Reviews
Inspection supplies that penetrate regardless of Material
[How is it used?
The power supply when installing a USB power supply, etc., and the earth search.
Was the one you received as per Image?
The package is simple and as shown in the Image.
It is unexpected that the tip of the terminal is quite sharp, perhaps to enable inspection by sticking it into the Plain Type Terminal.
Cap is included but was missing when I noticed it and may have been somewhat loose
How was your experience with it?
Although it was not possible to measure any voltage or current, it was possible to check various points with Earth clamped in appropriate places to see where the power source was coming from.
Since Cable is about 80cm, after checking Plus and Minus, we were able to try out the fixation points with pathways and Tie Wrap as it is.
Since it can be purchased for only one coin in terms of price, it is not so regrettable in case the Cable breaks or disconnects when it is bent at a steeper angle than expected by Handlebar, for example.
After installing all the electrical components, it is no longer used for measurement, but it is increasingly used as a tool for drilling holes because of its sharp tip and Gold price, which is not too high even if it is broken.
I've penetrated quite a few polyesters and skins, and the tips still remain sharp enough to be painful to the fingertips.
[Points to note]
The tip is sharp enough to easily pierce paper, thin plastic, cloth, and skin, so it is quite painful when it pierces the hand.
How did it compare to other products?
Compared to most products, the price is much lower due to the fact that the equipment does not measure.
Where can I get power and where can I connect it to use the electrical components? I recommend this product for people like me who think that all they need is to search for the answer. On the other hand, I want to see the values of electricity that I can't see. I want to work while watching. I do not recommend this product to such a person.
View detail
Buy this before you buy the expensive ones.
[How is it used?
I purchased this to check the disconnected part of the Blinker harness.
Was the one you received as per Image?
As per image.
How was your experience with it?
I don't have a Meter or anything like that.
It is easy to use, and it glows red when energized.
In this case, it was just to check the power, so this was sufficient.
[Points to note]
I don't know about voltage and such.
Only check for electrical current.
How did it compare with other products?
It was cheap and I needed it urgently.
View detail
Voltage is not measured.
Used to locate power source
LED in Body emits light when voltage is present
It can be checked with one hand, so it's useful in tight spaces.
View detail
Simple and easy to understand!
This time, I purchased it to check the ACC power supply from the fuse box for the installation of a car's driver's record system. The LED glows red to confirm that power is being supplied. I used it for the first time, but I had no trouble with it by referring to the instructions in the Emon site.
In other people's reviews, it seems that it is often used in Motorcycle electrical tinkering, and I would like to put it in my tool box and use it.
View detail
easy to understand
I purchased this product to replace a Flat Type Fuse Power Supply. The power detection was easy to understand and simple. View detail
Convenient!
Used to look for a power supply! I want a real Tester but a power supply for now.
Perfect for those who want to find it!
View detail
Necessities
It's a necessity to check the energized side. This time, I checked the energized side to get power from Fuse. The energized side is indicated by a red Lamp. Since you can't see the electrical connection, it is useful if you have one of these. I am satisfied with its good cost performance. View detail
Easy to use
The Inspection Tester is very useful for locating a permanent power source.
The LEDs light up for easy and safe use.
View detail
A must have for any electrical DIY!
It's a must have for finding ACC power!
How to use is also simple, and it shines Red when the power supply can be confirmed.
View detail
It is easy to use even for beginners.
This Inspection Tester is very useful to find out the permanent power supply or attachment power supply from the wiring cord of the vehicle. It is useful for USB and DriveRecorder installation. View detail
Durability ×
I used it for continuity testing, but unfortunately, it was not very useful.
The LED that emits a light when the device is switched on is right where it is held in the hand, so it is extremely difficult to see in bright light, let alone in the dark.
Also the durability was no good. I didn't bump into it, but the Minus line that Clip is attached to was broken from the root.
I thought the ordinary Inspection Tester was better.
View detail
High cost performance
When I installed the power supply for the XL1200S, I was wondering where to get the power supply from, so I decided to get the power supply from Fuse.
The Fuse power supply is the same Emon
"Mini Flat Type Fuse Power. https://www.webike.net/sd/22643196/
purchased and ready to go.
It seems that there are Plus and Minus in the Fuse. I pulled out the Fuse and tried to apply the terminals at both ends with tester.
Because it seems that there seems to be Plus and Minus in the Fuse power supply, and the side where Power Cord goes out seems to become Plus, the insertion is completed so that the terminal side Plus and Fuse power supply Plus may not be mistaken.
If you want to check details such as Ampereux, you should buy a proper tester, but if you only want to check whether it is energized or not, this product is sufficient enough performance.
This is more convenient if it's only about whether Plus is either or not etc.
When the LEDs glow, it makes me a little happy when they are energized.
I tried to remove the earth with the Bolt on the Frame, but the paint coating was too thick and it was difficult to remove the earth. I think it is not a problem for ordinary motorcycles, but you should be especially careful for Harley.
However, durability may be a little difficult to achieve because of the price.
If you want to check if the power is on or not, or if you don't use your tester that much but want to keep it in your toolbox, I recommend you to buy another product if you use it hard.
View detail
If only this were possible.
This is a must-have for me when I need to install Navigation, ETC, USB and other electrical components. It's easy to use and the best in the world. View detail
It's useful to have
I use this when I install electrical components It's a simple red LED that glows when it's energized, and I just want to check whether the electricity is coming or not It's useful because it doesn't require batteries and is easy to use View detail
Easy to use
Until now I have been using Tester when playing the electric system of Motorcycle, but it was inconvenient just to check if the electricity is coming.
The product of Emon is Earth is a crocodile mouth, it is very easy to use because it never goes out. Red color Lamp also makes it easy to see that electricity is coming soon.
It is recommended for those who only want to check energization!
View detail
It is convenient to have
Purchase for USB power supply to Motorcycle.
I've been doing something similar up to now, but I think that I did not buy it sooner.
I think that it is inexpensive so I should have one.
View detail
Although the Tester also has, this is enough if it is only a turning-on-electricity check. Since the tip is thin, from a Coupler, without removing a terminal, a crevice can be stabbed and it can check. Since it is easy to lose a Cap at the tip of
Although the Tester also has, this is enough if it is only a turning-on-electricity check.
Since the
tip is thin, from a Coupler, without removing a terminal, a crevice can be stabbed and it can check.
Since it is easy to lose a Cap at the tip of
, I would like to take care.
This is enough although there is also a Type more expensive than this with a Buzzer.
View detail
Since the head is always on already, an Accessories power source is not used for the purpose to say of Meeting, either. It is used for the search for an open-circuit part at the time of the attached electronic autoparts not carrying out a po
Since the head is always on already, an Accessories power source is not used for the purpose to say of
Meeting, either.
It is used for the search for an open-circuit part at the time of the attached electronic autoparts not carrying out a point etc.
In me without an ordinary Tester, it is found useful at the little Check in
outdoors.♪ which is large satisfaction at a Cost performance considering the
price
View detail