard to find. My concern is that it will deteriorate over time. View detail
Cost performance!
It is a normal oil filter, no oil leakage and comparable to OEM. Cost performance is good. View detail
NGK Iridium Spark Plugs for Honda CBF1000 2006
I was going to go for the standard OEM spark plugs for this service but when I saw the price of the iridium ones for the CBF1000, it was a no brainer to get these bad boys. These were easy to find using the tools provided by Webike and all the links to the manufactyrers websites.The cost was very good and purchased a set of 4.I have used iridium plugs before with great success as they seem to fire better than standard. I used EMS this time and everything arrived within a week. All packaged very well and no damage to anything in the order. Webike added additional bubble wrap for some of the parts to keep everything nice and snug. The plugs themselves are perfect. I have had some plugs befpre from overseas suppliers and generally, one of those had been a dud or just been broken during transit. Not this time. All 100% perfect and fired as they should. They do have a better performance than standard plugs but you would have to be a professional to actually notice the difference of the bat. Once fitted, the bike just feels smoother. Take your time and don't over tighten. One very happy customer. Thanks Webike View detail